BEHAVIOR OF INTERIOR JOINTS FOR REINFORCED CONCRETE FRAME WITH DIFFERENT DEPTH BEAMS

Pan Yuan; Xing Guohua; Wu Tao; Liu Boquan

doi:10.13204/j.gyjz201009015

Volume 40 Issue 9

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2010 > 40(9): 53-57

Pan Yuan, Xing Guohua, Wu Tao, Liu Boquan. BEHAVIOR OF INTERIOR JOINTS FOR REINFORCED CONCRETE FRAME WITH DIFFERENT DEPTH BEAMS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(9): 53-57. doi: 10.13204/j.gyjz201009015

Citation:

Pan Yuan, Xing Guohua, Wu Tao, Liu Boquan. BEHAVIOR OF INTERIOR JOINTS FOR REINFORCED CONCRETE FRAME WITH DIFFERENT DEPTH BEAMS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(9): 53-57. doi: 10.13204/j.gyjz201009015

Citation:

PDF( 0 KB)

BEHAVIOR OF INTERIOR JOINTS FOR REINFORCED CONCRETE FRAME WITH DIFFERENT DEPTH BEAMS

doi: 10.13204/j.gyjz201009015

1.
School of Civil Engineering,Chang’an University,Xi’an 710061,China

Received Date: 2010-05-24
Publish Date: 2010-09-20

Abstract

Abstract

Ten specimens of reinforced concrete interior joints with different depth beams were tested under reversed cyclic loading. The experimental study was conducted that focused on the failure characteristics and layer deformation capacity of beam column subassemblage. Results indicated that the critical crack load was quite nearly with the ultimate load of interior joints and the seismic behavior was poorer than that of ordinary joints,and the shear failures of all the specimens appeared in the large core under external loads,which can not meet the design requirement of a rigid joint. Furthermore,the layer deformation capacity analysis indicated that the deformation capacity of interior joint can satisfy the deformation demand in the elastic stage. However,the deformation capacity can not satisfy the deformation demand in the elastic-plastic stage based on the critical crack stage design. Thus,a security reserve coefficient was suggested in the seismic design of joints for RC structures to preserve the structural integrity.
- interior jointseismic behaviorframe structuresdeformation capacity,

FullText(HTML)

References(8)

References

[2] GB 500112001 建筑抗震设计规范[S].

GB 500102002 混凝土结构设计规范[S].

[3] JGJ 10196 建筑抗震试验方法规程[S].

[4] 吴涛，邢国华，刘伯权.钢筋混凝土框架异型中节点抗震性能影响因素分析[J].工业建筑，2009，39 (10):30-34.

[5] 沈聚敏，周锡元，高小旺，等.抗震工程学[M].北京:中国建筑工业出版社，1999:381-388.

[6] 周起敬，姜维山，潘泰华.钢与混凝土组合结构设计施工手册[M].北京:中国建筑工业出版社，1994:246-263.

[7] 吕西林，郭子雄，王亚勇.RC 框架梁柱组合件抗震性能试验研究[J].建筑结构学报，2001，22 (1): 2-7.

[8] 唐九如.钢筋混凝土框架节点抗震[M].南京:东南大学出版社，1989:36-49.

