EXPERIMENTAL STUDY OF MECHANICAL BEHAVIOR STEEL-CONCRETE SANDWICH COMPOSITE SHEAR WALLS UNDER COMPOSITE LOADING

Qian Kuan; Sun Yunlun; Yang Fang; Pan Rong; Tian Chunyu

doi:10.13204/j.gyjz2001412003

Volume 44 Issue 12

Feb. 2015

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2014 > 44(12): 12-16

Li Songqi, Li Zhongcheng, Zhang Tao. DESIGN AND SEISMIC RESPONSE ANALYSIS OF SEISMIC-ISOLATION SYSTEM FOR AN EMERGENCY CONTROL CENTER BUILDING OF A NUCLEAR POWER PLANT[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(12): 41-43. doi: 10.13204/j.gyjz2001412008

Citation:

Qian Kuan, Sun Yunlun, Yang Fang, Pan Rong, Tian Chunyu. EXPERIMENTAL STUDY OF MECHANICAL BEHAVIOR STEEL-CONCRETE SANDWICH COMPOSITE SHEAR WALLS UNDER COMPOSITE LOADING[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(12): 12-16. doi: 10.13204/j.gyjz2001412003

Citation:

PDF( 0 KB)

EXPERIMENTAL STUDY OF MECHANICAL BEHAVIOR STEEL-CONCRETE SANDWICH COMPOSITE SHEAR WALLS UNDER COMPOSITE LOADING

doi: 10.13204/j.gyjz2001412003

Publish Date: 2014-12-20

Abstract

Abstract

By quasi-static testing two sets of specimens of steel-concrete sandwich composite shear wall，including tests of the bearing capacity，deformability，failure mode of the specimens，valuable results were obtained from the tests，such as the typical failure modes， the hysteretic curves，skeleton curves，bearing capacity，ductility，energy dissipation capacity． In addition，it was also analyzed the influence of variations of out-of-plane bending moment on structural mechanical behavior． In conclusion，the failure patterns of specimens under compression and biaxial bending moment were compression-bending failure; and the hysteretic curves of all specimens were not plump， validating that the deformability and energy dissipation capacity of the specimens were general． In other words，the bigger the out-of-plane bending moment，the less the lateral resistance capacity and energy dissipation capacity of the specimens． The specimens’out-of-plane displacement in the plastic region increased significantly，and they had a divergent trend． The bottom section of the specimens could basically meet the plane section assumption．
- steel-concrete sandwich,
- composite shear wall,
- quasi-static test,
- ductility

FullText(HTML)

References(0)

