STUDY ON FORCED PERFORMANCE TEST OF EDGE JOINTS FOR REINFORCED CONCRETE FLAT BEAMS WITH EDGE BEAM

Guo Jinshi; Yin Xinsheng

doi:10.13204/j.gyjz200510023

Volume 35 Issue 10

Dec. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2005 > 35(10): 76-78

Guo Jinshi, Yin Xinsheng. STUDY ON FORCED PERFORMANCE TEST OF EDGE JOINTS FOR REINFORCED CONCRETE FLAT BEAMS WITH EDGE BEAM[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(10): 76-78. doi: 10.13204/j.gyjz200510023

Citation:

Guo Jinshi, Yin Xinsheng. STUDY ON FORCED PERFORMANCE TEST OF EDGE JOINTS FOR REINFORCED CONCRETE FLAT BEAMS WITH EDGE BEAM[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(10): 76-78. doi: 10.13204/j.gyjz200510023

Citation:

PDF( 0 KB)

STUDY ON FORCED PERFORMANCE TEST OF EDGE JOINTS FOR REINFORCED CONCRETE FLAT BEAMS WITH EDGE BEAM

doi: 10.13204/j.gyjz200510023

Guo Jinshi¹,
Yin Xinsheng²

1.
1. Civil Engineering Department,Institute of Jilin Architecture and Engineering Changchun 130021;
2.
2. Institute of Architecture and Civil Engineering,Shenzhen University Shenzhen 518067

Received Date: 2005-05-16
Publish Date: 2005-10-20

Abstract

Abstract

Failure mechanism, bearing capacity, deformation and rupture forms etc of edge joints for which there are three different width height ratios are contrasted and analyzed through loading test with and without reinforced concrete flast beams. Validity of the existing design methods for edge joints is demonstrated for reinforced concrete flat beams. A breakthrough is made at the requirements for section width limit of flat beams in Code for Seismic Design of Buildings (GB 50011-2001)and a scientific basis is provided for design methods and engineering application of edge joints for reinforced concrete flat beams.
- reinforced concrete flat beams edge,
- joints,
- forced performance,
- failure mechanism

FullText(HTML)

References(7)

References

GB 50010-2002 混凝土结构设计规范;

[2] GB 50011-2001 建筑抗震设计规范;

[3] 傅温.高效预应力混凝土工程技术.北京:中国民航出版社,1996.64～82;

[4] 罗福午,张惠英,杨军.建筑结构概念设计及案例.北京:清华大学出版社,2003.160～184;

[5] 尼尔逊 A H,温特尔G.混凝土结构设计.过镇海,等译.北京:中国建筑工业出版社,1993.327～368;

[6] 江见鲸.混凝土结构工程学.北京:中国建筑工业出版社,1998.281～338;

