STUDY ON APPLICATION OF SPECIAL-SHAPED COLUMNS TO BUILDINGS WITH SEISMIC FORTIFICATION INTENSITY 8

Qian Jiaru; Li Gengqin

doi:10.13204/j.gyjz200402010

Volume 34 Issue 2

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2004 > 34(2): 28-32

Qian Jiaru, Li Gengqin. STUDY ON APPLICATION OF SPECIAL-SHAPED COLUMNS TO BUILDINGS WITH SEISMIC FORTIFICATION INTENSITY 8[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(2): 28-32. doi: 10.13204/j.gyjz200402010

Citation:

Qian Jiaru, Li Gengqin. STUDY ON APPLICATION OF SPECIAL-SHAPED COLUMNS TO BUILDINGS WITH SEISMIC FORTIFICATION INTENSITY 8[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(2): 28-32. doi: 10.13204/j.gyjz200402010

Citation:

PDF( 0 KB)

STUDY ON APPLICATION OF SPECIAL-SHAPED COLUMNS TO BUILDINGS WITH SEISMIC FORTIFICATION INTENSITY 8

doi: 10.13204/j.gyjz200402010

1.
Tsinghua University Beijing 100084

Received Date: 2003-04-07
Publish Date: 2004-02-20

Abstract

Abstract

By elastoplastic time history analysis of reinforced concrete frame structures and frame shear wall structures with special shaped columns, and by summarizing the experimental results of special shaped columns and frames with special shaped columns, the application of special shaped columns to buildings with seismic fortification intensity 8 was studied and the design recommendations are presented.
- special-shaped column,
- frame,
- frame-shear wall,
- seismic design

FullText(HTML)

References(13)

References

[2] GB50010-2002 混凝土结构设计规范.189～197

DB29-16-98 大开间住宅钢筋混凝土异形柱框轻结构技术规程.10～32

[3] GB50011-2001 建筑抗震设计规范.56～60

[4] Kangning Li.3-Dimensional Nonlinear Static/Dynamic Structural Analysis Computer Program CANNY 99.Technical Manual, 1996

