H型钢连接方钢管混凝土组合柱简化模拟方法

闫翔宇; 张天柱; 张希; 陈志华; 亢景付

doi:10.13204/j.gyjzG20102702

H型钢连接方钢管混凝土组合柱简化模拟方法

doi: 10.13204/j.gyjzG20102702

闫翔宇^1,2,3,
张天柱²,
张希²,
陈志华^2,3, ,,
亢景付^2,3

1. 天津大学建筑设计规划研究总院有限公司, 天津 300073;
2. 天津大学建筑工程学院, 天津 300072;
3. 天津大学滨海土木工程结构与安全教育部重点实验室(天津大学), 天津 300072

基金项目:

国家重点研发计划（2017YFC0703802）。

详细信息

作者简介:
闫翔宇,男,1980年出生,博士,高级工程师。

通讯作者:
陈志华,男,博士,教授,zhchen@tju.edu.cn。

计量
- 文章访问数: 181
- HTML全文浏览量: 25
- PDF下载量: 18
- 被引次数: 0
出版历程
- 收稿日期: 2020-10-27
- 网络出版日期: 2022-04-24

A Simplified Simulation Method of Concrete-filled Square Steel Tube Composite Column Connected By H-shaped Steel

YAN Xiangyu^1,2,3,
ZHANG Tianzhu²,
ZHANG Xi²,
CHEN Zhihua^{2,3
, ,},
KANG Jingfu^2,3

1. Tianjin University Research Institute of Architectural Design and Urban Planning Co., Ltd., Tianjin 300073, China;
2. School of Civil Engineering, Tianjin University, Tianjin 300072, China;
3. Key Laboratory of Coast Civil Structure and Safety of Ministry of Education (Tianjin University), Tianjin 300072, China

摘要

摘要: 为了简化H型钢连接方钢管混凝土组合柱（SCFT柱）的建模计算过程，建立了三种H型钢连接SCFT柱的有限元分析模型，分别为常用的实体单元模型以及基于轴向刚度和抗弯刚度等效的双梁-单壳单元简化分析模型，结合试验结果，进行了压弯状态下的受力性能分析。基于实体模型和根据刚度等效换算的单梁-单壳单元模型、双梁-单壳单元模型，采用通用分析和设计软件MIDAS建立了典型SCFT柱框架，对比了三种模型在不同荷载下的响应。结果表明：三种模型得到的压弯状态下H型钢连接SCFT柱的破坏模式和承载力基本一致，且与试验结果吻合良好，SCFT框架自振特性、层间位移和柱底反力具有一致性，验证了简化分析计算模型结果的准确性，以及运用于结构分析计算的可行性。
- H型钢连接方钢管混凝土组合柱 /
- 压弯试验 /
- 轴向刚度 /
- 抗弯刚度 /
- 简化模拟方法
Abstract: To facilitate the simulation of concrete-filled square steel tube (SCFT) column connected by H-shaped steel, three types of models were established, including the simplified double-beam single-shell element models (based on the equivalent axial stiffness and bending stiffness) as well as the normal solid element model. The mechanical properties of models under compression and bending were discussed considering test results. On the basis of the solid element model and both the single-beam single-shell element model and double-beam single-shell element model converted by equivalent stiffness, the typical SCFT frame models were established by using the general analysis and design software MIDAS. The responses of these frame models were compared under different load conditions. The results showed that the failure modes and bearing capacity obtained by three models were consistent and in good agreement with the test results, and the natural vibration characteristics, story drift and column bottom reaction of SCFT frame were consistent, indicating the results of the simplified models were accurate and the simplified models of SCFT column based on the equivalent stiffness were proved to be feasible for structural analysis.
- concrete-filled square steel tube composite column connected by H-shaped steel /
- compression-bending experiment /
- axial stiffness /
- bending stiffness /
- simplified simulation method

HTML全文

参考文献(13)

[1]	XIONG Q Q, CHEN Z H, KANG J F, et al. Experimental and finite element study on seismic performance of the LCFST-D columns[J]. Journal of Constructional Steel Research, 2017, 137:119-134.
[2]	胥民扬,陈志华,周婷,等.L形无孔钢板连接式方钢管混凝土组合异形柱长柱轴心受压极限承载力试验研究[J].工业建筑,2016,46(7):178-182 ,117.
[3]	陈志华, 于敬海, 曹爽秋,等. 一种基于高频焊H型钢的方钢管混凝土组合异形柱:107905451A[P]. 2018-04-13.
[4]	RONG B, CHEN Z H, APOSTOLOS F, et al. Axial compression behavior and analytical method of L-shaped column composed of concrete-filled square steel tubes[J]. Transactions of Tianjin University, 2012, 18(3):180-187.
[5]	周婷.方钢管混凝土组合异形柱结构力学性能与工程应用研究[D]. 天津:天津大学,2012.
[6]	蒋宝奇, 周婷, 陈志华,等. L形无孔钢板连接式方钢管混凝土组合异形柱压弯性能简化模拟研究[J].建筑结构,2019,49(6):61-65.
[7]	赵炳震,陈志华,武亚鹏,等.方钢管混凝土组合异形柱建模方法研究[J].建筑钢结构进展,2019,21(4):78-85.
[8]	陈志华,赵炳震,李斌,等.矩形钢管混凝土组合异形柱框架-支撑体系静力弹塑性分析[J].工业建筑,2017,47(6):152-157.
[9]	韩林海,陶忠,刘威. 钢管混凝土结构:理论与实践[M]. 北京:科学出版社,2001.
[10]	XU M Y, ZHOU T, CHEN Z H, et al. Experimental study of slender LCFST columns connected by steel linking plates[J]. Journal of Constructional Steel Research, 2016, 127:231-241.
[11]	XIONG Q Q, CHEN Z H, ZHANG W, et al. Compressive behaviour and design of L-shaped columns fabricated using concrete-filled steel tubes[J]. Engineering Structures, 2017, 152:758-770.
[12]	路晓宇,王新敏. 基于ANSYS的梁-壳单元连接方法研究[J].建筑结构,2017,47(增刊2):561-566.
[13]	王震, 李国强. 一种新型高效的几何非线性梁-柱单元[J].建筑钢结构进展,2018,20(3):26-32.