RESEARCH OF UNLOADING RATES OF CONFINING PRESSURE UNDER PORE WATER PRESSURE CYCLES ON MECHANICAL PROPERTIES OF SANDSTONE

GUO Yongcheng; CHEN Zuogui

doi:10.13204/j.gyjz202006015

Volume 50 Issue 6

Aug. 2020

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2020 > 50(6): 93-97,174

Zhang Tiejun, Yan Yuelan. STUDY ON LOCALIZATION OF MANUFACTURE OF UNDERRELAXATION PRESTRESSED STEEL SHANDS FOR CONTAINMENT OF Ling'ao NUCLEAR POWER PLANT (PHASE-Ⅱ) AND ITS USE[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(4): 61-66. doi: 10.13204/j.gyjz200904015

Citation:

GUO Yongcheng, CHEN Zuogui. RESEARCH OF UNLOADING RATES OF CONFINING PRESSURE UNDER PORE WATER PRESSURE CYCLES ON MECHANICAL PROPERTIES OF SANDSTONE[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(6): 93-97,174. doi: 10.13204/j.gyjz202006015

Citation:

PDF( 1946 KB)

RESEARCH OF UNLOADING RATES OF CONFINING PRESSURE UNDER PORE WATER PRESSURE CYCLES ON MECHANICAL PROPERTIES OF SANDSTONE

doi: 10.13204/j.gyjz202006015

GUO Yongcheng^1,2,3,
CHEN Zuogui^{3
,
,}

1. Key Laboratory of Geological Hazards on Three Gorges Reservoir Area, Ministry of Education, China Three Gorges University, Yichang 443002, China;
2. Hubei Key Laboratory of Disaster Prevention and Mitigation, China Three Gorges University, Yichang 443002, China;
3. College of Civil Engineering and Architecture, China Three Gorges University, Yichang 443002, China

Received Date: 2019-09-13
Publish Date: 2020-08-20

Abstract

Abstract

Considering the actual excavation conditions of the water-level fluctuation zone in the Three Gorges reservoir area, the effects of different pore water pressure cycles and unloading rates of confining pressure on the mechanical properties of sandstone were studied by the indoor triaxial unloading experiment. The results were as follows:1) the effect of the pore water pressure cycles and unloading rates of confining pressure on peak intensity of deviator stress and deformation modulus of sandstone was significant. The more the cycles, the smaller the peak intensity and deformation modulus; the faster the unloading rates, the larger the peak intensity and deformation modulus; 2) when destroyed, axial and circumferential rates of strain variations or peak confining pressure all increased with the increase of pore water pressure cycles and decreased with the increase of unloading rates of confining pressure, however, the impact on the circumferential was more obvious than the axial; 3)the rupture angles of the sandstone under 0.3 MPa pore water pressure were not relevant to the unloading rates of pore water pressure.
- confining pressure,
- unloading rate,
- pore water pressure cycle,
- sandstone,
- strength deterioration

FullText(HTML)

References(12)

References

XU H, FENG X T, YANG C X, et al. Influence of Initial Stresses and Unloading Rates on the Deformation and Failure Mechanism of Jinping Marble Under True Triaxial Compression[J]. International Journal of Rock Mechanics and Mining Sciences,2019,117:90-104.

LI X B, WENG Z H, LEI C, et al. Unloading Responses of Pre-flawed Rock Specimens Under Different Unloading Rats[J]. Transactions of Nonferrous Metals Society of China,2019,29(7):1516-1526.

王兴霞,黄建文,黄曼丽.卸荷条件下砂岩变形模量弱化规律[J].人民黄河,2015,37(6):131-134.

黄润秋,黄达.高地应力条件下卸荷速率对锦屏大理岩力学特性影响规律试验研究[J].岩石力学与工程学报,2010,29(1):21-33.

邓媛,邹荣华,彭刚,等.孔隙水压循环次数对混凝土损伤影响[J].水利水运工程学报,2016(6):83-89.

邱士利,冯夏庭,张传庆.不同卸围压速率下深埋大理岩卸荷力学特性试验研究[J].岩石力学与工程学报,2010,29(9):1807-1817.

邓华锋,王哲,李建林,等.卸荷速率和孔隙水压力对砂岩卸荷特性影响研究[J].岩土工程学报,2017,39(11):1976-1983.

邓华锋,李建林,朱敏.饱水-风干循环作用下砂岩强度劣化规律试验研究[J].岩土力学,2012,33(11):3306-3312.

刘泽峰,乔雨,李飞.卸荷速率对含水砂岩卸荷力学特性的影响[J].水电能源科学, 2016,34(7):120-123

,137.

郭永成,胡鹏,王克辉,等.水压循环作用对砂岩卸荷破坏试验研究[J].水力发电,2019,45(11):23-27.

傅晏,刘新荣,张永兴.水岩相互作用对砂岩单轴强度的影响研究[J].水文地质工程地质,2009,36(6):54-58.

郭慧敏.饱水-风干循环作用下砂岩力学性质劣化规律研究[J].长江科学院院报,2020,255(1):90-94.

