MECHANICAL PROPERTIES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE ECCENTRIC COMPRESSION COLUMN AFTER HIGH TEMPERATURE

Chen Zongping; Ye Peihuan; Xue Jianyang; Zhou Chunheng

doi:10.13204/j.gyjz2001411007

Volume 44 Issue 11

Jan. 2015

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > INDUSTRIAL CONSTRUCTION > 2014 > 44(11): 39-44

Gao Danying, Zhang Junwei. EXPERIMENTAL INVESTIGATION ON SEISMIC BEHAVIOR OF STEEL FIBER REINFORCED HIGH- STRENGTH CONCRETE FRAME EXTERIOR JOINTS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(5): 84-89,28. doi: 10.13204/j.gyjz2011205015

Citation:

Chen Zongping, Ye Peihuan, Xue Jianyang, Zhou Chunheng. MECHANICAL PROPERTIES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE ECCENTRIC COMPRESSION COLUMN AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 39-44. doi: 10.13204/j.gyjz2001411007

Citation:

PDF( 0 KB)

MECHANICAL PROPERTIES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE ECCENTRIC COMPRESSION COLUMN AFTER HIGH TEMPERATURE

doi: 10.13204/j.gyjz2001411007

Publish Date: 2014-11-15

Abstract

Abstract

Based on the static load tests of five steel reinforced recycled aggregate concrete column specimens after high temperature and one contrastive specimen at ambient temperature，the damage process and failure mode of specimens were observed，ultimate bearing capacity，the stress distribution，load-deformation curve as well as other important information were obtained． The effects of replacement ratio and temperature on the mechanical properties of the specimens were analyzed． The results indicated that high temperature had a great influence on the mechanical properties of steel reinforced recycled aggregate concrete bias columns． It was shown that higher temperature brings cracks forward． The results also indicated that increasing the temperature caused a decrease of bearing capacity and the flexural rigidity while the deformation and ductility were increased． It was shown that increase in replacement ratio of specimens，the ultimate concrete strain as well as ductility were increased but ultimate bearing capacity was decreased． Eccentricity of loading had an influence on the mechanical properties of specimens． With increasing the eccentricity of loading，residual bearing capacity and residual lateral stiffness significantly reduced．
- after high temperature,
- steel reinforced recycled aggregate concrete,
- eccentric compression column,
- failure mode,
- mechanical property

FullText(HTML)

References(0)

