COLLAPSING REASONS ANALYSIS OF THE WALL OF A RECTANGULAR RC CONTACT OXIDATION TANK

Huang Pin; He Yibin; Li Yan; Leng Qiaojuan; Guo Jian

doi:10.13204/j.gyjz201108030

Volume 41 Issue 8

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2011 > 41(8): 126-129

Gao Xiaojian, Ba Hengjing, Ma Baoguo. THE RELATIONSHIP AMONG CEMENT HYDRATION DEGREE, COMPRESSIVE STRENGTH AND AUTOGENOUS SHRINKAGE OF CONCRETE AT EARLY AGES[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(2): 64-67. doi: 10.13204/j.gyjz200602019

Citation:

Huang Pin, He Yibin, Li Yan, Leng Qiaojuan, Guo Jian. COLLAPSING REASONS ANALYSIS OF THE WALL OF A RECTANGULAR RC CONTACT OXIDATION TANK[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(8): 126-129. doi: 10.13204/j.gyjz201108030

Citation:

PDF( 0 KB)

COLLAPSING REASONS ANALYSIS OF THE WALL OF A RECTANGULAR RC CONTACT OXIDATION TANK

doi: 10.13204/j.gyjz201108030

1.
1. College of Civil Engineering,Hunan University,Changsha 410082,China;
2.
2. College of Civil Engineering,Tongji University,Shanghai 200092,China;
3.
3. Institute of Design and Research,Hunan Vniversity,Changsha 410082,China

Received Date: 2010-07-21
Publish Date: 2011-08-20

Abstract

Abstract

In order to analyze the collapsing reasons,the design and construction of a rectangular RC contact oxidation tank are discussed.According to on-site detecting and design recheck,the results can be obtained as follows: the construction quality is favorable,which can satisfy the design and acceptance requirements.But there is serious shortage in design aspect.The wall's local negative moment in horizontal direction and the maximum negative moment in bottom side are too large than the calculative resistance.Under the lateral pressure of water,the plastic hinge line will occur in corresponding position of the wall,so that the support condition is changed,which leads to the collapse of the wall.
- contact oxidation tank,
- tank wall,
- resistance,
- collapse,
- reason analysis

FullText(HTML)

References(0)

References

Relative Articles

[1]	ZHAO Muzi, XU Chengyan, WANG Yuyin, GENG Yue, GONG Chao. Dilation Ratio and Modeling of Recycled Aggregate Concrete[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(10): 143-150,82. doi: 10.13204/j.gyjzG23051513
[2]	YU Zheng, SUN Hongyang, WANG Lijun. SEISMIC PERFORMANCES OF SINGLE-STORY INDUSTRIAL FACTORY BUILDINGS UNDER ELASTIC STRUCTURE DESIGN[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(12): 55-63. doi: 10.13204/j.gyjz201907170003
[3]	DANG Yujing. A DISCUSSION ON THE ADJUSTMENT FACTOR OF SEISMIC BEARING CAPACITY FOR CFG-PILE COMPOSITE FOUNDATION[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(11): 97-101. doi: 10.13204/j.gyjzG19090330
[5]	Song Yupu, Zhang Xiaoli. INFLUENCE OF STRAIN RATE ON EARTHQUAKE RESISTANCE EFFECT OF REINFORCED CONCRETE SHEAR WALL[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(3): 7-11,6. doi: 10.13204/j.gyjz201203002
[6]	Zhang Chunming. REGULATION OF "THE CODE FOR ASEISMIC DESIGN OF BUILDINGS"(2008 EDITION)[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(10): 136-140. doi: 10.13204/j.gyjz200910030
[7]	Peng Lingyun, Yan Weiming, Wu Honglei, Cao Qiang. DISCUSSION ON THE INTERNAL FORCE ADJUSTION IN SEISMIC DESIGN OF MAIN BUILDINGS FOR THERMOELECTRICAL POWER PLANT WITHOUT SHEAR WALL IN TRANSVERSE DIRECTION[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(7): 16-18,29. doi: 10.13204/j.gyjz200807004
[8]	Jiang Lizhong, Zou Fei, Qi Jingjing, Yu Zhiwu. THE INFLUENCE OF HORIZONTAL RElNFORCEMENT RATIO ON SEISMIC BEHAVIOR OF STEEL CONCRETE BEAM[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(8): 1-4,13. doi: 10.13204/j.gyjz200708001
[9]	Wang Shiying, Wang Xiaoping. BEARING CAPACITY RESEARCH ON ARCHED CORRUGATED STEEL ROOF WITH UNEQUAL ALTITUDE SUPPORT[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(5): 100-102. doi: 10.13204/j.gyjz200705025