EXPERIMENTAL STUDY OF EARTHQUAKE-DAMAGED RC FRAME COLUMNS STRENGTHENED WITH SPRAYED HYBRID BF-CFRP

Gu Qian; Li Bo; Bitewlgn M． Getahune; Peng Yujia

doi:10.13204/j.gyjz201508034

Volume 45 Issue 8

Nov. 2015

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2015 > 45(8): 185-191

Xing Guoqi, Wang Xiaoli. PULL-OUT EXPERIMENTAL STUDY ON NEW TYPE OF CHEMICAL ANCHORING BOLTS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(2): 66-69. doi: 10.13204/j.gyjz201102017

Citation:

Gu Qian, Li Bo, Bitewlgn M． Getahune, Peng Yujia. EXPERIMENTAL STUDY OF EARTHQUAKE-DAMAGED RC FRAME COLUMNS STRENGTHENED WITH SPRAYED HYBRID BF-CFRP[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(8): 185-191. doi: 10.13204/j.gyjz201508034

Xing Guoqi, Wang Xiaoli. PULL-OUT EXPERIMENTAL STUDY ON NEW TYPE OF CHEMICAL ANCHORING BOLTS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(2): 66-69. doi: 10.13204/j.gyjz201102017

Citation:

PDF( 0 KB)

EXPERIMENTAL STUDY OF EARTHQUAKE-DAMAGED RC FRAME COLUMNS STRENGTHENED WITH SPRAYED HYBRID BF-CFRP

doi: 10.13204/j.gyjz201508034

Publish Date: 2015-08-20

Abstract

Abstract

An experimental investigation on the seismic behavior of earthquake-damaged RC frame columns strengthened with sprayed hybrid basalt and carbon fiber reinforced polymer ( BF-CFRP) was presented． Three specimens with 1 /2 scale were tested by horizontal cyclic loading combined with constant gravity loads． The test results indicated that after spraying repair the ultimate bearing capacity of the damaged frame column yielded steel bars was nearly restored to the level before its damage，the ductility coefficient and the cumulative energy dissipation were respectively increased by 7. 43% and 22%，and the stiffness degeneration rate beyond peak load was lower than that of unrepaired column; the peak load and the cumulative energy dissipation of the damaged frame column were respectively decreased by 11. 9% and 39% after spraying repair，the ductility coefficient was increased a little，and the initial stiffness was much lower than the other two specimens because of serious pre-damage，but the stiffness degeneration rate was almost the same as the other two due to the effective confinement action of sprayed FRP coatings． That is to say，the seismic behavior of earthquake-damaged frame column can be rehabilitated even enhanced through spraying hybrid BF － CFRP，which demonstrates that this method can quickly repair earthquakedamaged frame columns and effectively hinder the collapse of RC frame structures in aftershock．
- sprayed fiber reinforced polymer ( FRP),
- hybrid basalt-carbon fibers,
- seismic strengthening,
- RC frame column,
- earthquake-damaged

FullText(HTML)

References(0)

