EXPERIMENTAL STUDY ON LATERAL BEARING CAPACITY AND AXIAL COMPRESSION RATIO LIMIT VALUES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS

Xue Jianyang; Wang Yuncheng; Ma Hui; Liu Jinlu; Ao Xiang

doi:10.13204/j.gyjz201309005

Volume 43 Issue 9

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2013 > 43(9): 30-34,45

Wu Jin, Huang Jie. RESEARCH ON FATIGUE BEHAVIOR OF CONCRETE BEAMS WITH SLIGHT CORROSION REINFORCEMENT[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(5): 65-67. doi: 10.13204/j.gyjz200905013

Citation:

Xue Jianyang, Wang Yuncheng, Ma Hui, Liu Jinlu, Ao Xiang. EXPERIMENTAL STUDY ON LATERAL BEARING CAPACITY AND AXIAL COMPRESSION RATIO LIMIT VALUES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 30-34,45. doi: 10.13204/j.gyjz201309005

Wu Jin, Huang Jie. RESEARCH ON FATIGUE BEHAVIOR OF CONCRETE BEAMS WITH SLIGHT CORROSION REINFORCEMENT[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(5): 65-67. doi: 10.13204/j.gyjz200905013

Citation:

PDF( 0 KB)

EXPERIMENTAL STUDY ON LATERAL BEARING CAPACITY AND AXIAL COMPRESSION RATIO LIMIT VALUES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS

doi: 10.13204/j.gyjz201309005

1.
College of Civil Engineering,Xi’an University of Architecture and Technology,Xi’an 710055,China

Received Date: 2013-01-30
Publish Date: 2013-09-20

Abstract

Abstract

Based on the test of seven steel reinforced recycled aggregate concrete (SＲＲC) columns under low-cyclicreversed loading，the lateral bearing capacity and axial compression ratio limit of the steel reinforced recycledaggregate concrete columns were studied． The influences of the axial compression ratio，stirrup ratio and recycledcoarse aggregate replacement rate on the bearing capacity of steel reinforced recycled aggregate concrete column wereanalyzed in this paper． It is shown that the lateral bearing capacity increases and the ductility coefficient reduces asthe increase of the axial compression ratio of the column． The column exhibits good bearing capacity as the increase ofthe stirrup ratio． There is no obvious influence of coarse aggregate replacement rate on the load carrying capacity ofthe column，which shows the same good bearing capacity and ductility as those of ordinary steel reinforced concretecolumn． The axial compression ratio limit of steel reinforced recycled aggregate concrete column was deduced basedon the force balanced condition at balanced failure． Finally，the axial compression ratio limit values of the SＲＲCcolumn under different seismic levels were put forward for engineering design reference in terms of the test data andductility analysis of the specimen．
- steel reinforced recycled aggregate concrete,
- column,
- bearing capacity,
- ductility,
- axial compression ratio limit

FullText(HTML)

References(11)

References

Limbachiya M C, Leelawat T,Dhir R K.Use of RecycledConcrete Aggregate in High-Strength Concrete [J].Materials andStructures,2000,233(33):574-580.

[2] 肖建庄,李佳彬,兰阳.再生混凝土技术研究最新进展与评述[J].混凝土,2003(10):17-20.

[3] 孙越东,肖建庄,周德源,等.再生混凝土框架抗震性能的试验研究[J].土木工程学报,2006(5):9-15.

[4] Mahony O,Margaret M.Analysis of the Shear Strength of RecycleAggregates[J].Materials and Structures,1997,204(30):599-606.

[5] 肖建庄,朱晓晖.再生混凝土框架节点抗震性能研究[J].同济大学学报:自然科学版,2005,33(4):436-440.

[6] 肖建庄.再生混凝土[M].北京:中国建筑工业出版社,2008.

[7] 李俊华,赵鸿铁,薛建阳.型钢高强混凝土柱延性的试验研究[J].西安建筑科技大学学报:自然科学版,2004,36(4):383-386.

[8] YB 90822006 钢骨混凝土结构技术规程[S].

[9] 叶列平,方鄂华,周正海,等.钢骨混凝土柱的轴压力限值[J].建筑结构学报,1997,18(5):43-50.

[10] 崔卫光.型钢再生混凝土组合柱正截面受力性能试验研究[D].西安:西安建筑科技大学,2011.

[11] JGJ 1382001 型钢混凝土组合结构技术规程[S].