Relative Articles

[1]	ZHOU Zhijun, TIAN Yeqing, ZHANG Mingyi, WANG Kangchao, ZHU Shanshan. Analysis on Bearing Characteristics of Pile Groups with Post-Grouting at Pile Ends in Loess Areas[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(3): 182-190. doi: 10.3724/j.gyjzG22090209
[2]	ZHOU Peng, MA Hailong. NUMERICAL ANALYSIS ON LOAD TRANSFER OF TENSILE PILES AND BOTTOM-UPLIFTED PILES[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(3): 147-152. doi: 10.13204/j.gyjzG20040901
[3]	MA Hailong, BAO Yanran, MA Yufei, YAO Wenhong. LOAD-TRANSFER LAWS OF A SINGLE PILE AND DETERMINATION OF REASONABLE POSITIONS FOR GROUTING ON PILE SIDES[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(9): 173-176,196. doi: 10.13204/j.gyjzG20091705
[4]	Chen Lanyun, Shu Zhong, Yi Nangai. NUMERICAL SIMULATION OF VERTICAL BEARING CAPACITY OF POST-GROUTING BORED PILES[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(7): 78-81. doi: 10.13204/j.gyjz201107018
[5]	Qiang Xiaojun, Wan Changhong, Jiang Huihuang. ANALYSIS AND COMPARISON OF MODEL TEST REINFORCED EMBANKMENT BY PILE NET WITH PILE CAP[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(5): 75-80. doi: 10.13204/j.gyjz200905016
[6]	Shen Baohan, Wang Haiyan, Liu Zhenliang, He Dexin. TEST STUDY OF DX PILE WITH FOUR BULBS AT XI'AN SXD PROJECT[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(2): 1-7. doi: 10.13204/j.gyjz200902001
[7]	Shen Baohan. DX PILE AND ITS SEVERAL PROBLEMS OF VERTICAL BEARING CAPACITIES[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(8): 84-95. doi: 10.13204/j.gyjz200908022
[8]	Dong Jinrong. INFLUENCE OF PILE BOTTOM SLIME ON SKIN FRICTION AND BEARING CAPACITY ESTIMATION TO PILE[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(4): 93-97. doi: 10.13204/j.gyjz200904021
[9]	Yi Yaolin, Liu Songyu. NUMERICAL ANALYSIS OF BEHAVIOR OF T-SHAPED CEMENT-SOIL DEEP MIXING PILE COMPOSITE FOUNDATION UNDER EMBANKMENT LOADS[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(11): 63-68. doi: 10.13204/j.gyjz200811016
[10]	Shen Baohan, Sun Junping, Wang Yan. THE CALCULATION OF VERTICAL COMPRESSIONAL BEARING CAPACITY OF DX PILE[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(5): 18-22. doi: 10.13204/j.gyjz200805004
[11]	Shen Baohan. THE CHARACTERISTICS OF LOAD TRANSFER OF DX PILES[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(5): 5-12. doi: 10.13204/j.gyjz200805002
[12]	Luo Chunbo, Zhu Xiangrong, Kong Qinghua, Sun Jinyue. PILE-SOIL INTERACTION ANALYSIS OF O-CELL TESTING PILE BASED ON ELASTIC THEORY[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(8): 60-63. doi: 10.13204/j.gyjz200708016
[13]	Zhang Shimin, Yu Feng. LOAD TRANSFER AND BEARING CAPACITY OF PILES JACKED INTO SANDY DEPOSITS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(5): 61-64. doi: 10.13204/j.gyjz200705016
[14]	Peng Fuming, Yue Qingrui, Hao Jiping, Yang Yongxin. LOAD TRANSFER ANALYSIS OF STEEL STRUCTURES REPAIRED WITH FRP[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(8): 26-30,109. doi: 10.13204/j.gyjz200508006
[15]	Pei Jie, Shui Weihou, Cao Hui. NEW MODEL OF LONG PILE LOAD TRANSFER FOR SOFT FOUNDATION IN SHANGHAI[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(7): 50-54,49. doi: 10.13204/j.gyjz200507015
[16]	Li Haiwang, Ju Yuwen, Zhao Mingwei, Liang Renwang. ANALYSIS AND FIELD STATIC LOADING TESTS OF CAST-IN-PLACE PILES WITH BRANCHES AND PLATES[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 21-23. doi: 10.13204/j.gyjz200403006
[17]	Wu Xiongzhi, An Xinzheng, Wu Ruizhi. STUDY ON BEARING MECHANISM OF SOIL-CEMENT PILE[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(6): 42-43,41. doi: 10.13204/j.gyjz200406014
[18]	Chun Lun, Wang Haiyan, Shen Baohan, He Dexin, Sun Junping. FULL-SCALE TEST STUDY ON UNIT SHAFT RESISTANCE AND UNIT END RESISTANCE OF DX PILES CAST-IN-SITU[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 15-18,39. doi: 10.13204/j.gyjz200403004
[19]	Chen Lun, Wang Haiyan, Shen Baohan, He Dexin, Sun Junping. FULL-SCALE TEST STUDY ON BEARING MECHANISM AND LOAD TRANSMISSION MODE OF DX PILES CAST-IN-SITU[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 5-8. doi: 10.13204/j.gyjz200403002