EXPERIMENTAL STUDY AND FINITE ELEMENT ANALYSIS OF BRICK WALL STRENGTHENED BY CFRP

Yang Zhao; Dai Shaobin

doi:10.13204/j.gyjz200905028

Volume 39 Issue 5

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2009 > 39(5): 124-127

Wang Tianfeng. EXPERIMENT ON THE EFFECTS OF STEEL FIBERS ON THE FLEXURAL TOUGHNESS AND FRACTURE ENERGY OF HIGH-PERFORMANCE CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(5): 65-68. doi: 10.13204/j.gyjz200705017

Citation:

Yang Zhao, Dai Shaobin. EXPERIMENTAL STUDY AND FINITE ELEMENT ANALYSIS OF BRICK WALL STRENGTHENED BY CFRP[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(5): 124-127. doi: 10.13204/j.gyjz200905028

Citation:

Yang Zhao, Dai Shaobin. EXPERIMENTAL STUDY AND FINITE ELEMENT ANALYSIS OF BRICK WALL STRENGTHENED BY CFRP[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(5): 124-127. doi: 10.13204/j.gyjz200905028

PDF( 0 KB)

EXPERIMENTAL STUDY AND FINITE ELEMENT ANALYSIS OF BRICK WALL STRENGTHENED BY CFRP

doi: 10.13204/j.gyjz200905028

Yang Zhao¹,
Dai Shaobin²

1.
1. Institute of Urbun Construction,Wuhan University of Science and Technology,Wuhan 430070,China;
2.
2. The Design and Research Institute of Wuhan University of Technology,Wuhan 430070,China

Received Date: 2008-06-25
Publish Date: 2009-05-20

Abstract

Abstract

Based on the experiment on seismic reinforcement of brick walls with a window strengthened by CFRP under lower cycle reversal loads and the finite element analysis,the seismic reinforcement effectiveness is studied through the comparison of the data on the wall before and after being strengthening,and the different effect of different strengthening ways was compared as well.The study shows that the strengthening effect is obvious.
- CFRP,
- brick wall,
- seismic reinforcemen,t finite element,

FullText(HTML)

References(9)

References

CECS 146:2003碳纤维片材加固混凝土结构技术规程[S];

[2] 赵彤,张晨军,谢剑,等.碳纤维布用于砖砌体抗震加固的试验研究[J].地震工程与震动控制,2001,21(2):89-95;

[3] 张祥顺,谷倩,管克俭,等.碳纤维布加固砌体结构试验研究[J].武汉理工大学学报,2002,24(11):29-32;

[4] 黄小奎,崔凯成,熊丹安.碳纤维布加固梁柱节点试验研究[J].武汉理工大学学报,2004,26(2):30-33;

[5] GB 500032001砌体结构设计规范[S];

[6] JGJ 10196建筑抗震实验方法规程[S];

[7] 朱伯龙.砌体结构设计原理[M].上海:同济大学出版社,1991;

[8] ANSYS,Inc.ANSYS Theory Reference[M].Cali Fornia:Sun-Microsystems,Inc,2000;

[9] 王国强.实用工程数值模拟技术及其在ANSYS上的实践[M].西安:西北工业大学出版社,2001.

