EXPERIMENTAL STUDY ON RESTORING FORCE MODEL OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS

Xue Jianyang; Liu Jinlu; Ma Hui; Liu Yi; Liu Zuqiang

doi:10.13204/j.gyjz201309006

Volume 43 Issue 9

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2013 > 43(9): 35-39,161

Xue Jianyang, Liu Jinlu, Ma Hui, Liu Yi, Liu Zuqiang. EXPERIMENTAL STUDY ON RESTORING FORCE MODEL OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 35-39,161. doi: 10.13204/j.gyjz201309006

Citation:

Xue Jianyang, Liu Jinlu, Ma Hui, Liu Yi, Liu Zuqiang. EXPERIMENTAL STUDY ON RESTORING FORCE MODEL OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 35-39,161. doi: 10.13204/j.gyjz201309006

Citation:

PDF( 0 KB)

EXPERIMENTAL STUDY ON RESTORING FORCE MODEL OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS

doi: 10.13204/j.gyjz201309006

1.
College of Civil Engineering,Xi’an University of Architecture and Technology,Xi’an 710055,China

Received Date: 2013-01-30
Publish Date: 2013-09-20

Abstract

Abstract

Based on the quasi-static test results of 7 steel reinforced recycled aggregate concrete (SＲＲC) columns，the method of calculation of the characteristic parameters was given and thedesignated pointbroken tri-linearrestoring force model for steel reinforced recycled aggregate concrete columns was also proposed by the theoreticalanalysis and experimental data fitting． The results show that the axial compression ratio，stirrup ratio and coarseaggregate replacement rate have little influence on the ratio of ultimate load to yield load，which approximates 0. 8．The ultimate load increases with the increase of axial compression ratio． However，the ductility decreases with theincrease of the coarse aggregate replacement rate and axial compression ratio，yet it increases as the stirrup ratioincreasing． Through the comparison between the test results and the calculated results，the restoring force model canreflect the mechanical performance of SＲＲC components and the results agree well with the test results，indicatingthat the restoring force model can be used for SＲＲC columns．

FullText(HTML)

References(10)

References

Park Y J,Reinhorn A M,Kunnath S K.IDARC:Inelastic DamageAnalysis of Reinforced Concrete Frame-Share-Wall Structures[R].Technical Report ,No.NCEER-87-0008,State Univ.ofNew York,1987.

[2] 沈聚敏,翁义军,冯世平.周期反复荷载下钢筋混凝土压弯构件的性能[J].土木工程学报,1982,15(2):53-64.

[3] 朱伯龙,张琨联.矩形及环形截面压弯构件恢复力特性的研究[J].同济大学学报,1981,9(2):1-10.

[4] 郭子雄,杨勇.恢复力模型研究现状及存在的问题[J].世界地震工程,2004,20(4):47-51.

[5] 郭子雄,张志伟,黄群贤,等.型钢混凝土柱恢复力模型试验研究[J].地震工程与工程振动,2009,29(5):79-85.

[6] 白国良,石启印.空腹式型钢混凝土框架柱的恢复力性能[J].西安建筑科技大学学报,1999,31(1):32-34.

[7] 刘阳,郭子雄,黄群贤.核心型钢混凝土柱恢复力模型试验研究[J].建筑结构学报,2009,30(S2):196-201.

[8] 薛建阳,王运成,马辉,等.型钢再生混凝土柱水平承载力及轴压比限值的试验研究[J].工业建筑,2013,43(9):32-37.

[9] 肖建庄.再生混凝土[M].北京:中国建筑工业出版社,2008.

[10] 靳鹏.型钢混凝土转换柱(SRC-RC)恢复力模型的研究与理论分析[D].西安:西安建筑科技大学,2008.

