EXPERIMENT ON SHEAR BEHAVIOR OF L-SHAPED SECTION BROAD-LIMB COLUMNS SUBJECTED TO LOW CYCLIC LOADING

Dign Xiaoyan; Wang Tiecheng

doi:10.13204/j.gyjz200804010

Volume 38 Issue 4

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2008 > 38(4): 36-40

Dign Xiaoyan, Wang Tiecheng. EXPERIMENT ON SHEAR BEHAVIOR OF L-SHAPED SECTION BROAD-LIMB COLUMNS SUBJECTED TO LOW CYCLIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(4): 36-40. doi: 10.13204/j.gyjz200804010

Citation:

Dign Xiaoyan, Wang Tiecheng. EXPERIMENT ON SHEAR BEHAVIOR OF L-SHAPED SECTION BROAD-LIMB COLUMNS SUBJECTED TO LOW CYCLIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(4): 36-40. doi: 10.13204/j.gyjz200804010

Citation:

PDF( 0 KB)

EXPERIMENT ON SHEAR BEHAVIOR OF L-SHAPED SECTION BROAD-LIMB COLUMNS SUBJECTED TO LOW CYCLIC LOADING

doi: 10.13204/j.gyjz200804010

Dign Xiaoyan¹,
Wang Tiecheng²

1.
1. Luohe Professional and Technical University,Luohe 462000;
2.
2. College of Architectural Engineering,Tianjin University,Tianjin 300072

Received Date: 2007-12-05
Publish Date: 2008-04-20

Abstract

Abstract

On the basis of the experiment on shear failure of 11 L-shaped section broad-limb frame columns subjected to low cyclic loading, the influence of horizontal looading angle, embedded column and ratio of section width to height on its shear behavior has been analyzed as well a selements. shear failure mechanism. From the results it is indicated that L-shaped section broad-limb-columns have higher shear strength with oblique loads. The embedded column with proper bar would reinforce members. shear strength and ductility. The members. brittleness will rise with ratio of its section height to width increasing inthe process of shear failure.
- L-shaped section broad-limb column angle of loading embedded column ratio of section height to width shear behavior,

FullText(HTML)

References(7)