References

Relative Articles

[1]	JIANG Feng, LU Tao, MAO Yongping, KOU Zhao, QIN Huihui, ZHOU An. Quasi-Static Tests on Seismic Performance of Centrifugal Concrete-Filled Steel Tube Piles[J]. INDUSTRIAL CONSTRUCTION, 2025, 55(2): 233-239. doi: 10.3724/j.gyjzG22120807
[2]	LI Hui, OU Ying, GAO Wenjun, XU Hu, YANG Zeng, YU Zhixiang. Experimental Research on Seismic Performance of Precast Columns with Intermediate Connections[J]. INDUSTRIAL CONSTRUCTION, 2024, 54(4): 39-45. doi: 10.3724/j.gyjzG22102901
[3]	WANG Peng, YU Bin, SHI Qingxuan, WANG Feng. Experimental Research on Seismic Performance of New-Type Steel Reinforced Concrete Composite Columns[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(12): 113-120,127. doi: 10.13204/j.gyjzG21072801
[4]	FU Bo, LI Zijie, LIN Chenhao, ZHOU Huajun, TONG Genshu. Experimental Research on Seismic Performance of Steel Plate Shear Wall with Outer Decorative Layer Considering the Effect of Vertical Load[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(11): 49-56. doi: 10.13204/j.gyjzG22062012
[5]	PANG Rui, WANG Lu, LIU Yuhao, WANG Yixiao, DING Shusu. Experimental Research on Seismic Performance Test of Prefabricated Steel-Concrete Composite Tube Shear Walls[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(4): 84-90. doi: 10.13204/j.gyjzG20050712
[6]	WANG Weiyong, YANG Qibo, LIANG Zhanshuo, OU Ying, JIANG Xianchun. Seismic Response of the Joint Between Steel Truss Concrete Composite Shear Wall and Steel Coupling Beam[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(11): 39-48. doi: 10.13204/j.gyjzG22040401
[7]	LI Yun, LIU Yang, ZHANG Xianlong, HE Fujiangshan, FENG Ruoqiang. Research on Hysteretic Performance of Grid-Tube Double Steel Plate Shear Walls[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(11): 32-38. doi: 10.13204/j.gyjzG21081212
[8]	ZHANG Liang, WU Bian, ZHANG Fengliang, LIU Yang. Anti-Seismic Performance of Composite Shear Walls of Concrete Filled Steel Tube Reinforced with Corrugated Steel Plates[J]. INDUSTRIAL CONSTRUCTION, 2022, 52(10): 146-155,138. doi: 10.13204/j.gyjzG22071409
[9]	ZHENG Qizhen, LI Huiyan, LONG Libo, CHEN Gang. EXPERIMENTAL RESEARCH ON ASEISMIC PERFORMANCES OF PREFABRICATED SHEAR WALL CONNECTED BY UHPC[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(9): 82-89. doi: 10.13204/j.gyjzG20042601
[10]	ZHOU Tiegang, WANG Xin, ZHANG Zaiyu, MA Ben, ZHU Ruizhao, DENG Mingke. EXPERIMENTAL RESEARCH ON ASEISMIC PERFORMANCES OF ROWLOCK WALLS STRENGTHENED WITH ECC[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(9): 132-137. doi: 10.13204/j.gyjzG20061402
[11]	ZHOU Xiongliang, SHU Ganping, ZHOU Guangen, LIU Zhonghua, HE Yunfei, LUO Kerong. EXPERIMENTAL RESEARCH ON THE MECHANICAL PROPERTIES OF SHORT DOUBLE-SKIN MULTI-CAVITY COMPOSITE WALL WITH STEEL TRUSS UNDER AXIAL COMPRESSION[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(3): 1-7,12. doi: 10.13204/j.gyjz202003001
[12]	WANG Yixiao, PANG Rui, DING Shusu, XU Zhu, WANG Lu, LEI Hongbing. EXPERIMENTAL RESEARCH ON SEISMIC BEHAVIORS OF PREFABRICATED SRCT SHEAR WALLS WITH DIFFERENT DISTANCE TO THICKNESS RATIOS[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(8): 145-153,127. doi: 10.13204/j.gyjzG19102302
[13]	YU Haifeng, HAO Mengtian, MA Jiansuo, YU Ke. QUASI-STATIC TEST AND NUMERICAL ANALYSIS OF PREFABRICATED SHEAR WALL WITH VERTICAL CONNECTIONS OF EMBEDDED STEEL PLATE AND BOLT[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(5): 24-30. doi: 10.13204/j.gyjz202005005
[14]	Song Xiaolu, Qian Jiaru, Feng Baochun, Zhang Yichao. TEST STUDY ON SEISMIC BEHAVIOR OF SPＲAYED CONCＲETE SANDWICH SHEAR WALLS WITH LOW SHEAR-SPAN RATIO[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(07): 16-20.
[15]	Xu Ming, Peng Zhu, Chen Zhongfan. EXPERIMENTAL RESEARCH ON SEISMIC BEHAVIOR OF LOAD-BEARING WALL WITH COMPOUND INSULATION CONCRETE BLOCKS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(3): 61-66. doi: 10.13204/j.gyjz201303013
[16]	Heng Panha, Nie Jianguo, Yu Zhouliang. EXPERIMENTAL STUDY OF COMPOSITE BEAM ASSEMBLED BY STEEL TRUSS AND CONCRETE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(10): 122-128,133. doi: 10.13204/j.gyjz201310026
[17]	Zhang Guangtai, Yu Xiaojun. EXPERIMENTAL STUDY ON BRICK WALLS STRENGTHENED WITH SIDED LATTICED STEEL PLATE[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(3): 125-128. doi: 10.13204/j.gyjz201303026
[18]	Li Bing, Li Hongnan. RESEARCH ON QUASI-STATIC TEST OF REINFORCED CONCRETE SHEAR WALLS WITH DIFFERENT SHEAR-SPAN RATIO[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(9): 32-36. doi: 10.13204/j.gyjz201009011
[19]	Liu Bingkang, Li Jianhong, Zhang Xingyu, Sheng Hai. TEST OF MOMENT BEARING CAPACITY AND DUCTILITY PERFORMANCE OF FILLED PRESTRESSED CONCRETE PIPE PILE[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(3): 46-49,4. doi: 10.13204/j.gyjz200703013
[20]	Liao Fei-yu, Tao Zhong. EXPERIMENTS ON BEHAVIOR OF RC SHEAR WALLS FRAMED WITH DIFFERENT KINDS OF COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2007, 37(12): 31-34,118. doi: 10.13204/j.gyjz200712007