ANALYSIS AND DESIGN OF REINFORCED CONCRETE STUB COLUMNS WITH REBAR HRB635 UNDER AXIAL COMPRESSION

CUI Yubo; WANG Jingfeng; SHEN Qihan; DING Zhaodong; LI Zhipeng

doi:10.13204/j.gyjzG20062707

Volume 50 Issue 10

Jan. 2021

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2020 > 50(10): 1-10

Zai Jinmin, Zhou Feng, Mei Guoxiong, Wang Xudong, Pei Jie, Liao Heshan. END-BEARING COMPOSITE PILE FOUNDATION AND ITS DESIGN METHOD[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(1): 60-64,73. doi: 10.13204/j.gyjz200801015

Citation:

CUI Yubo, WANG Jingfeng, SHEN Qihan, DING Zhaodong, LI Zhipeng. ANALYSIS AND DESIGN OF REINFORCED CONCRETE STUB COLUMNS WITH REBAR HRB635 UNDER AXIAL COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(10): 1-10. doi: 10.13204/j.gyjzG20062707

Citation:

PDF( 8653 KB)

ANALYSIS AND DESIGN OF REINFORCED CONCRETE STUB COLUMNS WITH REBAR HRB635 UNDER AXIAL COMPRESSION

doi: 10.13204/j.gyjzG20062707

1. School of Civil and Engineering, Hefei University of Technology, Hefei 230009, China;
2. Anhui Collaborative Innovation Center for Advanced Steel Structure Technology and Industrialization, Hefei 230009, China;
3. Anhui Key Laboratory of Civil Engineering Structures and Materials, Hefei University of Technology, Hefei 230009, China

Received Date: 2020-09-10

Abstract

Abstract

In order to explore the performances and mechanisms of reinforced concrete stub columns with hot-rolled high-strength rebars of 635 MPa under axial compression, a finite element analysis model of reinforced concrete stub columns with hot-rolled rebars under axial compression was modelled, and the accuracy of the model was verified based on the results of the axial compression test. Subsequently, the influences of various parameters such as longitudinal reinforcement ratios, stirrup strength and stirrup volume ratios on its axial compression performances were carried out. The bearing characteristics of stub columns subjected to the axial compression process were revealed and the issue of concrete strength matching with high strength rebars was also discussed. Finally, considering the influence of the stirrup strength, volumetric stirrup ratios and concrete strength, the calculation method for predicting the bearing capacity of reinforced concrete stub columns with hot-rolled ribbed high-strength rebars of 635 MPa subjected to axially compressed loads was proposed based on the results of numerical analysis. The results showed that the failure mode of short reinforced concrete columns with hot-rolled ribbed high-strength rebars of 635 MPa mainly displayed as concrete crushing at the mid-height of the column shafts, and the rebar cages were curved like lanterns; the ultimate axial compression bearing capacity of short columns increased with the increase of concrete strength, longitudinal reinforcement ratios, longitudinal reinforcement strength, stirrup volumetric ratios and stirrup strength; in order to take full use of the strength of hot-rolled ribbed high-strength steel bars of 635 MPa, it was appropriate to match concrete with strength above C50; the proposed calculation formula of ultimate bearing capacity could be used in practical engineering.
- short concrete column,
- hot-rolled ribbed rebar of 635 MPa,
- calculation formula for axial strength,
- finite element analysis,
- axial compressive property

FullText(HTML)

References(15)

References

熊浩, 葛杰, 冯俊, 等. HRB600钢筋的力学性能及其使用性能的试验研究[J].建筑结构学报,2018,39(增刊2):387-393.

中华人民共和国住房和城乡建设部.钢筋混凝土用钢第2部分:热轧带肋钢筋:GB/T 1499.2-2018[S].北京:中国建筑工业出版社, 2018.

中华人民共和国住房和城乡建设部.混凝土结构设计规范:GB 50010-2010[S]. 北京:中国建筑工业出版社, 2010.

刘传正. 配置HRB600级高强钢筋部分预应力混凝土梁抗弯性能研究[D]. 天津:河北工业大学,2014.

张建伟,夏冬瑞,乔崎云,等.HRB600级钢筋高强混凝土柱偏心受压性能试验研究[J].建筑结构学报,2019,40(4):74-80.

戎贤,杜虹茜,张健新.HRB600E钢筋混凝土偏心受压柱受力性能试验研究[J].硅酸盐通报,2019,38(1):60-64.

李义柱,曹双寅,许鹏杰,等. 600 MPa级钢筋混凝土柱抗震性能试验研究[J] 工程力学, 2018, 35(11):181-189.

戎贤, 乔超. 600 MPa级钢筋混凝土十字形柱抗震性能试验研究与恢复力特性分析[J].土木建筑与环境工程, 2018, 40(3):139-146.

EL-HACHA R, EL-AGROUDY H, RIZKALLA S H. Bond Characteristics of High-Strength Steel Reinforcement[J]. ACI Structural Journal, 2013, 103(6):771-782.

