带竖缝T形装配式剪力墙抗震性能试验研究

吕远贵; 胡龙平; 张相超; 张恒; 李建闯; 余敏; 池寅

doi:10.13204/j.gyjz201908300010

带竖缝T形装配式剪力墙抗震性能试验研究

doi: 10.13204/j.gyjz201908300010

1. 中建三局绿色产业投资有限公司, 武汉 430100;
2. 武汉大学土木建筑工程学院, 武汉 430072

基金项目:

国家重点研发计划项目（2016YFC0701402）。

详细信息

作者简介:
吕远贵,男,1988年出生,硕士,工程师。

通讯作者:
余敏,男,1982年出生,博士,副教授,ceyumin@163.com。

计量
- 文章访问数: 89
- HTML全文浏览量: 3
- PDF下载量: 9
- 被引次数: 0
出版历程
- 收稿日期: 2020-07-16
- 网络出版日期: 2021-09-16
- 刊出日期: 2021-09-16

EXPERIMENTAL STUDY ON SEISMIC PERFORMANCE OF T-SHAPED PREFABRICATED CONCRETE SHEAR WALL CONNECTED WITH A VERTICAL SEAM

1. China Construction Third Bureau Green Industry Investment Co., Ltd., Wuhan 430100, China;
2. School of Civil Engineering, Wuhan University, Wuhan 430072, China

摘要

摘要: 为了减少装配式剪力墙边缘构件现浇的问题，提出了一种带竖向拼缝的新型T形装配式混凝土剪力墙连接方式，即只对上部暗梁连接处进行现浇连接，从而方便施工，提高装配率。为了验证该新型装配式剪力墙的可行性，对装配式和现浇的T形剪力墙进行拟静力试验，重点分析连接处暗梁高度对T形剪力墙的滞回性能、刚度退化、延性以及耗能能力等的影响规律。试验结果表明：带竖缝T形装配式剪力墙的最终整体破坏模式为腹板墙外侧边缘构件底部的混凝土压碎破坏，上部暗梁连接处为局部剪切破坏，构件整体呈现弯曲破坏形态，与现浇构件类似；同时，该T形装配式剪力墙的滞回曲线饱满且呈非对称，表明其具有良好的耗能能力。此外，与相应的现浇剪力墙对比，该T形装配式剪力墙的承载力降低，变形能力和耗能能力差异不大。
- 装配式剪力墙 /
- 抗震性能 /
- 拟静力试验 /
- 竖向接缝
Abstract: A new type of prefabricated concrete shear wall, which is connected by the dark beam with a vertical seam, was proposed to reduce the quantity of cast-in-situ concrete in the edge members of the shear wall, and it also can facilitate the construction and improve the assembly rate. In order to verify the feasibility of the new prefabricated shear wall, quasi-static tests were carried out on the prefabricated and cast-in-situ T-shaped shear walls. The influence of dark beam height on the hysteretic behavior, stiffness degradation, ductility and energy dissipation capacity of T-shaped shear wall was studied. The experimental results showed that the failure modes of T-shaped precast shear walls were bending failures for integral component and shear failures for local joint, and the concrete at the bottom of the shear wall away from the flange side was crushed, which was similar to that of cast-in-situ shear wall; the hysteretic curves of shear walls were asymmetrical and very full, which showed a good energy dissipation capacity; comparing with the cast-in-situ shear walls, the bearing capacity of the prefabricated shear walls was reduced, but there was little difference between the deformation capacity and energy dissipation capacity.
- prefabricated shear wall /
- seismic performance /
- quasi-static test /
- vertical seam

HTML全文

参考文献(22)

