MECHANICAL PROPERTIES OF ECOLOGICAL REACTIVE POWDER CONCRETE UNDER UNIAXIAL COMPRESSION

Jiao Chujie; Sun Wei; Lai Jianzhong; Jiang Jinyang

doi:10.13204/j.gyjz200401017

Volume 34 Issue 1

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2004 > 34(1): 60-62

Jiao Chujie, Sun Wei, Lai Jianzhong, Jiang Jinyang. MECHANICAL PROPERTIES OF ECOLOGICAL REACTIVE POWDER CONCRETE UNDER UNIAXIAL COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(1): 60-62. doi: 10.13204/j.gyjz200401017

Citation:

Jiao Chujie, Sun Wei, Lai Jianzhong, Jiang Jinyang. MECHANICAL PROPERTIES OF ECOLOGICAL REACTIVE POWDER CONCRETE UNDER UNIAXIAL COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(1): 60-62. doi: 10.13204/j.gyjz200401017

Citation:

PDF( 0 KB)

MECHANICAL PROPERTIES OF ECOLOGICAL REACTIVE POWDER CONCRETE UNDER UNIAXIAL COMPRESSION

doi: 10.13204/j.gyjz200401017

1.
Department of Materials and Engineering,Southeast University Nanjing 210096

Received Date: 2003-07-20
Publish Date: 2004-01-20

Abstract

Abstract

Based on the experiments, this paper systematically studied the quasi-static mechanical properties of ecological reactive powder concrete(ECO-RPC) with different fiber volume fractions( V f) under uniaxial compression with two strain rates.The experimental results showed that the adding of steel fiber into the ECO-RPC matrix led to not only further strengthening but also remarkably toughening and crack arresting of the composites, and the destruction pattern of ECO-RPC was changed from brittleness to pseudo plasticity.With the increase of the V f, the elastic modulus and Poisson's ratio of ECO-RPC were changed only a little.It was also found that the stress-strain curves of the same mix proportion of ECO-RPC with different strain rate were somewhat similar, with the strength and the peak strain increased but the toughness decreased when the strain rate increased, and the toughness of ECO-RPC matrix decreased more than those of steel fiber reinforced ECO-RPC.
- ecological reactive powder concrete( ECO- RPC),
- steel fiber,
- quasi-static uniaxial,
- compression strengthening,
- toughening,
- crack arresting,
- elastic modulus,
- Poisson' s ratio,

FullText(HTML)

References(15)

References

Pierre Richard, Marcel Cheyrezy.Composition of Reactive Powder Concretes.Cement and Concrete Research, 1995, 25(7):1501～1511

[2] Oliver Bonneau, Cloude Poulin, et al.Reactive Powder Concrete, from Theory to Practice.Concrete International, 1996, 18(4):47～49

[3] Oliver B, Lachemi M.Mechanical Properties and Durability of Tow Industrial Reactive Powder Concrete.ACI Materials Journal, 1997, 94(4):286～290

[4] 孙伟, 刘斯凤, 赖建中, 等.超高性能绿色活性粉末混凝土性能的研究.水利学报, 2002(增刊):10～14

[5] 刘斯凤, 孙伟, 张云升, 等.新型超高性能混凝土的力学性能研究及工程应用.工业建筑, 2002(6):1～3

[6] 中国工程建设标准化协会.钢纤维混凝土试验方法.北京:中国计划出版社, 1996.50～53

[7] 过镇海.混凝土的强度和变形:试验基础和本构关系.北京:清华大学出版社, 1997.13～15

[8] 程庆国, 高路彬, 徐蕴贤, 等.钢纤维混凝土理论及应用.北京:中国铁道出版社, 1999.50～54

[9] 安明哲, 王庆生, 丁建彤.活性粉末混凝土的配制原理及应用前景.建筑技术, 2002(1):15～16

[10] Romnaldi J P, Mandel J A.Tensile Strength of Concrete Affected by Uniformly Dispersed and Closely Spaced Short Length of Wire Reinforcement.Journal of American Concrete Institute, 1964(2):657～672

[11] 董毓利.混凝土非线性力学基础.北京:中国建筑工业出版社, 1997

[12] 中国土木工程学会高强混凝土委员会.高强混凝土结构设计与施工指南*第二版.北京:建筑工业出版社, 2001

[13] GB50010-2002 混凝土结构设计规范

[14] 吕德生, 汤骅.高强混凝土弹性模量与抗压强度的相关性试验研究.混凝土与水泥制品, 2001(6):20～21

[15] Stphanie Staquet, Bernard Espion.Influence of Cement and Silica Fume Type on Compressive Strength of Reactive Powder Concrete.In:Leung Christopher K Y, Li Zongjin, Ding Jiantong.High Performance Concrete-Workbility, Strength and Durability(2).Hong Kong:The Hong Kong University of Science and Technology, 2000