References

Relative Articles

[1]	FANG Wei, ZHOU Peng, WANG Jiao, SHEN Hongyu. Study of Pullout Tests on Plastic Geogrids with Vertical Stiffener Ribs of Aluminum Angles[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(5): 205-211. doi: 10.3724/j.gyjzG22092708
[2]	WANG Jiaquan, WANG Menglian, TANG Yi, QI Hangxiang. Pullout Tests and Analysis of Reinforced Soil Interfaces at High, Medium and Low Pullout Rates[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(4): 142-148. doi: 10.3724/j.gyjzG22091601
[3]	ZHU Hongbing, ZHANG Na, YU Zhiwu, JIANG Lizhong, XU Wenkang. Bonding Mechanical Properties Between Ceramsite Concrete with Hybrid Fibers of Steel and Polypropylene and Threaded Rebars[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(2): 32-36,114. doi: 10.13204/j.gyjzG21071801
[4]	HUANG Jian, FANG Wei, SHI Lijun, JIANG Yougen, CHEN Guang. Numerical Simulations of Pullout Characteristics and a Calculation Method for Ultimate Pullout Resistance of Denti-Geogrids[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(8): 187-193,110. doi: 10.13204/j.gyjzG21060212
[5]	LIU Xue-chun, MENG Kun. Research on Tensile Bearing Capacity of Joints of Concrete-Filled Square Steel Tubular Columns with Built-in Hooks and Bending Plates[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(9): 138-146. doi: 10.13204/j.gyjzg21072201
[6]	MA Hongwei, WEI Zengting, LIU Weiya. PULL-OUT TEST AND FINITE ELEMENT ANALYSIS OF ANCHORAGE-EMBEDDED PARTS[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(11): 81-89. doi: 10.13204/j.gyjzG20110403
[7]	LIU Xuechun, QIANG Shen, DENG Yuping, GAO Jiawei, CUI Fuyuan. EXPERIMENTAL RESEARCH ON BEARING CAPACITY OF PREFABRICATED INVISIBLE BEAMS AND FLOORS AT THE CONSTRUCTION STAGE[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(5): 36-43. doi: 10.13204/j.gyjz202005007
[9]	Zheng Yuzhou, Yang Xing, Wang Wenwei, Zhang Yongkang. BOND BEHAVIOR TEST AND BOND-SLIP CONSTITUTIVE RELATION BETWEEN FRP REBAＲS AND CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(6): 1-6. doi: 10.13204/j.gyjz201506001
[10]	Long Zhiqin, Mu Jianchun, Wang Zhigang, Xi Huifeng. EXPERIMENTAL RESEARCH ON THE DRAWING BEHAVIOR OF EMBEDDED STEEL L-BAR IN REINFORCED CONCETE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(1): 91-94. doi: 10.13204/j.gyjz201501017
[11]	Liu Ze, Lei Yong. TEST STUDY ON THE INTERFACE FRICTION CHARACTERISTICS OF COAL GANGUE-GEOGRID-SAND LAYERED SYSTEM[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(04): 90-93.
[12]	Hu Xinguo, Zhu Han. EFFECTS OF ADDING BASALT FIBER ON BOND PROPERTIES BETWEEN DEFORMED BAR AND CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(3): 84-87. doi: 10.13204/j.gyjz201303018
[13]	Wang Bo, Bai Guoliang, Wu Shuhai, Feng Xiangdong, Li Jian. STUDY ON ULTIMATE BOND STRENGTH AND ANCHORAGE LENGTH OF THE REBAR IN THE RECYCLED AGGREGATE CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(8): 59-63,38. doi: 10.13204/j.gyjz201308013
[14]	Wang Bo, Bai Guoliang, Li Jian, Wu Shuhai, Liu Chao. EXPERIMENTAL AND THEORETICAL ANALYSIS OF BOND STRESS DISTRIBUTION BETWEEN THE REBAR AND THE RECYCLED CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(4): 10-14. doi: 10.13204/j.gyjz201204003
[15]	Yang Guolin, Liu Ze, Huang Xiangjing. STUDY ON THE INTERFACE RELATIONSHIP BETWEEN WIRE MESH AND SOIL BASED ON POWER FUNCTION MODEL[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(6): 97-101,114. doi: 10.13204/j.gyjz201106021
[16]	Xie Biaoyun, Yang Yong, Zhou Pijian, Cai Junwei. EXPERIMENT STUDY ON BOND STRENGTH BETWEEN CONCRETE AND NEAR SURFACE MOUNTED (NSM) CFRP RODS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(8): 103-106,81. doi: 10.13204/j.gyjz201008024
[17]	Zhang Peng, Zhang Shengli, Huang Liuyun, Deng Langni. PULL-OUT TEST AND ANALYSIS OF PRESSURE-TYPE ANCHOR OF CFRP TENOON[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(10): 98-102. doi: 10.13204/j.gyjz201010022
[18]	Liu Zhongyu, Shang Yalong, Yan Fuyou, Zhang Qingwei, Ma Chongwu. EXPERIMENTAL STUDY ON BOND PROPERTIES OF GFRP BARS TO CEMENT MORTAR[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(6): 71-73,78. doi: 10.13204/j.gyjz200806019
[19]	Liu Yi, Mei Guoxiong, Song Linhui, Zai Jinmin. EXPERIMENTAL STUDY OF A NEW TYPE UMBRELLA-SHAPED ANTI-FLOAT ANCHOR[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(10): 71-75. doi: 10.13204/j.gyjz20081018