RESEACH ON ULTIMATE BEARING CAPACITY OF REINFORCED FOUNDATION BASED ON TERZAGHI THEORY ON ULTIMATE BEARING CAPACITY OF FOUNDATION

LIU Shuanqi; ZHANG Changjun; ZHANG Wenjuan; TIAN Nan; ZHANG Bin

doi:10.13204/j.gyjzG20072603

Volume 51 Issue 4

Aug. 2021

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2021 > 51(4): 148-153

Lu Hailin, Sun Chengfang, Yue Lin. EXPERIMENTAL RESEARCH ON ULTIMATE BEARING CAPACITY OF STEEL FIBER REINFORCED CONCRETE THICK PILE CAP WITH TWO PILES[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(8): 38-40. doi: 10.13204/j.gyjz200408013

Citation:

LIU Shuanqi, ZHANG Changjun, ZHANG Wenjuan, TIAN Nan, ZHANG Bin. RESEACH ON ULTIMATE BEARING CAPACITY OF REINFORCED FOUNDATION BASED ON TERZAGHI THEORY ON ULTIMATE BEARING CAPACITY OF FOUNDATION[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(4): 148-153. doi: 10.13204/j.gyjzG20072603

Citation:

PDF( 1765 KB)

RESEACH ON ULTIMATE BEARING CAPACITY OF REINFORCED FOUNDATION BASED ON TERZAGHI THEORY ON ULTIMATE BEARING CAPACITY OF FOUNDATION

doi: 10.13204/j.gyjzG20072603

China Jikan Research Institute of Engineering Investigations and Design Co., Ltd., Xi'an 710043, China

Received Date: 2020-07-26
Available Online: 2021-08-19

Abstract

Abstract

In order to study the effect of reinforcement on the bearing capacity of foundation, the limit equilibrium method and slice method were adopted for calculating the ultimate bearing capacity of reinforced foundation in non-cohensive soil based on Terzaghi ultimate bearing capacity theory.The slip blocks of foundation were divided into the active zone, transition zone and passive zone, in which the angle δ₁ between the side of the active zone and horizontal plane was not a fixed value but could meet the minimum prinicple of the bearing capacity of the foundation at failure. The sliding surface of the transition zone assumed to be a logarithmic spiral was divided into many triangular slices in calculation. The reinforcement was equivalent to tensile forces acting on the blocks. Based on the limit equilibrium theory, the force equilibrum formulas on the passive zone, active zone and transition zone were established,which could calculate the angles of δ₁ corresponding to the ultimate bearing capacity of foundation. By optimizing δ₁, the minimum bearing capacity of foundation could be calculated. The effects of the layers of being reinforced, embedment, spacing, length and internal friction angles on the bearing capacity of foundation were also analyzed. By comparison with experimental data, the feasibility of the method was verified.
- ultimate bearing capacity,
- reinforced foundation,
- strip footing

FullText(HTML)

References(13)

References

[1]	VIDAL H. The Principle of Reinforced Earth[J]. Highway Research Record, 1969, 282:1-16.
[2]	BINQUET J, LEE K L. Bearing Capacity Tests on Reinforced Earth Slabs[J]. Journal of Geotechnical Engineering, 1975, 101(12):1241-1255.
[3]	ABU-FARSAKH M, CHEN Q M, SHARMA R. An Experimental Evaluation of the Behavior of Footings on Geosynthetic-Reinforced Sand[J]. Soils and Foundations, 2013, 53(2):335-348.
[4]	柏蕾, 王家全, 周圆兀,等.加筋地基室内大模型试验尺寸效应分析[J].广西科技大学学报, 2019, 30(4):23-29.
[5]	OTANI J, OCHIAI H, YAMAMOTO K. Bearing Capacity Analysis of Reinforced Foundations on Cohesive Soil[J]. Geotextiles and Geomembranes, 1998, 16(4):195-206.
[6]	介玉新, 李广信. 加筋土数值计算的等效附加应力法[J]. 岩土工程学报, 1999, 21(5):614-616.
[7]	刘庆潭, 刘启凤, 华祖焜,等. 用极限平衡法确定加筋土地基的极限承载力[J]. 长沙铁道学院学报, 1997, 15(4):65-73.
[8]	陈蓉, 栾茂田, 郝冬雪,等.加筋地基极限承载力的变分解法[J]. 岩土工程学报, 2010, 32(5):774-779.
[9]	刘拴奇, 卢坤林, 朱大勇, 等. 条形基础加筋砂土地基极限承载力计算[J]. 岩土力学, 2015,36(8):2307-2314.
[10]	栾茂田, 李敬峰, 肖成志.土工格栅加筋挡土墙工作性能的非线性有限元数值分析[J]. 岩石力学与工程学报, 2005, 24(14):2428-2433.
[11]	TERZAGHI K. Theoretical Soil Mechanics[M]. New York:John Wiley and Sons, 1943.
[12]	ZHU D Y. A Method for Locating Critical Slip Surfaces in Slope Stability Analysis[J].Canadian Geotechnical Journal, 2001,38(2):328- 337.
[13]	JU J W. Capacity of Sand Foundation Reinforced by Geonet[C]//Proceedings of International Symposium on Earth Reinforcement. 1996:603-608.

