EXPERIMENTAL RESEARCH ON THE DRAWING BEHAVIOR OF EMBEDDED STEEL L-BAR IN REINFORCED CONCETE

Long Zhiqin; Mu Jianchun; Wang Zhigang; Xi Huifeng

doi:10.13204/j.gyjz201501017

Volume 45 Issue 1

Mar. 2015

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2015 > 45(1): 91-94

Long Zhiqin, Mu Jianchun, Wang Zhigang, Xi Huifeng. EXPERIMENTAL RESEARCH ON THE DRAWING BEHAVIOR OF EMBEDDED STEEL L-BAR IN REINFORCED CONCETE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(1): 91-94. doi: 10.13204/j.gyjz201501017

Citation:

Long Zhiqin, Mu Jianchun, Wang Zhigang, Xi Huifeng. EXPERIMENTAL RESEARCH ON THE DRAWING BEHAVIOR OF EMBEDDED STEEL L-BAR IN REINFORCED CONCETE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(1): 91-94. doi: 10.13204/j.gyjz201501017

Citation:

PDF( 0 KB)

EXPERIMENTAL RESEARCH ON THE DRAWING BEHAVIOR OF EMBEDDED STEEL L-BAR IN REINFORCED CONCETE

doi: 10.13204/j.gyjz201501017

Publish Date: 2015-01-20

Abstract

Abstract

The experiment of embedded steel L-bar in reinforced concrete under tensile load was carried out. The first important factor was the section steel model of the reinforcing L-bar，next was the depth of the embedded steel L-bar， and the third was the strength of the concrete. Through observing the failure process of the specimens，the failure model，the bond mechanism and the distribution of shear stress were discussed. The maximum value of binding shear stress appeared when the steel L-bar entered into the state of yielding.
- embedded steel L-bar,
- drawing test,
- destroy form

FullText(HTML)

References(0)