[7] 王振东.混凝土及砌体结构(上册).北京:中国建筑工业出版社,2002.222～275

Relative Articles

[1]	YANG Hangdong. Experimental Research on Seismic Performance of Prefabricated CFST Composite Column-Reinforced Concrete Beam Joints[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(9): 133-140. doi: 10.3724/j.gyjzG23082308
[2]	ZHANG Xiaowei, RONG Xian, YANG Hongwei, ZHANG Jianxin. Research on Mechanical Properties of Prefabricated High-Strength Steel Reinforced Concrete Beam-Column Joints with Steel Ends[J]. INDUSTRIAL CONSTRUCTION, 2023, 53(11): 110-116. doi: 10.13204/j.gyjzG22051211
[3]	WANG Weiyong, YANG Qibo, LIANG Zhanshuo, OU Ying, JIANG Xianchun. Seismic Response of the Joint Between Steel Truss Concrete Composite Shear Wall and Steel Coupling Beam[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(11): 39-48. doi: 10.13204/j.gyjzG22040401
[4]	ZHANG Min, HUANG Wei, MIAO Xinwei. SEISMIC BEHAVIOR TEST OF FIBER-REINFORCED RECYCLED CONCRETE PREFABRICATED COMPOSITE WALLS[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(12): 42-49. doi: 10.13204/j.gyjz201907080013
[5]	BAI Zhengxian, BAI Yaritu, LIU Xuechun. MECHANICAL PROPERTIES ANALYSIS OF Z-SHAPED SPLICING JOINT OF CONCRETE- FILLED L-SHAPED STEEL TUBULAR COLUMN AND H-SECTION BEAM[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(11): 153-161,194. doi: 10.13204/j.gyjzG20020603
[6]	Zhang Yanxia, Zhao Wei, Li Yunpeng, Min Zongjun. RESEARCH ON MECHANICAL BEHAVIOR OF THE CIRCULAR HOLE CELLULAR BEAMS AND STEEL-CONCRETE COMPOSITE CELLULAR BEAM[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(2): 136-142. doi: 10.13204/j.gyjz201502028
[7]	Wang Chaoqun, Bai Guoliang, Wang Bo, Zhu Jianing, Li Hongxing. STUDY OF FAILURE MECHANISM AND MECHANICAL BEHAVIOR OF ABNORMAL JOINTS BETWEEN STEEL REINFORCED CONCRETE COLUMN AND REINFORCED CONCRETE BEAM UNDER LOW-CYCLE REVERSED LOADING[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(09): 156-161.
[8]	Rong Xian, Li Pengfei. STUDY ON SEISMIC PERFORMANCE OF THE JOINT OF PRESTRESSED CONCRETE PIPE PILES[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(8): 94-97. doi: 10.13204/j.gyjz201308020
[9]	Zhao Yana, Yu Zhixiang, Zhao Shichun. STUDY ON MECHANICAL PROPERTIES OF LARGE STEEL UNDERPINNING TRUSS-STCC JOINT[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(10): 90-94. doi: 10.13204/j.gyjz201110022
[10]	Wang Hailiang, Yang Xinlei, Ren Quanchang, Dong Peng. EXPERIMENTAL STUDIES OF CFT COLUMN TO H-BEAM CONNECTIONS UNDER CYCLIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(7): 114-119. doi: 10.13204/j.gyjz201107025
[11]	Yao Guohuang, Chen Yiyan, Huang Yongjun, Pan Donghui, Zheng Xiaoying, Xu Wenjie. EXPERIMENTAL STUDY ON SEISMIC BEHAVIOR OF JOINT OF CFST COLUMN-RC BEAM[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(2): 97-101,69. doi: 10.13204/j.gyjz201102023
[12]	Liu Chunyang, Li Zhenbao, Ma Hua, Han Jianqiang. EXPERIMENT STUDY ON ASEISMIC BEHAVIOR OF RC FRAME SPACE JOINTS[J]. INDUSTRIAL CONSTRUCTION, 2011, 41(6): 67-70. doi: 10.13204/j.gyjz201106014
[13]	Yao Guohuang, Huang Yongjun, Zheng Xiaoying, Xu Wenjie, Pan Donghui, Sun Suwen. EXPERIMENTAL STUDY ON BEHAVIOR OF JOINT OF CFST COLUMN-RC BEAM[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(7): 100-104. doi: 10.13204/j.gyjz201007025
[14]	Wang Tiecheng, Wang Yuliang, Jiang Weishan. ANALYSIS OF MECHANICAL PROPERTY ON SRC JOINTS WITHOUT STIRRUP[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(3): 32-35. doi: 10.13204/j.gyjz200903011
[15]	Ding Beidou, Ding Li. RESEARCH ON MECHANICAL PERFORMANCE OF T-JOINT OF CIRCULAR TUBE UNDER LOW REVERSED CYCLIC LOADING[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(11): 102-105. doi: 10.13204/j.gyjz200811025
[16]	Li Bin, Ren Limin, Shi Xiaoyan. EXPERIMENTAL RESEARCH ON BEHAVIOR OF CONCRETE-FILLED RHS FRAMES[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(11): 97-101,105. doi: 10.13204/j.gyjz200811024
[17]	Wen Yuping, Wang Qingxiang. EXPERIMENT RESEARCH ON ASEISMATIC BEHAVIOR OF JOINTS OF HEAVY-LOAD STEEL TUBE COLUMNS FILLED WITH STEEL-REINFORCED CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(3): 20-22,8. doi: 10.13204/j.gyjz200803006
[18]	Lu Tie-jian, Xiao Lin-hong. STUD CONNECTOR.S INFLUENCE ON ASEISMIC PERFORMANCE OF SC BEAM-RC COLUMN JOINT[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(12): 67-70. doi: 10.13204/j.gyjz200712016
[19]	Guo Jinshi, Yin Xinsheng. STUDY ON PERFORMANCE TEST OF EDGE JOINTS FOR FLAT BEAMS OF REINFORCED CONCRETE TOP FLOOR[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(7): 33-35. doi: 10.13204/j.gyjz200707011
[20]	Dai Shaobin, Huang Jun, Zhu Jian. RESEARCH ON MECHANICAL PERFORMANCE OF T-JOINT OF STEEL FRAME[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(9): 90-93. doi: 10.13204/j.gyjz200509025