SIMULATION EXPERIMENT STUDY ON A CANTILEVER BEAM BASED ON TRANSMISSIBILITY

Wei Zhuobing; Wu Sen; Zhang Ning

doi:10.13204/j.gyjz201302029

Volume 43 Issue 2

Dec. 2014

Turn off MathJax

Article Contents

Article Navigation > INDUSTRIAL CONSTRUCTION > 2013 > 43(2): 143-147

Wei Zhuobing, Wu Sen, Zhang Ning. SIMULATION EXPERIMENT STUDY ON A CANTILEVER BEAM BASED ON TRANSMISSIBILITY[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(2): 143-147. doi: 10.13204/j.gyjz201302029

Citation:

Wei Zhuobing, Wu Sen, Zhang Ning. SIMULATION EXPERIMENT STUDY ON A CANTILEVER BEAM BASED ON TRANSMISSIBILITY[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(2): 143-147. doi: 10.13204/j.gyjz201302029

Wei Zhuobing, Wu Sen, Zhang Ning. SIMULATION EXPERIMENT STUDY ON A CANTILEVER BEAM BASED ON TRANSMISSIBILITY[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(2): 143-147. doi: 10.13204/j.gyjz201302029

Citation:

Wei Zhuobing, Wu Sen, Zhang Ning. SIMULATION EXPERIMENT STUDY ON A CANTILEVER BEAM BASED ON TRANSMISSIBILITY[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(2): 143-147. doi: 10.13204/j.gyjz201302029

PDF( 0 KB)

SIMULATION EXPERIMENT STUDY ON A CANTILEVER BEAM BASED ON TRANSMISSIBILITY

doi: 10.13204/j.gyjz201302029

1.
College of Service,Naval Univ.of Engineering,Tianjin 300450,China

Received Date: 2011-04-22
Publish Date: 2013-02-20

Abstract

Abstract

For studying the feasibility of the damage identification method based on vibration transmissibility,various simulation experiments on a cantilever beam were done to study the repeatability,sensitivity for damage,and sensitivity for damage location.The results of the simulation experiments showed that the viration transmissibility was independent of the exciting load,sensitive to damage strongly,and can identify the damage locations.But in comparison with identifying several damage locations,the method could identify single damage location more effectively.
- cantilever beam,
- transmissibility,
- damage Identification

FullText(HTML)

References(7)

References

[2] PARK N G, PARK Y S. Damage Detection Using SpatiallyIncomplete Frequency Response Functions[J]. MechanicalSystems and Signal Processing,2003,17(3):519-532.

SAMPAIO R P C, MAIA N M. Damage Detection Using theFrequency-Response-Function Curvature Method[J]. Journal ofSound and Vibration,1999,226(5):1029-1042.

[3] 杨彦芳.基于频响函数的网架结构损伤诊断方法研究[D].大连:大连理工大学,2008.

[4] G. Manson, K. Worden. Experimental Validation of A StructuralHealth Monitoring Methodology: Part III. Damage Location on AnAircraft Wing[J]. Journal of Sound and Vibration,2003,259(2):365-385.

[5] Zhang H, Schulz M J, Ferguson F. Structural Health MonitoringUsing Transmittance Functions[J]. Mechanical Systems andSignal Processing,1999,13(5):765-787.

[6] 张启伟.桥梁健康监测中的损伤特征提取与异常诊断[J].同济大学学报,2003,31(3):258-262.

[7] 李德葆,陆秋海.工程振动试验分析[M].北京:清华大学出版社,2004.

Relative Articles

Supplements(0)

Cited By

Proportional views