[5] 刘超.钢筋混凝土L形截面双向压弯构件正截面强度、延性的试验及理论研究:[硕士学位论文].天津:天津大学, 1994.3～22

[6] 钟剑霞.双向压弯钢筋混凝土异形柱抗震性能的试验及理论研究:[硕士学位论文].北京:清华大学, 2001.5～22

[7] 曹万林, 王光远, 等.不同方向周期反复荷载作用下L形柱的性能.地震工程与工程振动, 1995, 15(1):69～72

[8] 曹万林, 王光远, 等.不同方向周期反复荷载作用下T形柱的性能.地震工程与工程振动, 1995, 15(4):76～83

[9] 曹万林, 王光远, 等.周期反复荷载作用下钢筋混凝土十字形柱的性能.地震工程与工程振动, 1994, 14(3):60～67

[10] 曹万林, 胡国振, 等.较小剪跨比带暗柱十字形柱抗震性能试验研究.地震工程与工程振动, 1999, 19(3):54～58

[11] 刘进军, 吕志涛, 等.9层(带转换层)钢筋混凝土异形柱框架结构模型振动台试验研究.建筑结构学报, 2002, 23(1):21～26

[12] 王滋军, 等.中高层大开间钢筋混凝土异形柱框架结构抗震性能研究.地震工程与工程振动, 1999, 19(3):59～64

[13] 曹万林, 等.轻质填充墙异形柱框架抗震性能试验分析.工程力学, 1993(增刊):474～478

Relative Articles

[1]	Ding Hongyan, Yang Baokun, Zhang Puyang, Qiao Shuai. EXPERIMENTAL RESEARCH ON SEISMIC PERFORMANCE OF STORY-ADDED REINFORCED CONCRETE FRAME[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(5): 49-54. doi: 10.13204/j.gyjz201505012
[2]	Huang Wei, Zhang Min, Zhang Chenghua, Jiang Xiaoping, Hou Lina. STUDY OF METHOD OF DISPLACEMENT-BASED SEISMIC DESIGN OF MULTI-LAYER ECOLOGICAL COMPOSITE WALL STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(09): 68-73.
[3]	Li Yanyan, Chen Yanfeng, Zhang Xuehui. SEISMIC PERFORMANCE EXPERIMENTAL RESEARCH ON STEEL AND POLYPROPYLENE FIBER REINFORCED SPECIAL-SHAPED COLUMN EDGE NODE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(07): 21-24.
[4]	Liu Ping, Li Yanyan, Chen Yanfeng, Xu Liying. EXPERIMENTAL RESEARCH ON SEISMIC BEHAVIOR OF HIGH STRENGTH REINFORCEMENT CONCRETE SPECIALLY SHAPED COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(6): 52-55. doi: 10.13204/j.gyjz201306012
[5]	Li Yanyan, Wang Meng, Zhang Jianxin, Liu Kun. EFFECT OF AXIAL COMPRESSION RATIO ON SEISMIC BEHAVIOR OF SPECIALLY SHAPED COLUMNS WITH HIGH STRENGTH STEEL BARS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(4): 62-65. doi: 10.13204/j.gyjz201304013
[6]	Hu Bo, Liu Bingkang, Wang Chenggang, Yu Chao. EXPERIMENTAL STUDY ON SEISMIC PERFORMANCES OF A TWO-STOREY REINFORCED RECYCLED AGGREGATES CONCRETE FRAME UNDER LOW-CYCLE REPEATED LOAD[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 53-58. doi: 10.13204/j.gyjz201309010
[7]	Rong Xian, Zhang Jianxin, Li Yanjun, Li Yanyan. EXPERIMENTAL RESEARCH ON MECHANICAL BEHAVIOR OF INTERIOR JOINTS OF SPECIALLY SHAPED COLUMN FRAMES REINFORCED BY STEEL FIBER[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(5): 47-51. doi: 10.13204/j.gyjz201305011
[8]	Li Junfeng, Xu Yan, Yang Xiaodong. OPTIMIZATION DESIGN OF HIGH-RISE SHEAR WALL STRUCTURE WITH STAGGERED STORIES[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(12): 151-155. doi: 10.13204/j.gyjz201212033
[9]	Chen Lin-zhi, Feng Yuan. INFLUENCE OF RIGID ZONE SETTING FOR BEAMS AND COLUMNS ON SEISMIC PERFORMANCE OF REINFORCED CONRETE FRAME STRUCTURES[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(9): 75-78. doi: 10.13204/j.gyjz201209017
[10]	Zhao Yuxing, Yang Qing, Li Liyong. SEISMIC DESIGN BY SEMI-SLIP-SUPPORTED STAIRS FOR REASONABLE STRUCTURAL SYSTEM OF THE FRAME BUILDING[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(1): 94-97,148. doi: 10.13204/j.gyjz201201018
[11]	Liu Chunyang, Li Zhenbao, Ma Hua, Han Jianqiang. EXPERIMENT STUDY ON ASEISMIC BEHAVIOR OF RC FRAME SPACE JOINTS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(6): 67-70. doi: 10.13204/j.gyjz201106014
[12]	Wang Tiecheng, Zhang Xuehui, Zhao Hailong, Qi Jianwei. EXPERIMENTAL RESEARCH ON SEISMIC BEHAVIOR OF EXTERIOR JOINTS WITH SPECIALLY SHAPED COLUMNS REINFORCED BY FIBER[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(1): 46-50,72. doi: 10.13204/j.gyjz201001013
[13]	Han Jianqiang, Li Zhenbao, Song Jia, Liu Chunyang. STUDY ON SEISMIC PERFORMANCE OF PRECAST PRESTRESSED REINFORCED CONCRETE FRAME STRUCTURE[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(5): 47-50. doi: 10.13204/j.gyjz201005009
[14]	Ding Xiaoling. THE SEISMIC ANALYSIS OF AN IRREGULAR-SHAPED PILLAR FRAMEWORK OF REINFORCED CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(5): 51-54. doi: 10.13204/j.gyjz201005010
[15]	Han Jianqiang, Li Zhenbao, Song Xiaosheng. A NEW TYPE OF CONNECTION FOR ASSEMBLING CONCRETE FRAME:STUDY ON PRESTRESSED ASSEMBLING FRAME STRUCTURES CONSTRUCTION[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(11): 100-103. doi: 10.13204/j.gyjz200911023
[16]	Wang Weihua, Tao Zhong. TESTS ON TEMPERATURE FIELDS OF CONCRETE-FILLED STEEL TUBULAR COLUMN TO REINFORCED CONCRETE BEAM FRAMES UNDER FIRE[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(4): 18-21. doi: 10.13204/j.gyjz200904005
[17]	Luo Youxin, Diao Bo, Li Shuchun, Hao Zhihong. REPETITIVE LOADING TEST OF RC FRAME STRUCTURES WITH SPECIAL SHAPED COLUMNS AND NUMERICAL SIMULATION[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(8): 46-49,82. doi: 10.13204/j.gyjz200808013
[18]	Mao Xiaoyong, Xiao Yan. DISPLACEMENT-BASED SEISMIC DESIGN OF CIRCULAR CFT COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(8): 28-30. doi: 10.13204/j.gyjz200708008
[19]	Chong Xun, Meng Shao-ping, Pan Qi-jian, Zhang Lin-zhen. STUDY ON FORM AND DESIGN APPROACH OF PRECAST PRESTRESSED CONCRETE FRAMES[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(5): 5-7. doi: 10.13204/j.gyjz200605002
[20]	Wang Fa-wu, Tang Gan, Yang Jie. OPTIMAL LATERAL DEFLECTION DESIGN OF TALL BUILDINGS OF FRAMES AND SHEAR WALLS[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(6): 38-42. doi: 10.13204/j.gyjz200606013