References

Relative Articles

[1]	ZHANG Jiahui, GE Zujing. EXPERIMENTAL RESEARCH ON MECHANICAL PROPERTIES OF COLD-FORMED STEEL STUB COLUMNS WITH OPEN SECTIONS AFTER A FIRE[J]. INDUSTRIAL CONSTRUCTION, 2021, 51(5): 99-107. doi: 10.13204/j.gyjzG20030706
[2]	CUI Yubo, WANG Jingfeng, SHEN Qihan, DING Zhaodong, SHAO Xingqiao. EXPERIMENTAL AND STUDY ON ECCENTRIC COMPRESSIVE PERFORMANCES OF REINFORCED CONCRETE COLUMNS WITH REBAR HRB635[J]. INDUSTRIAL CONSTRUCTION, 2020, 50(10): 11-19. doi: 10.13204/j.gyjzG20021905
[3]	Zhai Yue Deng Zichen Ai Xiaoqin, . INFLUENCE OF DIFFERENT COOLING MODE AND HIGH TEMPERATUＲE ON CONCRETE SPLITTING TENSILE STRENGTH[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(7): 113-117. doi: 10.13204/j.gyjz201507023
[4]	Wu Huazong, Li Junhua, Chi Yuyu, Qiu Dongliang. EXPERIMENTAL STUDY OF BOND-SLIP BEHAVIOR OF SRC MEMBERS UNDER CYCLIC REVERSED LOADING AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2015, 45(5): 138-142. doi: 10.13204/j.gyjz201505029
[5]	Cheng Bo, Wang Jianmin, Wang Nengjun, Jiang Wenting. EXPERIMENT OF MECHANICAL PERFORMANCE OF FIBER CERAMSITE CONCRETE AFTER ELEVATED TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(08): 126-130.
[6]	Chen Zongping, Chen Junrui, Xue Jianyang, Chen Yuliang. EXPERIMENTAL STUDY OF MECHANICAL BEHAVIOR OF STEEL AND RECYCLED AGGREGATE CONCRETE AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 1-4. doi: 10.13204/j.gyjz2001411001
[7]	Chen Zongping, Jing Chenggui, Xue Jianyang, Zhang Chaorong. STUDY OF MECHANICAL BEHAVIOR OF RECYCLED AGGREGATE CONCRETE FILLED CIRCULAR STEEL TUBE COLUMNS UNDER ECCENTRIC LOADING AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 19-24. doi: 10.13204/j.gyjz2001411004
[8]	Chen Zongping, Liang Ying, Xue Jianyang, Li Yi. DEFORMATION PERFORMANCE AND CALCULATION OF FLEXURAL RIGIDITY OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE BEAMS AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 58-63. doi: 10.13204/j.gyjz2001411010
[9]	Chen Zongping, Zheng Wei, Zhou Chunheng, Xue Jianyang. TEST OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE AXIAL COMPRESSION SHORT COLUMNS AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 32-38. doi: 10.13204/j.gyjz2001411006
[10]	Chen Zongping, Zhou Wenxiang, Xue Jianyang, Li Ling. TEST OF RECYCLED AGGREGATE CONCRETE FILLED SQUARE STEEL TUBE COLUMN SUBJECTED TO ECCENTRIC COMPRESSION AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2014, 44(11): 25-31. doi: 10.13204/j.gyjz2001411005
[11]	Xue Jianyang, Zhang Jie, Ma Hui, Ren Rui, Wang Cheng. NON-LINEAR NUMERICAL SIMULATION ANALYSIS OF STEEL RECYCLED AGGREGATE CONCRETE COLUMN UNDER LOW-CYCLIC REVERSED LOADING[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 40-45. doi: 10.13204/j.gyjz201309007
[12]	Xue Jianyang, Wang Yuncheng, Ma Hui, Liu Jinlu, Ao Xiang. EXPERIMENTAL STUDY ON LATERAL BEARING CAPACITY AND AXIAL COMPRESSION RATIO LIMIT VALUES OF STEEL REINFORCED RECYCLED AGGREGATE CONCRETE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 30-34,45. doi: 10.13204/j.gyjz201309005
[13]	Xue Jianyang, Lin Jianpeng, Ma Hui, Chen Zongping, Cui Weiguang. STIFFNESS AND DEFORMATION ANALYSIS OF STEEL REINFORCED RECYCLED CONCRETE ECCENTRIC COMPRESSION COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(8): 109-113. doi: 10.13204/j.gyjz201308024
[14]	Xue Jianyang, Meng Gang, Liu Zuqiang, Chen Zhuo, Chen Zongping. FINITE-ELEMENT ANALYSIS OF MECHANICAL BEHAVIORS OF NORMAL CROSS-SECTION OF STEEL RECYCLED AGGREGATE CONCRETE COMPOSITE COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2013, 43(9): 23-29. doi: 10.13204/j.gyjz201309004
[15]	Guan Hong-bo, Wang Qing-xiang. CALCULATION OF BEARING CAPACITY OF ECCENTRICALLY LOADED CONCRETE-FILLED GFRP TUBULAR LONG COLUMNS[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(10): 42-46. doi: 10.13204/j.gyjz201210011
[16]	Zhou Ming, Wang Xintang, Zheng Xiaoyao. EXPERIMENTAL RESEARCH ON POST-FIRE MECHANICAL BEHAVIOR OF H-STEEL COLUMNS WITH DIFFERENT RESTRAINT[J]. INDUSTRIAL CONSTRUCTION, 2012, 42(6): 153-157,33. doi: 10.13204/j.gyjz201206032
[17]	Wu Hao, Chen Ligang. EXPERIMENTAL INVESTIGATION ON BOND PERFORMANCE BETWEEN REINFORCEMENT AND CONCRETE AFTER FIRE[J]. INDUSTRIAL CONSTRUCTION, 2010, 40(2): 105-108. doi: 10.13204/j.gyjz201002024
[18]	Zhang Wei, Geng Shujiang, Zhu Jianguo, Jiang Tao, Wang Mingping. EXPERIMENTAL RESEARCH ON CRACK WIDTH ON REINFORCED CONCRETE BIAS COLUMN WITH HRBF500[J]. INDUSTRIAL CONSTRUCTION, 2009, 39(11): 22-25. doi: 10.13204/j.gyjz200911006
[19]	Yu Hongjie, Zhang Yange. THE ANALYSIS OF THE CHARACTERISTICS OF HRB500 REINFORCED ECCENTRIC LOADING COLUMNS BY THE CALCULATION RESULTS[J]. INDUSTRIAL CONSTRUCTION, 2008, 38(9): 64-66. doi: 10.13204/j.gyjz200809019
[20]	Wang Ping, Xiao Jianzhuan, Chen Ruisheng, Zheng Xuebin. EXPERIMENTAL STUDY ON EFFECT OF POLYPROPYLENE FIBER ON MECHANICAL PROPERTY OF HIGH PERFORMANCE CONCRETE AFTER HIGH TEMPERATURE[J]. INDUSTRIAL CONSTRUCTION, 2005, 35(11): 67-69,77. doi: 10.13204/j.gyjz200511020