THEORETICAL ANALYSIS ON BOND-SLIP CONSTITUTIVE RELATION OF PUSHING AND PULL MEMBER ON STEEL AND CONCRETE INTERFACE IN SRC STRUCTURES

Liu Junling; Liang Bin; Hu Jun

doi:10.13204/j.gyjz200805022

Volume 38 Issue 5

Dec. 2014

Turn off MathJax

Article Contents

Article Navigation > INDUSTRIAL CONSTRUCTION > 2008 > 38(5): 93-95,108

Liu Junling, Liang Bin, Hu Jun. THEORETICAL ANALYSIS ON BOND-SLIP CONSTITUTIVE RELATION OF PUSHING AND PULL MEMBER ON STEEL AND CONCRETE INTERFACE IN SRC STRUCTURES[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(5): 93-95,108. doi: 10.13204/j.gyjz200805022

Citation:

Liu Junling, Liang Bin, Hu Jun. THEORETICAL ANALYSIS ON BOND-SLIP CONSTITUTIVE RELATION OF PUSHING AND PULL MEMBER ON STEEL AND CONCRETE INTERFACE IN SRC STRUCTURES[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(5): 93-95,108. doi: 10.13204/j.gyjz200805022

Citation:

PDF( 0 KB)

THEORETICAL ANALYSIS ON BOND-SLIP CONSTITUTIVE RELATION OF PUSHING AND PULL MEMBER ON STEEL AND CONCRETE INTERFACE IN SRC STRUCTURES

doi: 10.13204/j.gyjz200805022

1.
1. College of Architecture and Engineering,Henan University of Science and Technology,Luoyang 471003;
2.
2. International Engineering Co.,Ltd,No.10 Institute of China Machinery Industry,Luoyang 471039

Received Date: 2007-12-20
Publish Date: 2008-05-20

Abstract

Abstract

Based on the former experimental research on bond-slip performance, the constitutive relation of bond-slip on steel and concrete interface in SRC structures has been established. Through analysis of the former experimental researches on bond-slip performance, constitutive relation in different anchor-hold place of push and pull member on steel and concrete interface in SRC structures has been set up according to the conditions of balance and boundary, which lays down an academic foundation for constitutive relation of other SRC members and provides a reference for analyzing the non-linear performance of SRC members using ANSYS.
- steel reinforced concrete structure (SRC),
- bond-slip,
- constitutive relation,
- pushing and pull member

FullText(HTML)

References(10)

References

[2] Bryson J O, Mathey R G. Surface Condit ion Effect on Bond Strength of Steel Beams in Concrete. Journal of ACI, 1962, 59(3) : 397-406

王彦宏, 赵鸿铁, 薛建阳. 型钢混凝土结构粘结强度的研究. 西安建筑科技大学学报, 2004, 36(1) : 16-20

[3] 杨勇, 赵鸿铁, 薛建阳. 型钢混凝土粘结-滑移本构关系理论分析. 工业建筑, 2002, 32(6) : 60-63

[4] 伍文波, 陈海燕, 王真龙. 型钢混凝土粘结滑移本构关系的分析研究. 四川建筑, 2005, 25(2) : 64-65

[5] Charles W Roeder. Composit e and Mixed Construct ion. ASCE, 1985

[6] Charles W Roeder, Robert Chmielowski. Shear Connector Requirements for Embedded Steel Section. Journal of Structural Engineering, 1999,125(2): 142-151

[7] 叶列平, 方鄂华. 钢骨混凝土构件的受力性能研究综述. 土木工程学报, 2000, 33(5) : 1-12

[8] 郑山锁, 杨勇, 薛建阳, 等. 混凝土粘结滑移性能研究. 土木工程学报, 2002, 35(4) : 47-51

[9] 赵鸿铁. 钢与混凝土组合结构. 北京: 科学出版社, 2001

[10] 李红. 型钢与混凝土粘结性能的试验研究: [ 硕士学位论文].西安: 西安建筑科技大学, 1995

Relative Articles

Supplements(0)

Cited By

Proportional views