Relative Articles

[1]	XU Jimin, XING Kuntao, GAO Xiangyu, GUO Xiaohua, WANG Ling. DEGRADATION LAWS OF MECHANICAL PROPERTIES FOR PROFILED STEEL SHEETS IN ACCELERATED CORROSION ENVIRONMENTS[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(1): 163-168. doi: 10.13204/j.gyjzG201908130001
[2]	ZHANG Xingshuai, WU Yaohua. COMPARATIVE ANALYSIS OF STRUCTURAL REQUIREMENTS FOR DEFORMATION AND OVERLAP FOR PROFILED STEEL SHEET BY CHINESE, AMERICAN AND EUROPEAN STANDARDS[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(2): 158-162,136. doi: 10.13204/j.gyjz202002024
[4]	Sun Defa. ANALYSIS OF EFFECTIVE SECTION OF COLD-FORMED THIN-WALL LIPPED CHANNEL PURLINS[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(2): 131-135. doi: 10.13204/j.gyjz201502027
[5]	Tong Genshu, Xu Yuanjie, Zhang Lei. ANALYSIS OF GLOBAL STABILITY OF C-PURLINS UNDER WIND SUCTION[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(12): 34-37,11. doi: 10.13204/j.gyjz201312005
[6]	Tong Genshu, Xu Yuanjie, Zhang Lei. ANALYSIS OF GLOBAL STABILITY OF COLD-FORMED Z PURLINS UNDER WIND SUCTION[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(12): 26-33. doi: 10.13204/j.gyjz201312004
[7]	Tong Genshu. EFFICIENCY OF SAG RODS AS LATERAL SUPPORTS FOR STABILITY OF PURLINS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(12): 52-56,65. doi: 10.13204/j.gyjz201312008
[8]	Tong Genshu, Wu Qiang, Zhang Lei. BENDING AND TWISTING ABOUT A CONSTRAINED AXIS OF Z-SECTION PURLINS WITH ONE SAG ROD AT MIDSPAN[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(12): 1-11. doi: 10.13204/j.gyjz201312001
[9]	Tong Genshu, Wu Qiang, Zhang Lei. BENDING AND TWISTING ABOUT A CONSTRAINED AXIS OF C-SECTION PURLINS WITH ONE SAG ROD AT MIDSPAN[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(12): 12-20. doi: 10.13204/j.gyjz201312002
[10]	Wu Qiang, Tong Genshu, Zhang Lei. ANALYSIS OF TWISTING ABOUT UPPER FLANGE OF C-SECTION PURLIN WITH TWO SAG RODS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(12): 21-25. doi: 10.13204/j.gyjz201312003
[11]	Du Huilin, Tong Genshu, Song Changyong, Zhang Lei. TORSIONAL RESTRAINTS OF CORRUGATED SHEETING TO PURLIN THROUGH SLIPPABLE CLIPS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(4): 34-41. doi: 10.13204/j.gyjz201304007
[12]	Tong Genshu, Wu Qiang. NOTIONAL LOAD ON BOTTOM FLANGE IN STRENGTH CALCULATION OF Z- SHAPED CROSS SECTION PURLIN[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(4): 136-142. doi: 10.13204/j.gyjz201204028
[13]	Nie Shaofeng, Wang Wenke, Zhou Tianhua, He Baokang. STUDY ON MECHANICAL BEHAVIOR OF HIGH STRENGTH COLD-FORMED STEEL CONTINUOUS HAT SECTION PURLIN[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(7): 92-94,91. doi: 10.13204/j.gyjz200907025
[14]	Zhang Yankun, Liu Yanghua, Song Xiaoruan. EXPERIMENTAL STUDY ON FLEXURAL BEARING CAPACITY OF PROFILED STEEL SHEET-LIGHT-WEIGHT AGGREGATE CONCRETE FLOOR SLABS[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(8): 83-85. doi: 10.13204/j.gyjz200808021
[15]	Liu Yang, Zhang Qilin. EXPERIMENT AND FEM ANALYSIS ON THE SHEAR BEHAVIORS OF PROFILED METAL SHEETS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(10): 88-92. doi: 10.13204/j.gyjz200710024
[16]	Han Jinsheng, Cheng Wenrang, Xu Zhaodong, Dong Yuli, Lv Junli. EXPERIMENTAL STUDY ON THE BEHAVIORS OF PROFILED STEEL SHEETING_CONCRETE COMPOSITE SLABS UNDER FIRE[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(3): 87-90. doi: 10.13204/j.gyjz200603023
[17]	Long Liping, Gu Hongyan, Cui Jia. STATIC BEHAVIOR OF STRESSED SKIN DIAPHRAGM CONNECTED WITH V840 PROFILED SHEET[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(6): 84-85,83. doi: 10.13204/j.gyjz200506024