References

Relative Articles

[1]	FANG Wei, ZHOU Peng, WANG Jiao, SHEN Hongyu. Study of Pullout Tests on Plastic Geogrids with Vertical Stiffener Ribs of Aluminum Angles[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(5): 205-211. doi: 10.3724/j.gyjzG22092708
[2]	WANG Jiaquan, WANG Menglian, TANG Yi, QI Hangxiang. Pullout Tests and Analysis of Reinforced Soil Interfaces at High, Medium and Low Pullout Rates[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(4): 142-148. doi: 10.3724/j.gyjzG22091601
[3]	LIN Wenluo, LI Junhua, TAN Jie. Experimental Research on Shear Performance of Stainless Steel Connectors in a New Type of Prefabricated Concrete Sandwich Insulation Wall Panels[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(4): 64-71. doi: 10.13204/j.gyjzG23050606
[4]	YUAN Zhishen, YIN Siguang, YAO Yao, TANG Xiang, YUAN Jian, LUO Xuewen. Experimental Research on Hysteretic Behavior of High-Strength Steel CHS T-Joints Under Axial Loads[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(5): 170-178. doi: 10.3724/j.gyjzG23111510
[5]	DING Zushan, HUO Fuguang, GAO Shengda, LU Limin, QU Luyang. Service State Inspection and Failure Mode Analysis of Old Welded Towers[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(1): 233-239. doi: 10.13204/j.gyjzG22102605
[6]	HUANG Jian, FANG Wei, SHI Lijun, JIANG Yougen, CHEN Guang. Numerical Simulations of Pullout Characteristics and a Calculation Method for Ultimate Pullout Resistance of Denti-Geogrids[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(8): 187-193,110. doi: 10.13204/j.gyjzG21060212
[7]	ZHU Hongbing, ZHANG Na, YU Zhiwu, JIANG Lizhong, XU Wenkang. Bonding Mechanical Properties Between Ceramsite Concrete with Hybrid Fibers of Steel and Polypropylene and Threaded Rebars[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(2): 32-36,114. doi: 10.13204/j.gyjzG21071801
[8]	Zheng Yuzhou, Yang Xing, Wang Wenwei, Zhang Yongkang. BOND BEHAVIOR TEST AND BOND-SLIP CONSTITUTIVE RELATION BETWEEN FRP REBAＲS AND CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(6): 1-6. doi: 10.13204/j.gyjz201506001
[9]	Liu Ze, Lei Yong. TEST STUDY ON THE INTERFACE FRICTION CHARACTERISTICS OF COAL GANGUE-GEOGRID-SAND LAYERED SYSTEM[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(04): 90-93.
[10]	Huang Wei, Chen Junying, Liu Jieyu, Zhang Chenghua. STUDY ON FAILURE MODES OF FUNDAMENTAL ELEMENT OF ECOLOGICAL COMPOSITE WALL[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(03): 68-73. doi: 10.13204/j.gyjz201403016
[11]	Wang Bo, Bai Guoliang, Li Jian, Wu Shuhai, Liu Chao. EXPERIMENTAL AND THEORETICAL ANALYSIS OF BOND STRESS DISTRIBUTION BETWEEN THE REBAR AND THE RECYCLED CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(4): 10-14. doi: 10.13204/j.gyjz201204003
[12]	Guo Gang, Liu Zhong, Yang Song, Zhang Yi, Lu Jingchun. MODEL TEST RESEARCH ON FAILURE MODES OF DIFFERENT EMBEDDED DEPTH UNDERREAMED GROUND ANCHOR UNDER VERTICAL PULLOUT[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(1): 123-127,122. doi: 10.13204/j.gyjz201201023
[13]	Xing Guoqi, Wang Xiaoli. PULL-OUT EXPERIMENTAL STUDY ON NEW TYPE OF CHEMICAL ANCHORING BOLTS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(2): 66-69. doi: 10.13204/j.gyjz201102017
[14]	Xie Biaoyun, Yang Yong, Zhou Pijian, Cai Junwei. EXPERIMENT STUDY ON BOND STRENGTH BETWEEN CONCRETE AND NEAR SURFACE MOUNTED (NSM) CFRP RODS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(8): 103-106,81. doi: 10.13204/j.gyjz201008024
[15]	Zhang Peng, Zhang Shengli, Huang Liuyun, Deng Langni. PULL-OUT TEST AND ANALYSIS OF PRESSURE-TYPE ANCHOR OF CFRP TENOON[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(10): 98-102. doi: 10.13204/j.gyjz201010022
[16]	Liu Zhongyu, Shang Yalong, Yan Fuyou, Zhang Qingwei, Ma Chongwu. EXPERIMENTAL STUDY ON BOND PROPERTIES OF GFRP BARS TO CEMENT MORTAR[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(6): 71-73,78. doi: 10.13204/j.gyjz200806019
[17]	Liu Yi, Mei Guoxiong, Song Linhui, Zai Jinmin. EXPERIMENTAL STUDY OF A NEW TYPE UMBRELLA-SHAPED ANTI-FLOAT ANCHOR[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(10): 71-75. doi: 10.13204/j.gyjz20081018
[18]	Zhou Lincong, Chen Longzhu, Chen Xiaobao. SIMPLE JUDGEMENT OF FAILURE MODE AND SAFE STATE OF COUPLING BEAMS[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(3): 38-40. doi: 10.13204/j.gyjz200603010
[19]	Yi Weijian, Zhao Xin. DAMAGE PATTERN OF COLUMNS WITH CORRODED STEEL BARS IN THE COMPRESSIVE ZONE OF CONCRETE SECTION AND THE DIFFICULT IDENTIFICATION OF CORROSION WITH HALF-CELL TECHNIQUE[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(12): 23-26,90. doi: 10.13204/j.gyjz200512007
[20]	Wang Haizhong, Zhao Tianyu. STRUCTURAL DESIGN AND MODES OF FAILURE ANALYSIS OF SANDWICH PANELS[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(8): 97-99,120. doi: 10.13204/j.gyjz200508024