Relative Articles

[1]	MA Hailong, BAO Yanran, MA Yufei, YAO Wenhong. LOAD-TRANSFER LAWS OF A SINGLE PILE AND DETERMINATION OF REASONABLE POSITIONS FOR GROUTING ON PILE SIDES[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(9): 173-176,196. doi: 10.13204/j.gyjzG20091705
[2]	ZHOU Peng, MA Hailong. NUMERICAL ANALYSIS ON LOAD TRANSFER OF TENSILE PILES AND BOTTOM-UPLIFTED PILES[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(3): 147-152. doi: 10.13204/j.gyjzG20040901
[3]	Chi Yuyu Li Junhua Yu Kai Shi Zhe, . STUDY OF FORCE TRANSFER BEHAVIOR FOR SRC MEMBERS WITH STUD SHEAR CONNECTORS UNDER CYCLIC REVERSED LOADING AFTER EXPOSURE TO HIGH TEMPERATURES[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(7): 159-163. doi: 10.13204/j.gyjz201507032
[4]	Wu Huazong, Li Junhua, Chi Yuyu, Qiu Dongliang. EXPERIMENTAL STUDY OF BOND-SLIP BEHAVIOR OF SRC MEMBERS UNDER CYCLIC REVERSED LOADING AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(5): 138-142. doi: 10.13204/j.gyjz201505029
[5]	Hu Xinguo, Zhu Han. EFFECTS OF ADDING BASALT FIBER ON BOND PROPERTIES BETWEEN DEFORMED BAR AND CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(3): 84-87. doi: 10.13204/j.gyjz201303018
[6]	Qiang Xiaojun, Wan Changhong, Jiang Huihuang. ANALYSIS AND COMPARISON OF MODEL TEST REINFORCED EMBANKMENT BY PILE NET WITH PILE CAP[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(5): 75-80. doi: 10.13204/j.gyjz200905016
[7]	Dong Jinrong. INFLUENCE OF PILE BOTTOM SLIME ON SKIN FRICTION AND BEARING CAPACITY ESTIMATION TO PILE[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(4): 93-97. doi: 10.13204/j.gyjz200904021
[8]	Shen Baohan. THE CHARACTERISTICS OF LOAD TRANSFER OF DX PILES[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(5): 5-12. doi: 10.13204/j.gyjz200805002
[9]	Ma Kesheng, Zhang Xiaoju. SETTLEMENT OF SINGLE PILE IN MULTI-LAYERED SOILS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(7): 58-59. doi: 10.13204/j.gyjz200707017
[10]	Zhang Shimin, Yu Feng. LOAD TRANSFER AND BEARING CAPACITY OF PILES JACKED INTO SANDY DEPOSITS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(5): 61-64. doi: 10.13204/j.gyjz200705016
[11]	Wang Gang, Wang Qiongmei. ANALOGICAL RATIO BETWEEN SCALE MODELS WITH LESS BALLAST AND THEIR PROTOTYPES[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(9): 66-68. doi: 10.13204/j.gyjz200709014
[12]	Qi Le, Shi Jian-yong. RESEARCHES ON DISTRIBUTION OF FRICTIONAL RESISTANCE AND EFFECTIVE LENGTH OF FLEXIBLE PILE UNDER RIGID FOUNDATION[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(11): 68-70,84. doi: 10.13204/j.gyjz200711018
[13]	Yang Yong-xin, Yue Qing-rui, Guo Chun-hong, Zhao Yan, Cai Peng. EVALUATION METHOD OF DURABILITY OF FRP[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(8): 6-9. doi: 10.13204/j.gyjz200608002
[14]	Huang Wei, Feng Dingguo. TEST AND RESEARCH ON SLIDING AND SHOCK INSULATION OF LARGE BAY REINFORCED CONCRETE AND BRICK CONSTRUCTION[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(12): 47-50,79. doi: 10.13204/j.gyjz200512014
[15]	Peng Fuming, Yue Qingrui, Hao Jiping, Yang Yongxin. LOAD TRANSFER ANALYSIS OF STEEL STRUCTURES REPAIRED WITH FRP[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(8): 26-30,109. doi: 10.13204/j.gyjz200508006
[16]	Shi Qiyin, Li Aiqun, Li Peibin, Lou Yu, Chen Liu. TESTS ON SHAKING TABLE OF NEW TALL TOWER STRUCTURE MODEL FOR BEIJING AIRPORT[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(9): 40-44,63. doi: 10.13204/j.gyjz200409012
[17]	Wu Mai, Zhao Xin, Dou Yuanming, Wang Enyuan. EXPERIMENTAL STUDY ON STIFFENED DCM PILE IN LABORATORY[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(11): 45-48. doi: 10.13204/j.gyjz200411012
[18]	Yin Zifeng, Jin Xiangwu. ANALYSIS AND TREATMENT OF A LOCAL SLIDING ACCIDENT OF NO.3 RETAINING WALL OF A PROJECT[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(2): 88-90. doi: 10.13204/j.gyjz200402026
[19]	Chen Lun, Wang Haiyan, Shen Baohan, He Dexin, Sun Junping. FULL-SCALE TEST STUDY ON BEARING MECHANISM AND LOAD TRANSMISSION MODE OF DX PILES CAST-IN-SITU[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 5-8. doi: 10.13204/j.gyjz200403002
[20]	Chun Lun, Wang Haiyan, Shen Baohan, He Dexin, Sun Junping. FULL-SCALE TEST STUDY ON UNIT SHAFT RESISTANCE AND UNIT END RESISTANCE OF DX PILES CAST-IN-SITU[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 15-18,39. doi: 10.13204/j.gyjz200403004