THEORY AND TEST INVESTIGATION OF BEARING CAPACITY OF CONCRETE FILLED STEEL TUBE UNDER ECCENTRIC COMPRESSION

Ma Shu-fang; Zhao Jun-hai; Wei Xue-ying

doi:10.13204/j.gyjz200610022

Volume 36 Issue 10

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2006 > 36(10): 79-80

Chang Haosong, Jiang Xinliang, Xie Jian, Yang Jianping, Ge Anxiang. TEST STUDY ON AXIAL COMPRESSION ANGLE STEEL WITH LOCAL DEFORMATION[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(6): 117-119,66. doi: 10.13204/j.gyjz201306023

Citation:

Ma Shu-fang, Zhao Jun-hai, Wei Xue-ying. THEORY AND TEST INVESTIGATION OF BEARING CAPACITY OF CONCRETE FILLED STEEL TUBE UNDER ECCENTRIC COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(10): 79-80. doi: 10.13204/j.gyjz200610022

Citation:

PDF( 0 KB)

THEORY AND TEST INVESTIGATION OF BEARING CAPACITY OF CONCRETE FILLED STEEL TUBE UNDER ECCENTRIC COMPRESSION

doi: 10.13204/j.gyjz200610022

1.
School of Civil Engineering,Chang'an University Xi'an 710061

Received Date: 2006-03-20
Publish Date: 2006-10-20

Abstract

Abstract

It was conducted the test of 16 concrete filled steel tubes (CFST) with different steel ratio under eccentric compression. The load-deformation curves and the ultimate loads of the samples were obtained. The formula of bearing capacity for CFST was also given based on twin shear unified strength theory. Good agreement was found between the experimental and the analytical values of the bearing capacity.
- concrete filled steel tube (CFST),
- bearing capacity,
- eccentric compression

FullText(HTML)

References(7)

References

韩林海, 钟善桐. 钢管混凝土力学. 大连: 大连理工大学出版社,1996

蔡绍怀, 顾万黎. 钢管混凝土长柱性能和强度计算. 建筑结构学报, 1985(1): 32-40

Chen W F. Plasticity in Reinforced Concrete. New York: McGraw-HillBook Company, 1982

蔡绍怀, 焦占拴. 钢管混凝土短柱的基本性能和强度计算. 建筑结构学报, 1984(6): 13-29

周起敬, 姜维山, 潘泰华. 钢管混凝土组合结构设计施工手册. 北京: 中国建筑工业出版社, 1991

汤关祚, 招炳泉, 竺惠仙, 等. 钢管混凝土基本力学性能的研究. 建筑结构学报, 1982(1): 13-31

赵均海, 顾强, 马淑芳. 基于双剪统一强度理论的轴心受压钢管混凝土承载力的研究. 工程力学, 2002, 19(2): 32-35

Relative Articles

[1]	JING Denghu, HU Songtao, QIAO Dun. Experimental Research on Size Effects of Brick Masonry Columns Reinforced with and Without External Angle Steel Under Axial Compression[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(12): 246-253. doi: 10.3724/j.gyjzG23120709
[2]	LI Zhenling, QIN Siyuan. Study on Horizontal Load-Bearing and Deformation Performances of Monopile Foundations for Offshore Wind Turbines Based on In-Situ Static Load Tests[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(6): 13-18. doi: 10.13204/j.gyjzG22122304
[3]	NIE Jin, XING Kuntao, YANG Jianping. Research on Tensile Capacity of Tensile Members of Double Angle with Local Deformation[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(12): 101-106. doi: 10.13204/j.gyjzG20010903
[6]	Ye Xin. RESEARCH ON THE BEARING CAPACITY OF ANGLE MEMBERS UNDER AXIAL FORCE BASED ON CHINESE AND AMERICAN TECHNICAL STANDARDS IN TRANSMISSION STEEL TOWER DESIGN[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(5): 146-151. doi: 10.13204/j.gyjz201505031
[7]	Sun Feng, Pan Rong, Sun Yunlun. NONLINEAR FINITE ELEMENT TEST SIMULATION OF THE MECHANICAL BEHAVIOR OF THE HALF-STEEL-CONCRETE COMPOSITE PLATE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(12): 36-40. doi: 10.13204/j.gyjz2001412007
[8]	Liu Weiping, Fu Mingfu. GRADIENT DEPENDENT NONLOCAL FRICTION MODEL AND ITS APPLICATION IN MECHANICAL ANALYSIS OF BOLT[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(08): 114-117.
[9]	Chang Haosong, Jiang Xinliang, Xie Jian, Yang Jianping, Ge Anxiang. RESEARCH ON BEARING CAPACITY OF SINGLE ANGLE STEEL WITH LOCAL DEFORMATION[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(04): 128-130.
[10]	Zhang Min, Ma Jianlin, Chai Rui, Wu Weisheng. STUDY OF INFLUENCE OF SHEAR RING ON FORCE AND DEFORMATION PROPERTIES OF STEEL TUBULAR COMPOSITE PILE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(11): 67-72,88. doi: 10.13204/j.gyjz201311016
[11]	Shi Gang, Lin Cuocuo, Wang Yuanqing, Shi Yongjiu. EXPERIMENTAL STUDY ON LOCAL BUCKLING OF HIGH STRENGTH STEEL SQUARE BOX SECTION STUB COLUMNS UNDER AXIAL COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(1): 18-25,36. doi: 10.13204/j.gyjz201201004
[12]	Shi Gang, Liu Zhao, Ban Huiyong, Zhang Yong, Shi Yongjiu, Wang Yuanqing. STUDY ON THE STABILITY DESIGN METHOD OF HIGH STRENGTH STEEL ANGLE MEMBERS UNDER AXIAL COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(6): 18-21. doi: 10.13204/j.gyjz200906004
[13]	Hao Jiping, Fan Jinkai, Wang Xiantie, Ta Yanyan, Wei Peng. CALCULATION INVESTIGATION OF LOCAL BUCKLING STABILITY FOR AXIALLY COMPRESSED SINGLE EQUAL LEG ANGLE MEMBERS[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(6): 22-24. doi: 10.13204/j.gyjz200906005
[14]	Ji Jing, Zheng Wenzhong. EXPERIMENTAL RESEARCH ON FLEXURAL MECHANICAL BEHAVIOR OF ANGLE-STEEL CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(8): 67-72. doi: 10.13204/j.gyjz200808018
[15]	Song Linhui, Mei Guoxiong, Zai Jinmin, Cui Xiaodong. MECHANICAL ANALYSIS OF RETAINING STRUCTURE CONSIDERING DEFORMATION AND ITS APPLICATION[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(7): 53-57. doi: 10.13204/j.gyjz200707016
[16]	Fu Guang-yao. ANALYSIS OF THE STRESS AND DEFLECTION OF A MULTI-SPAN LIGHT GAUGE STEEL FLOORCONTINUOUS MAIN-BEAM WITH TESTING AND THEORETICAL METHODS[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(4): 85-87. doi: 10.13204/j.gyjz200604026
[17]	Qian Peng, Ye Lieping, Weng Guanqun. EXPERIMENTAL STUDY ON CFRP TUBES UNDER UNIAXIAL LOADING[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(4): 11-14,4. doi: 10.13204/j.gyjz200404003