[1]	蒋勤俭. 中国建筑产业化发展研究报告[J]. 混凝土世界, 2014(7):10-20.
[2]	陈建伟, 苏幼坡. 预制装配式剪力墙结构及其连接技术[J]. 世界地震工程, 2013, 29(1):38-48.
[3]	兰天晴, 赵少楠, 薛艺鹏, 等. 预制钢筋混凝土剪力墙结构抗震性能研究综述[J]. 土木建筑与环境工程, 2015, 37(增刊2):71-77.
[4]	赵斌, 王庆杨, 吕西林. 采用全装配水平接缝的预制混凝土剪力墙抗震性能研究[J]. 建筑结构学报, 2018, 39(12):48-55.
[5]	钱稼茹, 杨新科, 秦珩, 等. 竖向钢筋采用不同连接方法的预制钢筋混凝土剪力墙抗震性能试验[J]. 建筑结构学报, 2011, 32(6):51-59.
[6]	刘家彬, 陈云钢, 郭正兴, 等. 装配式混凝土剪力墙水平拼缝U型闭合筋连接抗震性能试验研究[J]. 东南大学学报(自然科学版), 2013, 43(3):565-570.
[7]	LU X, WANG D, ZHAO B. Experimental Study on Seismic Performance of Precast Concrete Shear Wall with Joint Connecting Beam Under Cyclic Loadings[A]//Experimental Research in Earthquake Engineering[C]. Cham:Springer, 2015:373-386.
[8]	中华人民共和国住房和城乡建设部.装配式混凝土结构技术规程:JGJ 1-2014[S]. 北京:中国建筑工业出版社, 2014.
[9]	刘亨, 徐其功. 全装配式混凝土墙板结构的竖向接缝研究[J]. 建筑结构, 2018, 48(7):68-72.
[10]	BRUNESI E, NASCIMBENE R. Experimental and Numerical Investigation of the Seismic Response of Precast Wall Connections[J]. Bulletin of Earthquake Engineering, 2017, 15(12):5511-5550.
[11]	张敏. 局部设缝T形与L形截面短肢剪力墙抗震性能试验研究[J]. 世界地震工程, 2014, 30(3):27-38.
[12]	THOMSEN J H, WALLACE J W. Displacement-Based Design of Slender Reinforced Concrete Structural Walls-Experimental Verification[J]. Journal of Structural Engineering, 2004, 130(4):618-630.
[13]	LI W, LI Q N, ZHAO J L. Experimental Study of T-Shaped RC Shear Wall Subjected to Cyclic Loading[J]. Iranian Journal of Science and Technology, Transactions of Civil Engineering, 2018, 42(2):191-198.
[14]	LU X, YANG J. Seismic Behavior of T-Shaped Steel Reinforced Concrete Shear Walls in Tall Buildings Under Cyclic Loading[J]. The Structural Design of Tall and Special Buildings, 2015, 24:141-157.
[15]	陈彬彬, 季静, 谢舜光, 等. T形RC剪力墙抗震变形指标限值试验[J]. 哈尔滨工业大学学报, 2018, 50(6):64-70.
[16]	吕西林, 阳菊华, 蒋欢军. 型钢混凝土T形截面剪力墙抗震性能试验研究[J]. 建筑结构学报, 2014, 35(3):46-52.
[17]	LIU C, NI X, WU H, et al. Calculation Theory and Test Verification for Skeleton Curve of T-Shaped Shear Walls[J]. Structural Engineering International, 2017, 27(2):281-291.
[18]	刘晓楠, 郭正兴, 董年才, 等. 全预制装配剪力墙结构节点性能试验研究[J]. 江苏建筑, 2010(2):21-24.
[19]	刘家彬, 陈云钢, 郭正兴, 等. 竖向新型连接装配式剪力墙抗震性能试验研究[J]. 湖南大学学报(自然科学版), 2014, 41(4):16-24.
[20]	孙建, 邱洪兴, 谭志成, 等. 采用螺栓连接的工字形全装配式RC剪力墙试验研究[J]. 工程力学, 2018, 35(8):172-183.
[21]	中华人民共和国住房和城乡建设部.建筑抗震试验规程:JGJ/T 101-2015[S]. 北京:中国建筑工业出版社, 2015.
[22]	TANG J R. Seismic Resistance of Joints in Reinforced Concrete Frames[M]. Nanjing Southeast University Press, 1989:312-316.