王新玲,吴凯鑫,朱俊涛.600 MPa级钢筋与高强混凝土黏结锚固性能试验研究[J].工业建筑,2019,49(7):113-118.

PARK R, PRIESTLEY M J N, GILL W G. Ductility of Square Confined Concrete Columns[J]. Journal of the Structural Division, 1982, 108(4):929-950.

SCOOT B D, PARK R, PRIESTLEY M J N. Stress-Strain Behaviour of Concrete Confined by Overlapping Hoops at Low and High Strain Rates[J]. Journal of American Concrete Institute, 1982, 79(1):13-27.

刘康,洪嵩然. 《混凝土结构设计规范》附录C建议的钢筋和混凝土本构关系模型在结构弹塑性分析中的开发应用[J]. 建筑结构,2012, 42(增刊2):181-185.

金浏,李平,杜修力.考虑尺寸影响的箍筋约束混凝土轴压本构模型[J].土木与环境工程学报(中英文),2020,42(1):81-89.

ESMAEILY-GHASEMABADI A, XIAO Y. Seismic Behavior of Bridge Columns Subjected to Varous Loading Patterns[R]. Berkeley:University of California, 2002.

Relative Articles

[1]	ZHOU Zhijun, TIAN Yeqing, ZHANG Mingyi, WANG Kangchao, ZHU Shanshan. Analysis on Bearing Characteristics of Pile Groups with Post-Grouting at Pile Ends in Loess Areas[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(3): 182-190. doi: 10.3724/j.gyjzG22090209
[2]	ZHOU Xuhong, LUO Yintao, WANG Wenling, WANG Yuhang, LU Yao. Optimizational Analysis on Structural Parameters and Study on Practical Deformation Analysis Methods for High-Rise Pile Cap Foundations of Offshore Wind Turbines[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(6): 1-12. doi: 10.13204/j.gyjzG23022210
[3]	LI Zhenling, QIN Siyuan. Study on Horizontal Load-Bearing and Deformation Performances of Monopile Foundations for Offshore Wind Turbines Based on In-Situ Static Load Tests[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(6): 13-18. doi: 10.13204/j.gyjzG22122304
[4]	LI Shu'an, ZHANG Junhua, TIAN Shizhen, WU Jianqun, CHANG Jingcheng, WANG Yukui. RESEARCH ON BEARING CHARACTERISTICS OF GROUP PILE FOUNDATIONS CONSIDERING PILE-SOIL-CAP INTERACTION IN STRATIFIED SOIL[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(8): 65-71. doi: 10.13204/j.gyjzG201908210002
[6]	Fan Xianming, Ren Qing, Gao Zhanshi. COUPLED HORIZONTAL AND ROCKING VIBRATION OF LARGE-DIAMETER END-BEARING PILE IN LAYERED SOIL[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(10): 96-102. doi: 10.13204/j.gyjz201410020
[7]	Zhang Min, Ma Jianlin, Chai Rui, Wu Weisheng. STUDY OF INFLUENCE OF SHEAR RING ON FORCE AND DEFORMATION PROPERTIES OF STEEL TUBULAR COMPOSITE PILE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(11): 67-72,88. doi: 10.13204/j.gyjz201311016
[8]	Hu Lifeng, Zhang Zhao, Gong Weiming, Xu Guoping, Guo Chao. MODEL TEST ON BEARING CAPACITY OF COMPOSITE PILE FOUNDATION IN TOP-DOWN ORDER[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(11): 76-80. doi: 10.13204/j.gyjz200911018
[9]	Xu Biao, Wang Qi-zhi. DEFORMATION PROPERTY OF PILE GROUP COMPOSITE FOUNDATION IN LAYERED SOIL SUBJECTED TO A HORIZONTAL LOAD[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(12): 88-92. doi: 10.13204/j.gyjz200712021
[10]	Zhao Honghua, Han Xuanjiang. DEFORMATION STUDY ON COMPOSITE FOUNDATION WITH CEMENT MIXING PILES[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(6): 63-65. doi: 10.13204/j.gyjz200706016
[11]	Duan Yonghui, Xiao Zhaoran, Zhang Zhao. RESEARCH AND COMPARATION OF MECHANICAL BEHAVIORS OF COMPOSITE FOUNDATION WITH RIGID PILES AND THE ONE WITH FLEXIBLE PILES BY 3-D FEM[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(2): 54-56. doi: 10.13204/j.gyjz200602016
[12]	Liu Zhigang, Wang Qizhi, Peng Shengen. DEFORMATION BEHAVIOR OF COMPOSITE FOUNDATION UNDER HORIZONTAL LOADING[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(2): 60-63. doi: 10.13204/j.gyjz200502017
[13]	Zai Jinmin, Wang Xudong, Yu Chuang. RESEARCH ON THE SOIL ADDITIONAL STRESS AND SIMPLIFIED SETTLEMENT CALCULATION OF COMPOSITE PILE FOUNDATION[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(5): 24-27. doi: 10.13204/j.gyjz200505006