超高性能混凝土华夫桥面板错缝型负弯矩区抗弯性能试验研究

王忠强; 李晓龙; 陈晖; 王泽辉; 袁泉; 王巍

doi:10.3724/j.gyjzG22120407

超高性能混凝土华夫桥面板错缝型负弯矩区抗弯性能试验研究

doi: 10.3724/j.gyjzG22120407

王忠强¹,
李晓龙¹,
陈晖¹,
王泽辉^2,3,
袁泉^2,3,
王巍⁴

1. 北京市市政工程设计研究总院有限公司, 北京 100082;
2. 北京交通大学土木建筑工程学院, 北京 100044;
3. 结构风工程与城市风环境北京市重点实验室, 北京 100044;
4. 深圳中冶南方城建工程技术有限公司, 广东深圳 518028

详细信息

作者简介:
王忠强,工程师,主要从事高性能桥梁结构研究工作。电子信箱:604001164@qq.com

计量
- 文章访问数: 20
- HTML全文浏览量: 5
- PDF下载量: 1
- 被引次数: 0
出版历程
- 收稿日期: 2022-12-04
- 网络出版日期: 2025-04-02

Experimental Research on Flexural Behavior of the Staggered Joint Type Negative Moment Zone of UHPC Waffle Bridge Decks

1. Beijing General Municipal Engineering Design & Research Institute Co., Ltd., Beijing 100082, China;
2. School of Civil Engineering, Beijing Jiaotong University, Beijing 100044, China;
3. Beijing's Key Laboratory of Structural Wind Engineering and Urban Wind Environment, Beijing 100044, China;
4. Shenzhen MCC Southern Urban Construction Engineering Technology Co., Ltd., Shenzhen 518028, China

摘要

摘要: 为改善钢-超高性能混凝土(UHPC)华夫桥面板负弯矩区力学性能,以实际工程文昌桥为背景,提出了一种错缝型连接节点,并设计制作了4组钢-UHPC华夫桥面板节点试件进行抗弯试验,对比分析钢纤维类型、接缝类型等不同因素对试件破坏模式、承载力、钢筋应变、裂缝延展等性能的影响,并对钢-UHPC华夫桥面板在正常使用极限状态和承载能力极限状态下的力学性能进行评价分析。研究结果表明:各试件表现为典型的延性受弯破坏,裂缝集中于加载点下方和节点区域;错缝型节点和端勾型纤维均能有效提高试件的承载性能和变形能力;各试件裂缝发展曲线存在持缝和持力两个阶段,当裂缝宽度为3 mm时,对缝型试件DD较DZ承担荷载提升14.8%,而错缝型试件CD较CZ提升幅度仅为5.3%;在正常使用极限状态和承载能力极限状态下,UHPC华夫桥面板均具有优异的承载性能,并且满足“强节点、弱构件”设计要求。
- 钢-UHPC华夫桥面板 /
- 负弯矩区 /
- 接缝类型 /
- 抗弯试验 /
- 力学性能评价
Abstract: In order to improve the mechanical properties of the negative bending moment zone of steel UHPC waffle bridge decks, a staggered joint was proposed against the background of Wenchang Bridge, and four groups of steel UHPC waffle bridge deck joint specimens were designed and manufactured for bending tests. The effects of different factors, such as steel fiber type and joint type, on the failure mode, bearing capacity, reinforcement strain, crack extension and other properties of the specimens were compared and analyzed. The mechanical properties of the steel UHPC wiffle bridge deck undered the normal service limit state and bearing capacity limit state were evaluated and analyzed. The results showed that the specimens showed typical ductile bending failure, and the cracks were concentrated below the loading point and in the joint area; both staggered joints and end hook fibers could effectively improve the bearing capacity and deformation capacity of specimens; there were two stages in the crack development curve of each specimen: crack holding and force holding. When the crack width was 3 mm, the load borne by butted joint specimen DD was 14.8% higher than that of DZ, while the staggered joint specimen CD was only 5.3% higher than that of CZ; in the serviceability limit state and bearing capacity limit state, UHPC waffle bridge deck had excellent bearing performance, and met the design requirements of "strong joints, weak members".
- steel-UHPC waffle bridge deck /
- negative bending moment zone /
- joint type /
- bending test /
- evaluation of mechanical properties

HTML全文

参考文献(29)