Relative Articles

[1]	ZHOU Qiaoling, ZHAO Shixing, ZHONG Ziqin, ZHANG Ming, CHEN Shuwei, YANG Shuheng. Experimental Research on the Seismic Performance of Bamboo Scrimber Beam-Column Joints[J]. INDUSTRIAL CONSTRUCTION, 2025, 55(2): 44-51. doi: 10.3724/j.gyjzG24102205
[2]	XIE Zhiqiang, GAO Chengwei, QIAN Zengzhi, BI Ye, TANG Shengqiang, YI Hang, LIU Hongjiang, DING Shijun. Research on In-Plane Deformation Performance of Masonry Walls Confined with Prefabricated Cold-Formed Steel Tie-Columns[J]. INDUSTRIAL CONSTRUCTION, 2025, 55(4): 88-95. doi: 10.3724/j.gyjzG24112908
[3]	YANG Xiaohua, ZHANG Qian, WU Senkun, FENG Jian, CAI Jianguo. Seismic Performance Analysis of Beam-Column Connections of Prefabricated Fiber Modified Concrete Frames[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(4): 102-107,147. doi: 10.13204/j.gyjzG20122208
[4]	GAO Peinan, DENG Yang, LI Aiqun, LU Fengyong. REVIEW ON SEISMIC PERFORMANCE OF CONNECTION JOINTS OF PREFABRICATED CONCRETE FRAME STRUCTURES[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(2): 171-185,152. doi: 10.13204/j.gyjzG20040805
[5]	MEN Yiang, WANG Xinwu, YU Yongqiang, SHI Qiang. RESEARCH ON SEISMIC BEHAVIOR OF BEAM-COLUMN JOINTS OF PREFABRICATED STEEL FRAME STRUCTURES[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(3): 156-159,135. doi: 10.13204/j.gyjz202003027
[6]	Du Yuanfang, Wang Sheliang, Zhao Qin, Fan Yujiang. SHAKING TABLE TEST OF ENHANCED RECYCLED AGGREGATE CONCRETE FRAME STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(11): 30-33,44. doi: 10.13204/j.gyjz201311007
[7]	Yan Xikang, Yan Hua, Chen Pei. STUDIES OF SEISMIC BEHAVIOR OF A REINFORCED CONCRETE FRAME WITH CONSTRUCTION JOINT[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(10): 46-49. doi: 10.13204/j.gyjz201310011
[8]	Rong Xian, Zhang Jianxin, Li Yanjun, Li Yanyan. EXPERIMENTAL RESEARCH ON MECHANICAL BEHAVIOR OF INTERIOR JOINTS OF SPECIALLY SHAPED COLUMN FRAMES REINFORCED BY STEEL FIBER[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(5): 47-51. doi: 10.13204/j.gyjz201305011
[9]	Gao Danying, Zhang Junwei. EXPERIMENTAL INVESTIGATION ON SEISMIC BEHAVIOR OF STEEL FIBER REINFORCED HIGH- STRENGTH CONCRETE FRAME EXTERIOR JOINTS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(5): 84-89,28. doi: 10.13204/j.gyjz2011205015
[10]	Zhu Lanlan, Zheng Qizhen, Wang Dong, Yang Jue. SEISMIC APPRAISAL AND STRENGTHENING DESIGN OF A STOREY-ADDING-FRAME STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(1): 160-163,65. doi: 10.13204/j.gyjz201201031
[11]	Liu Chunyang, Li Zhenbao, Ma Hua, Han Jianqiang. EXPERIMENT STUDY ON ASEISMIC BEHAVIOR OF RC FRAME SPACE JOINTS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(6): 67-70. doi: 10.13204/j.gyjz201106014
[12]	Yan Hua, Li Ronghua. ASEISMIC PERFORMANCE ANALYSIS OF A MOMENT FRAME STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(9): 136-140. doi: 10.13204/j.gyjz201109031
[14]	Xing Guohua, Liu Boquan, Wu Tao, Lu Benyan. CHARACTERISTIC ANALYSIS OF INTERIOR JOINTS OF RC FRAME WITH DIFFERENT DEPTH BEAMS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(11): 47-50. doi: 10.13204/j.gyjz201011013
[15]	Liu Jianwei, Li Yingmin, Yang Zhihong, Xia Hongliu, Shan Liang. COMPARISON OF ASEISMIC BEHAVIOR OF TRADITIONAL AND SANDWICH SPACE RC BEAM-COLUMN JOINTS BASED ON CYCLIC LOAD TEST[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(2): 88-93. doi: 10.13204/j.gyjz200902014
[16]	Yang Ling-qiang, Wu Jia-qing. RESEARCH ON DEFORMATION OF FRAME STRUCTURES IN UNDERGROUNDWORKING-OUT SECTION AREA[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(12): 81-83. doi: 10.13204/j.gyjz200712019
[17]	Wu Shuguang, Chang Yejun. SOME PROBLEMS OF THE SEISMIC DESIGN AND BLUEPRINT CHECKUP OF RC FRAME STRUCTURE BUILDING[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(6): 46-50. doi: 10.13204/j.gyjz200706012
[18]	Ai Bing, Wu Minzhe, Guo Di, Wang lixin. EXPERIMENT ON SEISMIC BEHAVIOR OF 4-STORY R.C. FRAME WITH BROAD-LIMB SPECIAL SHAPE COLUMN[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(2): 11-13,10. doi: 10.13204/j.gyjz200702003
[19]	Sun Wei-wei, Meng Shao-ping, Wu Jing. RESEARCH ON SEISMIC CAPACITY OF PRESTRESSED CONCRETE FRAME STRUCTURES WITH LARGE LONGITUDINAL LENGTH[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(5): 23-26. doi: 10.13204/j.gyjz200605007
[20]	Huang Yasheng, Chen Xiaobao, Ma Hongwang, Yang Jianjun, LüMengying. THE MINIMUM DEPTH OF THE GIRDER OF PRESTRESSED CONCRETE FRAME DUE TO REQUIREMENT OF PRESTRESS DEGREE FOR ASEISMIC DESIGN[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(6): 14-16. doi: 10.13204/j.gyjz200506004