EXPERIMENTAL STUDY ON THE MECHANICAL PERFORMANCE OF A BLAST FURNACE FOUNDATION

Xue Shangling; Li Yingmin; Dong Qishi; Liu Liping; Xiao Qihua; Wang Lu; Liao Xiufeng

doi:10.13204/j.gyjz201002020

Volume 40 Issue 2

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2010 > 40(2): 86-91

Gu Sheng, Tang Baijian. ESTIMATION OF INITIAL TENSION OF CABLES IN MULTI-STOREY PRESTRESS-MEGA-BRACED STEEL FRAME STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(1): 120-123. doi: 10.13204/j.gyjz201101027

Citation:

Xue Shangling, Li Yingmin, Dong Qishi, Liu Liping, Xiao Qihua, Wang Lu, Liao Xiufeng. EXPERIMENTAL STUDY ON THE MECHANICAL PERFORMANCE OF A BLAST FURNACE FOUNDATION[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(2): 86-91. doi: 10.13204/j.gyjz201002020

Citation:

PDF( 0 KB)

EXPERIMENTAL STUDY ON THE MECHANICAL PERFORMANCE OF A BLAST FURNACE FOUNDATION

doi: 10.13204/j.gyjz201002020

1.
1. Chongqing Iron and Steel Design Institute Engineering Co.Ltd,Chongqing 400013,China;
2.
2. College of Civil Engineering,Chongqing University,Chongqing 400045,China;
3.
3. Chongqing Architectural Design Institute,Chongqing 400015,China

Received Date: 2009-08-20
Publish Date: 2010-02-20

Abstract

Abstract

The 3 specimens of blast furnace foundations under the action of vertical load and temperature effect were tested.The influence of temperature on blast furnace foundation is discussed,and the characteristics of foundation stress based on different grounds are compared.The conclusions are: 1)only the top of the foundation is affected by temperature effect;2)under vertical loading,the stress in the bottom of blast furnace foundation supported by uniform ground is low and the stress in the bottom supported by piles is high;3) there is obvious stress concentration at the interface between foudation and the upper sturcture,the way of setting the constructional reinforcement needs improvement.
- blast furnace foundation,
- mechanical performance,
- experimental research,
- temperature effect

FullText(HTML)

References(3)

References

彭立海,阎士勤,张春生,等.大体积混凝土温控与防裂[M].郑州:黄河水利出版社,2005.

[2] GB 500102002混凝土结构设计规范[S].

[3] 王铁梦.工程结构裂缝控制[M].北京:中国建筑工业出版社,1997.