Relative Articles

[1]	LU Li, HE Mingli, LI Haiyan, CHEN Wei, LI Huawei, XIONG Zhe, FENG Pandeng, LIU Feng. Research on Fracture Properties of Rubber Concrete Containing Steel Fibers and Glass Fibers[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(12): 216-221. doi: 10.13204/j.gyjzG23092609
[2]	LI Xiaohui, LI Lijuan, LI Yanlong, LU Junjie, ZHAO Zhongyu, ZHENG Yingming, LIU Feng, ZHONG Genquan. Research on Mechanical Properties of Hybrid Fibers Reinforced Rubber Concrete[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(10): 135-142. doi: 10.13204/j.gyjzG23050809
[3]	ZHAO Xiumin, YANG Haifeng, LI Xueliang, YANG Peng, LI Bingsu. STUDY ON STATIC AND DYNAMIC IMPACT PROPERTIES OF STEEL-FIBER REINFORCED RUBBER CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(8): 173-178. doi: 10.13204/j.gyjzG20070301
[4]	Rong Xian, Zhang Jianxin, Li Yanjun, Li Yanyan. EXPERIMENTAL RESEARCH ON MECHANICAL BEHAVIOR OF INTERIOR JOINTS OF SPECIALLY SHAPED COLUMN FRAMES REINFORCED BY STEEL FIBER[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(5): 47-51. doi: 10.13204/j.gyjz201305011
[5]	Yang Jianhui, Li Yanfei, Ding Peng, Zhao Hongbing. EXPERIMENTAL STUDY ON MECHANICAL PROPERTIES OF HYBRID FIBERS REINFORCED SHOTCRETE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(8): 101-105. doi: 10.13204/j.gyjz201308022
[6]	Huang Wei, Zhang Li, Wu Mingchao. EXPERIMENTAL INVESTIGATION ON FLEXURAL BAHAVIOR OF STEEL FIBER RC BEAMS WITH GRADE HRB500 REINFORCEMENT OF LOW-COST AND HIGH-PERFORMANCE[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(11): 76-80. doi: 10.13204/j.gyjz201111016
[7]	Tian He, Ding Yining, De Rivaz Benoit. EXPERIMENTAL STUDY ON THE MECHANIC BEHAVIOR OF STEEL FIBRE AND PP-FIBRE REINFORCED CONCRETE NOTCHED PANELS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(2): 70-73,77. doi: 10.13204/j.gyjz201102018
[8]	Zeng Zhixing, Wu Xiaobin. EXPERIMENTAL RESEARCH ONMECHANICAL PERFORMANCE OF STEEL FIBER REINFORCED HAYDITE CONCRETE AFTER CARBONIZATION[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(1): 93-96. doi: 10.13204/j.gyjz200901020
[9]	Xie Xiaopeng, Gao Danying, Guan Qiaoyan. RESEARCH ON LOCAL STEEL FIBER HIGH-STRENGTH REINFORCED CONCRETE SLABS SUBJECTED TO PUNCHING SHEAR[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(6): 96-100. doi: 10.13204/j.gyjz200906023
[10]	Tian Ruijun, Du Xiuli, Peng Yijiang. NUMERICAL SIMULATION ON COMPRESSION FAILURE PROCESS OF CONCRETE AND SIZE EFFECT[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(4): 68-72112. doi: 10.13204/j.gyjz200804018
[11]	Wu Zhuanqin, Fan Yunyun, Liu Jingliang, Liu Gang. STUDY ON MECHANICAL PROPERTIES OF ADHESIVE MATERIALS FOR RETARD-BONDED PRESTRESSING STRAND[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(11): 9-12,35. doi: 10.13204/j.gyjz200811003
[12]	Huo Jun-fang. STUDY ON THE MECHANICAL PROPERTIES OF LIGHTWEIGHT AGGREGATE CONCRETE IMPROVED BY STEEL FIBERSMETHOD[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(12): 96-99. doi: 10.13204/j.gyjz200712023
[13]	Lian Jie, Yang Yongxin, Yang Meng, Zhao Yan. EXPERIMENTAL RESEARCH ON THE MECHANICAL BEHAVIOR OF CHOPPED BASALT FIBER REINFORCED CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(6): 8-10. doi: 10.13204/j.gyjz200706003
[14]	Wang Cheng-qi. EFFECTOF STEEL FIBER TYPE ON CONCRETE BENDING PROPERTIES[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(11): 74-76,114. doi: 10.13204/j.gyjz200711020
[15]	Zhao Jun, Liu Jing-yuan, Ma Zhi-ying. EXPERIMENTAL STUDY ON STRENGTHS OF STEEL FIBER REINFORCED CONCRETE WITH EARLY-AGE LOADING HISTORY[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(8): 45-49. doi: 10.13204/j.gyjz200608015
[16]	Gao Dan-ying, Xie Xiao-peng. PERFORMANCE OF STEEL FIBER REINFORCED CONCRETE UNDER THE ACTION OF FREEZE-THAW CIRCULATION[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(10): 65-68. doi: 10.13204/j.gyjz200610018
[17]	Song Xiaoruan, Zhang Yankun, Si Jian. CALCULATION OF YOUNG'S MODULUS FOR LYTAG CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(2): 61-63. doi: 10.13204/j.gyjz200602018
[18]	Liu Shuguang, Huang Chengkui, Wang Qingxiang, Zhao Guofan. EXPERIMENTAL INVESTIGATION OF UNIAXIAL COMPRESSIVE CHARACTERISTICS OF STEEL FIBER IMPROVED HIGH-STRENGTH CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(11): 78-80. doi: 10.13204/j.gyjz200511023
[19]	Sun Daosheng, Deng Min, Tang Mingshu, Huang Xiaoming, Tan Maiqiu. STUDY ON THE ANTI-CRACKING AND IMPERMEABILITY PROPERTIES OFPOLYPROPYLENE FIBER REINFORCED EXPANSIVE CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(3): 49-51,64. doi: 10.13204/j.gyjz200403015
[20]	Gao Danying, Tang Jiyu, Zhao Jun. A EXPERIMENTAL STUDY ON ELASTIC MODULUS OF FIBER REINFORCED HIGH-STRENGTH CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2004, 34(10): 47-49. doi: 10.13204/j.gyjz200410014