Relative Articles

[1]	XUE Weichen, ZHANG Baozheng, CHEN Shengyang, JIANG Jiafei, GUO Dapeng. State of the Art on Mechanical Properties of Precast Prestressed Concrete Structures (for Buildings and Utility Tunnels)[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(10): 9-20. doi: 10.3724/j.gyjzG24100801
[2]	XIE Li, FANG Xu, CHEN Mengcheng, YANG Chao, HUANG Hong. Experimental Research on Mechanical Properties of Composite Cross-Shaped Concrete Filled Steel Tubular Column Under Axial Compression[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(2): 133-137,196. doi: 10.13204/j.gyjz2018121501
[3]	HAO Wenxiu, CUI Boyun, XU Xiao. Experimental Research on the Axial Compressive Capacity of Thin-Walled Concrete-Filled Square Steel Tubular Columns[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(7): 109-115,230. doi: 10.13204/j.gyjzG22040112
[4]	Chen Zongping, Zheng Wei, Ye Peihuan, Zhang Shiqian. EXPERIMENTAL STUDY ON MECHANICAL BEHAVIOUR OF REINFORCED RECYCLED COARSE AGGREGATE CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(04): 65-68.
[5]	Chen Zongping, Tan Qiuhong, Xue Jianyang, Chen Yuliang. STUDY OF ULTIMATE BEARING CAPACITY OF RECYCLED AGGREGATE CONCRETE-FILLED CIRCLE STEEL TUBE SHORT COLUMNS UNDER AXIAL COMPRESSION AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 5-12. doi: 10.13204/j.gyjz2001411002
[6]	Chen Zongping, Zheng Wei, Zhou Chunheng, Xue Jianyang. TEST OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE AXIAL COMPRESSION SHORT COLUMNS AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 32-38. doi: 10.13204/j.gyjz2001411006
[7]	Wang Qiuwei, Shi Qingxuan, Tang Liujiu. NUMERICAL ANALYSIS AND ULTIMATE AXIAL COMPRESSION RATIO OF NEW STEEL REINFORCED CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(7): 127-133,174. doi: 10.13204/j.gyjz201207022
[8]	Long Yueling, Cai Jian, Huang Yansheng. ULTIMATE CAPACITY OF AXIALLY-LOADED RECTANGULAR CFT STUB COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(7): 95-99. doi: 10.13204/j.gyjz201007024
[9]	Wang Qingxiang, Zhao Pengzhan, Guan Hongbo. AN EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CONCRETE－FILLED GFRP TUBE COLUMN[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(4): 70-74. doi: 10.13204/j.gyjz201004016
[10]	Qi Yue, Zheng Wenzhong. BEARING CAPACITY ANALYSIS OF THE CONCRETE COLUMNS WITH HIGH STRENGTH CORE UNDER AXIAL COMPRESSION LOAD[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(4): 75-78. doi: 10.13204/j.gyjz201004017
[11]	Long Yueling, Cai Jian. EXPERIMENTAL STUDY ON ECCENTRIC-LOADED BEHAVIOR OF RECTANGULAR CFT STUB COLUMNS WITH BINDING BARS[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(10): 126-130,71. doi: 10.13204/j.gyjz200910028
[12]	Liang Xingwen, Yang Penghui, Deng Mingke. THE STUDY ON THE ALLOWABLE AXIAL LOAD RATIO OF CONCRETE SHEAR WALL WITHOUT CONFINED BOUNDARY ELEMENTS[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(9): 67-70. doi: 10.13204/j.gyjz200909013
[13]	Wen Yuping, Wang Qingxiang. EXPERIMENT RESEARCH ON ASEISMATIC BEHAVIOR OF JOINTS OF HEAVY-LOAD STEEL TUBE COLUMNS FILLED WITH STEEL-REINFORCED CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(3): 20-22,8. doi: 10.13204/j.gyjz200803006
[14]	Jiao Junting, Diao Bo, Ye Yinghua. RESEARCH ON THE ULTIMATE AXIAL COMPRESSION RATIO OF REINFORCED CONCRETE L-SHAPED COLUMNS BY SECTION GAUSS NUMERICAL INTEGRATION[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(7): 36-38. doi: 10.13204/j.gyjz200707012
[15]	Cai Jian, He Zhenqiang, Chen Xing. EXPERIMENTAL STUDY ON BEHAVIOR OF RECTANGLE CFT STUB COLUMN WITH BINDING BARS SUBJECTED TO AXIALLY LOADING[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(3): 75-80,113. doi: 10.13204/j.gyjz200703019
[16]	Su Yi, Cheng Wenrang. LIMIT VALUE OF AXIAL COMPRESSION RATIO OF SRC COLUMN WITH H-SHAPED OR CROSS STEEL SECTION[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(2): 85-87. doi: 10.13204/j.gyjz200602025
[17]	Tao Zhong, Yu Qing, Teng Jinguang. EXPERIMENTAL BEHAVIOR OF FRP-CONFINED SQUARE RC LONG COLUMNS UNDER ECCENTRIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(9): 5-7,28. doi: 10.13204/j.gyjz200509002
[18]	Xian Qiaoling, Yi Weijian, Ding Hongtao. THE INFLUENCE FACTORS ON THE STRENGTH AND DUCTILITY OF THE REINFORCED CONCRETE COLUMNS EXTERNALLY BONDED WITH CFRP[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(5): 101-104. doi: 10.13204/j.gyjz200505027
[19]	Gao Xian, Tao Zhong, Yang Youfu, Yu Qing. HYSTERETIC BEHAVIOR OF CIRCULAR RC COLUMNS CONFINED WITH FRP JACKETS[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(9): 11-14. doi: 10.13204/j.gyjz200509004
[20]	Xian Qiaoling, Yi Weijian, Ding Hongtao. EXPERIMENT AND RESEARCH OF REINFORCED CONCRETE COLUMN EXTERNALLY BONDED WITH CFRP SHEETS UNDER ECCENTRIC LOAD[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(11): 78-81. doi: 10.13204/j.gyjz200411021