Relative Articles

[1]	LI Huankun, WANG Jianjun. Experimental Research on Seismic Performance of C-Shaped Light-Gauge Steel Shear Walls Filled with Expanded Polystyrene Lightweight Concrete[J]. INDUSTRIAL CONSTRUCTION, 2025, 55(4): 78-87. doi: 10.3724/j.gyjzG23031408
[2]	WANG Bo, WANG Ning, WANG Jingfeng, CHEN Gang, CHENG Tao. Seismic Performance Tests of Prefabricated Concrete Frames with Embedded Composite Lightweight Aggregate Partition Wall Panels[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(5): 159-169. doi: 10.3724/j.gyjzG23052901
[3]	FU Xin, PAN Molan, WANG Daiyu, WU Duanshuo. Quasi-Static Numerical Simulations and Resilient Force Models of GFRP-Confined FRP Bar-Reinforced Concrete Piers[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(6): 31-45. doi: 10.3724/j.gyjzG24040301
[4]	CUI Keran, YU Feng, CHEN Taiyao, QIN Yin, FANG Yuan, BU Shuangshuang. Research on Restoring Force Models of Reinforced Self-Stressing Steel Slag Concrete Columns Confined with Circular Steel Tubes[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(7): 50-61. doi: 10.13204/j.gyjzG22101204
[5]	CHU Liusheng, YAN Zenghui, TIAN Ye, YUAN Chengfang. A Resilience Model for Joints Between Steel-Reinforced Concrete Columns and Steel Beams Considering the Effect of Floor Slabs in a Shear Failure Mode[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(1): 175-181,90. doi: 10.13204/j.gyjzG20122911
[6]	WANG Yan, XU Shanhua, LI Anbang. Research on Restoring Force Model of Freeze-Thaw Damaged Reinforced Concrete Columns[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(8): 97-102. doi: 10.13204/j.gyjzG21101322
[7]	ZHANG Guangtai, LIU Shituo, WANG Mingyang, LI Ruixiang, GUO Qiaojun. EXPERIMENTAL STUDY ON RESTORING FORCE MODEL FOR STEEL-POLYPROPYLENE-FIBER-REINFORCED CONCRETE SHEAR WALLS WITH LITHIUM SLAG[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(8): 53-59,33. doi: 10.13204/j.gyjzG20053102
[8]	LI Ganggang, ZHAO Jun. SEISMIC CHARACTERISTICS OF HYBRID FRP-STEEL-REINFORCED CONCRETEL SHEAR WALLS SUBJECTED TO CYCLIC LOADS[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(10): 180-186,75. doi: 10.13204/j.gyjz201904140005
[9]	Xue Jianyang Liu Fei Gao Liang, . EXPERIMENTAL STUDY OF RESTORING FORCE CHARACTERISTICS OF STEEL REINFORCED RECYCLED CONCRETE FRAME INFILLED WITH RECYCLED CONCRETE HOLLOW BLOCKS[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(6): 160-164. doi: 10.13204/j.gyjz201506031
[10]	Men Jinjie, Li Peng, Guo Zhifeng. RESEARCH ON RESTORING FORCE MODEL OF RC COLUMN-STEEL BEAM COMPOSITE JOINTS[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(5): 132-137. doi: 10.13204/j.gyjz201505028
[11]	Xie Yongping, Jia Lei. SEISMIC BEHAVIOR OF LARGE-SCALE REINFORCED CONCRETE COLUMNS WITH DIFFERENT AXIAL LOAD RATIO[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(07): 31-36.
[12]	Xue Jianyang, Wang Cheng, Ma Hui, Zhou Sheng, Zhang Jie. NUMERICAL SIMULATION OF SHEAR BEHAVIOR OF STEEL RECYCLED AGGREGATE CONCRETE SHORT COLUMNS BASED ON OPENSEES PROGRAM[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(8): 114-119,137. doi: 10.13204/j.gyjz201308025
[13]	Cen Wenxiang, Zhang Yaoting. STUDY ON THE EFFECTS OF AXIAL COMPRESSION RATIO ON SEISMIC CAPACITY OF PRESTRESSED CONCRETE FRAME[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 65-70,110. doi: 10.13204/j.gyjz201309012
[14]	Li Yanyan, Wang Meng, Zhang Jianxin, Liu Kun. EFFECT OF AXIAL COMPRESSION RATIO ON SEISMIC BEHAVIOR OF SPECIALLY SHAPED COLUMNS WITH HIGH STRENGTH STEEL BARS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(4): 62-65. doi: 10.13204/j.gyjz201304013
[15]	Ye Xianguo, Wang Chengcheng, Chong Xun, Jiang Qing, Huang Xiaokun, Liu Gang. EXPERIMENTAL STUDY ON SHEAR BEHAVIOR OF BEAM WITH C1 00 CONCRETE AND HRBF500 GRADE REBAR[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(7): 86-90. doi: 10.13204/j.gyjz201207013
[16]	Fang Zhi, Wang Fei, Yin Xinfeng, Wang Cheng. EXPERIMENTAL STUDY ON SEISMIC PERFORMANCE OF RC BOX PIERS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(3): 12-19. doi: 10.13204/j.gyjz201203003
[17]	Bai Liang, Liang Xingwen. INFLUENCE OF THE CHARACTERISTIC VALUE OF STIRRUP CONTENT IN BOUNDARY ELEMENTS ON ALLOWABLE AXIAL LOAD RATIO FOR CONCRETE STRUCTURAL WALLS[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(4): 44-48. doi: 10.13204/j.gyjz200904011
[18]	Yan Jihong, Yu Liu. LIMITATION OF AXIAL-LOAD RATIO OF REINFORCED CONCRETE FRAME COLUMNS STRENGTHENED WITH AFRP SHEETS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(6): 104-106. doi: 10.13204/j.gyjz200706027
[19]	Zhao Zhonghu, Xie Heping, Xu Bo, Liu Zhibao. PRESENT STATUS OF RESEARCH ON CHARACTERISTICS OF RESTORING FORCE OF RC COMPRESSION-FLEXURE MEMBER[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(1): 62-65. doi: 10.13204/j.gyjz200601019
[20]	Zhang Guojun, LüXilin. EXPERIMENTAL STUDY ON MECHANICAL BEHAVIOR OF HIGH STRENGTH CONCRETE SHORT COLUMNS WITH HIGH AXIAL LOAD RATIO[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(3): 20-22,26. doi: 10.13204/j.gyjz200503009