Relative Articles

[1]	CHONG Xun, WANG Zeen, ZHU Wangcheng, JIANG Qing, ZENG Ying, ZHANG Weidong, YE Chuansheng. Experimental Research on Mechanical Properties of Reinforced Gypsum Beams[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(7): 166-173. doi: 10.3724/j.gyjzG23091308
[2]	YE Yong, YANG Shixuan, CHEN Hongtao, GUO Zixiong. Experimental Research on Mechanical Properties of Stone Curtain Wall Connection with Attached Stone Back Hook[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(10): 160-167. doi: 10.3724/j.gyjzG23091701
[3]	LIN Yan, LIU Yizheng, LIN Qingwei, ZHONG Chongting, SONG Jiankai. Experimental Research on Mechanical Properties of a New Prefabricated Concrete-Filled Composite Steel Box Caisson Structure[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(1): 201-206. doi: 10.13204/j.gyjzG21100401
[4]	LYU, Kunde, LI, Haifeng. RESEARCH ON THE MECHANICAL PROPERTIES OF EARTHQUAKE-RESILIENT BOX-SHAPED STEEL PIERS[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(1): 162-169. doi: 10.13204/j.gyjz202001026
[5]	LIN Yan, SONG Jiankai, ZHONG Chongting. EXPERIMENTAL RESEARCH ON MECHANICAL PROPERTIES OF COMPOSITE CONCRETE SLABS WITH DIFFERENT JOINT CONSTRUCTION MEASURES[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(6): 45-50,104. doi: 10.13204/j.gyjz202006008
[6]	Wang Xiantie, Li Haiguang, Bai Lianping, Ma Yousufu. STUDY OF MECHANICAL BEHAVIOR OF THE CONCRETE FILLED SQUARE STEEL TUBE FRAMES-THIN STEEL PLATE SHEAR WALLS WITH SIDE OPENINGS[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(1): 156-160. doi: 10.13204/j.gyjz201501032
[7]	Li Qing, Yuan Guanglin, Li Qingtao, Nie Ming. STUDY OF MECHANICAL PROPERTIES OF RC BEAMS AFTER REINFORCING THE OPENING ON THE BENDING SHEAR SECTION[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(8): 67-72. doi: 10.13204/j.gyjz201508013
[8]	Zhang Yanxia, Zhao Wei, Li Yunpeng, Min Zongjun. RESEARCH ON MECHANICAL BEHAVIOR OF THE CIRCULAR HOLE CELLULAR BEAMS AND STEEL-CONCRETE COMPOSITE CELLULAR BEAM[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(2): 136-142. doi: 10.13204/j.gyjz201502028
[9]	Xue Jianyang, Liu Zuqiang, Zhao Hongtie, Chen Zongping, Liu Yi. STATE-OF-THE-ART RESEARCH ON MECHANICAL PERFORMANCE OF STEEL REINFORCED CONCRETE IRREGULAR SECTION COLUMN STRUCTURES[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(03): 134-146. doi: 10.13204/j.gyjz201403028
[10]	Ma Yousufu, Wang Xiantie, Yang Hangdong, Gao Yajing, Zhou Chao, Zheng Jiang. MECHANICAL BEHAVIOR STUDY OF STEEL PLATE SHEAR WALLS WITH CHANNEL STIFFENERS[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(10): 152-157. doi: 10.13204/j.gyjz201410030
[11]	Rong Xian, Zhang Jianxin, Li Yanjun, Li Yanyan. EXPERIMENTAL RESEARCH ON MECHANICAL BEHAVIOR OF INTERIOR JOINTS OF SPECIALLY SHAPED COLUMN FRAMES REINFORCED BY STEEL FIBER[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(5): 47-51. doi: 10.13204/j.gyjz201305011
[12]	Yang Yong, Li Huijing, Xue Jianyang. EXPERIMENTAL STUDY ON THE MECHANICAL BEHAVIOR AND DESIGN METHOD OF PLAIN STEEL PLATE AND CONCRETE COMPOSITE HOLLOW SLABS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(12): 116-120. doi: 10.13204/j.gyjz201212025
[13]	Jiang Lixue. EXPERIMENTAL STUDY ON STRUCTURAL BEHAVIOR OF R/C CONTINUOUS BEAMS WITH CAST-IN-SITU SLABS UNDER VERTICAL LOAD[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(11): 62-67. doi: 10.13204/j.gyjz200911015
[14]	Ding Beidou, Ding Li. RESEARCH ON MECHANICAL PERFORMANCE OF T-JOINT OF CIRCULAR TUBE UNDER LOW REVERSED CYCLIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(11): 102-105. doi: 10.13204/j.gyjz200811025
[15]	Yao Qianfeng, Wu Fang, Huang Wei, Ma Jing, Wang Hui, Zhang Yan. ANALYSIS OF MECHANICAL BE日AVIORS OF MULTI-RIBBED COMPOSITE-DOUBLE WALL[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(1): 31-35. doi: 10.13204/j.gyjz200801008
[16]	Li Bin, Ren Limin, Shi Xiaoyan. EXPERIMENTAL RESEARCH ON BEHAVIOR OF CONCRETE-FILLED RHS FRAMES[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(11): 97-101,105. doi: 10.13204/j.gyjz200811024
[17]	Zhang Jianrong, Liu Zhaoqiu, Hua Yijie. RESEARCH ON TEMPERATURE EFFECT COMBINATION IN THE DESIGN OF CONCRETE STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(1): 42-46,11. doi: 10.13204/j.gyjz200701012
[18]	Guo Jinshi, Yin Xinsheng. STUDY ON FORCED PERFORMANCE TEST OF EDGE JOINTS FOR REINFORCED CONCRETE FLAT BEAMS WITH EDGE BEAM[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(10): 76-78. doi: 10.13204/j.gyjz200510023
[19]	Dai Shaobin, Huang Jun, Zhu Jian. RESEARCH ON MECHANICAL PERFORMANCE OF T-JOINT OF STEEL FRAME[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(9): 90-93. doi: 10.13204/j.gyjz200509025
[20]	Li Zhilei, Gan Gang, Tang Jinchun. RESEARCH ON INTERNAL FORCE AND SPATIAL DEFORMATION OF AN OVERLONG FRAME STRUCTURE UNDER TEMPERATURE EFFECT[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(4): 36-39. doi: 10.13204/j.gyjz200404011