BENDING BEAM ANALYSIS FOR REINFORCED CRUMB RUBBER CONCRETE BASED ON STRAIN ENERGY

Yuan Lin; Zhu Han

doi:10.13204/j.gyjz200704010

Volume 37 Issue 4

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2007 > 37(4): 32-36

Xu Xiaobo, Li Yixun. DESIGN AND CONSTRUCTION OF PULLING COLUMN BY LARGE-SPAN BRACKET[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(8): 89-92,85. doi: 10.13204/j.gyjz200708023

Citation:

Yuan Lin, Zhu Han. BENDING BEAM ANALYSIS FOR REINFORCED CRUMB RUBBER CONCRETE BASED ON STRAIN ENERGY[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(4): 32-36. doi: 10.13204/j.gyjz200704010

Xu Xiaobo, Li Yixun. DESIGN AND CONSTRUCTION OF PULLING COLUMN BY LARGE-SPAN BRACKET[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(8): 89-92,85. doi: 10.13204/j.gyjz200708023

Citation:

Yuan Lin, Zhu Han. BENDING BEAM ANALYSIS FOR REINFORCED CRUMB RUBBER CONCRETE BASED ON STRAIN ENERGY[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(4): 32-36. doi: 10.13204/j.gyjz200704010

PDF( 0 KB)

BENDING BEAM ANALYSIS FOR REINFORCED CRUMB RUBBER CONCRETE BASED ON STRAIN ENERGY

doi: 10.13204/j.gyjz200704010

Yuan Lin,
Zhu Han

1.
Civil Engineering Department,Tianjin University Tianjin 300072

Received Date: 2005-12-22
Publish Date: 2007-04-20

Abstract

Abstract

In comparison to controlled concrete, crumb rubber concrete (CRC)exhibits a higher value of strain energy.It is presented a bending analysis of a reinforced beam made with CRC as well as controlled concrete of C-50 and under.It is found that the maximum loading capacity of CRC beam can be expressed by the variable of strain energy in place of the quantity of 28 day maximum concrete compressive strength, which may be used in the current beam design.
- rubber crumbs,
- controlled concrete,
- crumb rubber concrete (CRC),
- reinforced concrete beam

FullText(HTML)

References(11)

References

[2] 朱涵.新型橡胶集料混凝土的研究综述.天津建设科技,2004,14(2):35-37

Han Zhu.Adding Crumb Rubber into Exterior Wall Materials.Waste Management and Research.2003,20:407-413

[3] Han Zhu.Rubber Crumbs in Concrete.Concrete Technology Today.2003,135(8):30-33

[4] Zhu H.Crumb Rubber Concrete,Rapra Handbook on Polymers Use in Construction,edited by Gune Ri AKOVLI,Rapra Technology,Shawbury,SY44NR,UK,2004:234-245

[5] Hernandez Olivares F,Barluenga G,Bollati M,et al.Static and Dynamic Behavor of Recycle Type Rubber-Filled Concrete.Cement and Concrete Research,2002,32(10):1 587-1 596

[6] Xiao C.Engineering Characterization and Field Evaluation for Rubber Concrete.Arizona:Arizona State University,2002

[7] Zhu H.Recent Development in Crumb Rubber Application in Noise Reduction and PCC.The Conference of Crumb Rubber in Road Construction,Dallas,Texas,USA.2002:215-221

[8] Zhu H.New Development in Crumb Rubber Research,First International Symposium on Rubberized Asphalt Pavement,Temqe,AZ.USA.2000:78-81

[9] Schimizze R R,Nelson J K,Amirkhanian S N,et al.New Materials and Methods of Repair.Infrastructure,Proceedings of the Third Material Engineering Conference,San Diego,CA:1994:367-374

[10] 袁琳.橡胶集料钢筋混凝土梁受弯性能初探.混凝土,2005(6):70-76

[11] 程文瀼,康谷贻,颜德姮.混凝土结构.北京:中国建筑工业出版社,2001:62-64

Relative Articles

[1]	Yang Jue, Zheng Qizhen, Han Mingfei. THE INSPECTION AND REINFORCEMENT ON THE STEEL TRUSS OF A BELT TRANSPORT CORRIDOR[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(3): 138-141,124. doi: 10.13204/j.gyjz201303029
[2]	Zhang Kaichen, Wang Feng, Si Bo, Li Ming. DESIGN AND CONSTRUCTION OF THE CORBEL BETWEEN THE OLD COLUMN AND THE NEW BEAM FOR A REFORM PROJECT[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(11): 126-128. doi: 10.13204/j.gyjz200911029
[3]	Yu Guoqin. APPLICATION OF CUTTING COLUMN WITH BEAM SUPPORTED IN THE PROCESS OF TRANSFORMING A SINGLE-STOREY INDUSTRIAL BUILDING[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(4): 113-115108. doi: 10.13204/j.gyjz200804028
[4]	Zhang Su, Tang Qingxuan, Tian Yajun. APPLICATION OF LIFT-UP TECHNOLOGY IN CONSTRUCTION OF INCREASING BEAMS AND REMOVING COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(1): 117-119. doi: 10.13204/j.gyjz200801030
[5]	Hao Ruizhen, Ji Cunde. TECHNICAL REFORM OF ENERGY-SAVING OF APARTMENT BUILDING 6 IN GUANGHUA SCHOOL AREA[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(1): 14-15. doi: 10.13204/j.gyjz200601005
[6]	Bao Xuemei. RENEWAL DESIGN OF INDUSTRIAL ARCHITECTURE[J]. INDUSTRIAL CONSTRUCTION, 2006, 36(3): 1-3. doi: 10.13204/j.gyjz200603001
[7]	Ao Haigen. DESIGN AND CONSTRUCTION OF SUPPORTING BEAM AND REMOVING COLUMN FOR MILL BUILDING WITH REINFORCED CONCRETE BENT FRAME[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(4): 26-27,14. doi: 10.13204/j.gyjz200504008
[8]	Wang Peiqiong, Tang Yuechao, Mao Zhongyi. RESEARCH ON LONGITUDINAL CRACK DAMAGE TO CONCRETE-FILLED STEEL TUBE STRUCTURE AND ITS STRENGTHENING[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(2): 96-97,109. doi: 10.13204/j.gyjz200502026
[9]	Yang Fulei, Xi Zhenyong, Sun Hai. A DESIGN SCHEME OF STRENGTHENING LONG-SPAN RC BEAM WITH DEMOLISHING COLUMN[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(4): 21-23. doi: 10.13204/j.gyjz200504006
[10]	Liu Qingyang, Xu Xiangdong, Cui Qingha, i Zhao Kaozhong, Zhang Xin. THE ACIDIFICATION CORROSION (VITRIOL)OF REINFORCED CONCRETE PROVISION[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(3): 93-94.