References

[2] 巩长江. L 形载面钢筋混凝土框架柱受剪性能的试验研究: [硕士学位论文]. 天津: 天津大学, 1994

郭棣. 宽肢异形柱的实验研究: [博士学位论文]. 西安: 西安建筑科技大学, 2001

[3] 康谷贻, 巩长江. 单调低周反复荷载作用下异形截面框架柱的受剪性能. 建筑结构学报, 1997, 18(5) : 22-31

[4] 巩长江, 康谷贻, 姚石良.L 形截面钢筋混凝土框架柱受剪性能的试验研究. 建筑结构, 1999(1) : 31-34

[5] 王丹. 钢筋混凝土框架异形柱设计理论研究: [博士学位论文].大连: 大连理工大学, 2002

[6] 包世华. 新编高层建筑结构. 北京: 中国水利水电出版社, 2005:199-206

[7] 李杰, 吴建营, 等. L 形和Z 形宽肢异形柱低周反复荷载试验研究. 建筑结构学报, 2002, 23(1) : 9-15

Relative Articles

[1]	GAO Shuran, ZHANG Junfeng, LI Bo, HAN Dongguang, REN Liqun. Research on Buckling Performance of Cold-Formed Uniformly Compressed Plates with Complex Edge Stiffeners[J]. INDUSTRIAL CONSTRUCTION, 2025, 55(3): 88-99. doi: 10.3724/j.gyjz.G22122203
[2]	XIONG Qingqing, GUI Haiwei, ZHANG Wang, LI Ge. Finite Element Parametric Analysis of Seismic Performance of Wide-Flange L-Shaped CFST Composite Columns with Built-in PBL[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(5): 7-16,173. doi: 10.13204/j.gyjzG22042402
[3]	JIA Lian-guang, TANG Kang, JIAO Yu-ming, ZHAO Yi-min. Research on Buckling of Webs of Castellated Composite Beams Under Negative Bending Moment[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(9): 129-137. doi: 10.13204/j.gyjzg21081705
[4]	HE Changjie, LI Lu, HUANG Hu, LI Jianxin, YANG Yong. ANALYSIS OF ENGINEERING SCHEMES FOR PARTIALLY PREFABRICATED STEEL REINFORCED CONCRETE BEAMS[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(10): 134-140. doi: 10.13204/j.gyjzG21020108
[5]	QIN Yongjun, LI Xiangyang, CUI Zhuang, WANG Bo. RESEARCH ON SHEAR PERFORMANCES OF CONCRETE DEEP BEAMS MIXED WITH DESERT SAND WITHOUT WEB REINFORCEMENT[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(9): 98-105. doi: 10.13204/j.gyjzG20081505
[6]	PI Zhengbo, WEI Qike, LAN Yongsen, LUO Wei, ZHANG Hao, WANG Shuqi. RESEARCH ON SHEAR AND BENDING PROPERTIES OF COMPOSITE REINFORCED CONCRETE SLABS WITH REINFORCED TRUSSES[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(6): 51-57. doi: 10.13204/j.gyjz202006009
[7]	Cao Dafu, Zhou Min, Ge Wenjie, Yuan Shenfeng. STUDY OF THE SHEAR BEHAVIORS OF RC BEAMS AFTER FREEZE-THAW CYCLES[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(2): 32-37. doi: 10.13204/j.gyjz201502008
[8]	Zheng Tingyin, Cao Haopeng, Wu Jingyu. SHEAR BEHAVIOR OF L-SECTION HONEYCOMB STEEL-REINFORCED CONCRETE COLUMN[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(05): 122-127.
[9]	Chen Zongping, Wang Huanhuan, Xue Jianyang, Chen Yuliang. SHEAR PROPERTIES EXPERIMENT OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE BEAMS AFTER ELEVATED TEMPERATURES[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 51-57. doi: 10.13204/j.gyjz2001411009
[10]	Du Zhao-hua, Liu Li-xin, Fu Jun-fei. EXPERIMENTAL STUDY ON THE SHEAR BEHAVIOR OF RECYCLED AGGREGATE CONCRETE BEAMS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(9): 66-70,78. doi: 10.13204/j.gyjz201209015
[11]	Chen Wei, Zhou Xuhong, Wu Fangbo, Huang Hailin, Xu Jing. EXPERIMENTAL STUDY ON BASIC MECHANICAL BEHAVIOR OF A NEW TYPE CONCRETE HORIZONTAL-HOLE HOLLOW BLOCK MASONRY[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(12): 98-101,115. doi: 10.13204/j.gyjz201112022
[12]	Chen Lin, Zhao Ruirong, Zhou Yun. INFLUENCE OF VERTICAL LOAD ON SHEAR PERFORMANCE OF BUCKLING-RESTRAINED COMPOSITE STEEL PLATE SHEAR WALL[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(10): 100-105. doi: 10.13204/j.gyjz201110024
[13]	Liu Jiahui, Bai Juan, Liu Lixin. EXPERIMENTAL STUDY ON SHEAR BEHAVIOR OF CONCRETE BEAMS REINFORCED BY HOT ROLLED RIBBED BARS OF FINE GRAINS[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(10): 106-110. doi: 10.13204/j.gyjz201010024
[14]	Meng Shaoping, Wang Guolin, Yuan Qin, Huang Shiping. EXPERIMENTS ON SHEAR BEHAVIOR OF PRESTRESSED CONCRETE BEAMS WITH DRAPED TENDONS:LONGITUDINAL REINFORCEMENT RATIO(A_s GROUP)[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(12): 5-9. doi: 10.13204/j.gyjz200912002
[15]	Xu Man, Wang Yuyin, Zhang Sumei. SHERA RESISTANCE BEHAVIOR OF TWO-SIDE CONNECTED STEEL-PLATE SHEAR WALL (SPSW)[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(3): 107-111. doi: 10.13204/j.gyjz200903028
[16]	Wang Guolin, Meng Shaoping, Huang Shiping, Yuan Qin. EXPERIMENTS ON SHEAR BEHAVIOR OF PRESTRESSED CONCRETE BEAMS:ANGLES OF PRESTRESSING TENDONS(θ GROUP)[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(12): 10-13. doi: 10.13204/j.gyjz200912003
[17]	Wang Qian, Diao Bo, Li Shuchun, Luo Youxin, Zhang Shaoxing. EXPERIMENT AND BEARING CAPACITY ANALYSIS OF R.C.L SHAPED COLUMN UNDER DIFFERENT DIRECTIONAL CYCLIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(9): 53-58. doi: 10.13204/j.gyjz200809017
[18]	Jiao Junting, Diao Bo, Ye Yinghua. RESEARCH ON THE ULTIMATE AXIAL COMPRESSION RATIO OF REINFORCED CONCRETE L-SHAPED COLUMNS BY SECTION GAUSS NUMERICAL INTEGRATION[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(7): 36-38. doi: 10.13204/j.gyjz200707012
[19]	Ai Bing, Wu Minzhe, Guo Di, Wang lixin. EXPERIMENT ON SEISMIC BEHAVIOR OF 4-STORY R.C. FRAME WITH BROAD-LIMB SPECIAL SHAPE COLUMN[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(2): 11-13,10. doi: 10.13204/j.gyjz200702003
[20]	Lu Linfeng, Gu Qiang. THE LIMITATION OF WEB DEPTH-THICKNESS RATIO AND SHEAR RESISTANCE OF PORTAL FRAME TAPERED GIRDER[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 74-76,82. doi: 10.13204/j.gyjz200403023