[1]	陈宝春, 牟廷敏, 陈宜言, 等. 我国钢-混凝土组合结构桥梁研究进展及工程应用[J]. 建筑结构学报, 2013, 34(增刊1): 1-10.
[2]	宋爱明. 钢-混凝土组合梁负弯矩区静力与疲劳性能研究[D]. 南京: 东南大学, 2020.
[3]	JUN S C, LEE C H, HAN K H, et al. Flexural behavior of high-strength steel hybrid composite beams[J]. Journal of Constructional Steel Research, 2018, 149: 269-281.
[4]	邵旭东, 胡建华. 钢-超高性能混凝土轻型组合桥梁结构[M]. 北京: 人民交通出版社, 2015: 10-14, 80-95.
[5]	蔡书坤. 钢-UHPC组合梁负弯矩区受力性能试验研究与理论分析[D]. 长沙: 湖南大学, 2020.
[6]	薛伟辰, 杨涛, 白丽丽. 负弯矩作用下预应力钢-混凝土组合梁的受力性能[J]. 武汉理工大学学报, 2012, 34(8): 123-127.
[7]	郭瑞, 苏庆田. 后结合预应力组合梁负弯矩区混凝土开裂性能试验[J]. 同济大学学报(自然科学版), 2015, 43(3): 352-356.
[8]	RYU H K, SHIM C S, CHANG S P, et al. Inelastic behaviour of externally prestressed continuous composite box-girder bridge with prefabricated slabs[J]. Journal of Constructional Steel Research, 2004, 60(7): 989-1005.
[9]	CHEN S, WANG X, JIA Y. A comparative study of continuous steel-concrete composite beams prestressed with external tendons: Experimental investigation[J]. Journal of Constructional Steel Research, 2009, 65(7): 1480-1489.
[10]	SU Q, YANG G, BRADFORD M A. Behavior of a continuous composite box girder with a prefabricated prestressed-concrete slab in its hogging-moment region[J]. Journal of Bridge Engineering, 2015, 20, B4014004.
[11]	刘劲, 丁发兴, 蒋丽忠, 等. 负弯矩荷载下钢-混凝土组合梁抗弯刚度研究[J]. 铁道科学与工程学报, 2019(9): 2281-2289.
[12]	贺俊钢. 混凝土组合梁连接件刚度理论及负弯矩区性能改进研究[D]. 重庆: 重庆交通大学, 2016.
[13]	FAN J S, NIE J G, LI Q W. Long-term behavior of composite beams under positive and negative bending I: experimental study[J]. Journal of Structural Engineering, 2010, 136(7): 849-857.
[14]	聂建国, 马原. 抗拔不抗剪栓钉连接件抗拔性能试验研究[J]. 特种结构, 2015, 32(3): 6-12.
[15]	樊健生, 施正捷, 芶双科, 等. 钢-ECC组合梁负弯矩区受弯性能试验研究[J]. 土木工程学报, 2017, 50(4): 64-72.
[16]	HAMODA A, HOSSAIN K M A, SENNAH K, et al. Behaviour of composite high performance concrete slab on steel I-beams subjected to static hogging moment[J]. Engineering Structures, 2017, 140: 51-65.
[17]	WANG K, ZHAO C, WU B, et al. Fully-scale test and analysis of fully dry-connected prefabricated steel-UHPC composite beam under hogging moments[J]. Engineering Structures, 2019, 197: 2-11.
[18]	廖子南, 邵旭东, 乔秋衡, 等. 钢-超高性能混凝土组合板横向受弯静力试验及有限元模拟[J]. 浙江大学学报(工学版), 2018, 52(10): 1954-1963.
[19]	项贻强, 竺盛, 赵阳. 快速施工桥梁的研究进展[J]. 中国公路学报, 2018, 31(12): 1-27.
[20]	李怀峰, 刘鑫, 贺攀, 等. 钢-UHTCC组合桥面板弯曲承载性能研究[J]. 施工技术(中英文), 2022, 51(1): 126-129.
[21]	LUO J, SHAO X D, FAN W, et al. Flexural cracking behavior and crack width predictions of composite (steel+UHPC) lightweight deck system[J]. Engineering Structures, 2019, 194: 120-137.
[22]	李文光, 邵旭东, 方恒, 等. 钢-UHPC组合板受弯性能的试验研究[J]. 土木工程学报, 2015, 48(11): 93-102.
[23]	邓舒文, 邵旭东, 晏班夫, 等. 全预制快速架设钢-UHPC轻型组合城市桥梁[J]. 中国公路学报, 2017, 30(3): 159-166.
[24]	朱劲松, 王修策, 丁婧楠. 钢-UHPC华夫板组合梁负弯矩区抗弯性能试验[J]. 中国公路学报, 2021, 34(8): 234-245.
[25]	周聪. 钢-UHPC组合梁负弯矩区受力性能试验研究[D]. 长沙: 湖南大学, 2019.
[26]	中国建筑材料联合会和中国混凝土与水泥制品协会. 超高性能混凝土基本性能与试验方法: T-CBMF37—2018[S]. 北京: 中国建材工业出版社, 2019.
[27]	GRAYBEAL B A. Characterization of the behavior of ultra-high performance concrete[D]. City of College Park: University of Maryland, 2005.
[28]	王巍. UHPC华夫桥面板及节点力学性能试验研究[D]. 北京: 北京交通大学, 2022.
[29]	中华人民共和国交通运输部. 公路桥涵设计通用规范:JTG D60—2015[S]. 北京: 人民交通出版社,2015.