箱板装配式钢结构火灾下的热力耦合响应分析

薛辰; 秦广冲; 兰涛; 余志祥; 李泽旭

doi:10.13204/j.gyjzG22041413

箱板装配式钢结构火灾下的热力耦合响应分析

doi: 10.13204/j.gyjzG22041413

薛辰¹,
秦广冲¹,
兰涛^1,2, ,,
余志祥²,
李泽旭²

1. 中国船舶重工集团国际工程有限公司, 北京 100121;
2. 西南交通大学土木工程学院, 成都 610031

基金项目:

国家钢结构工程技术研究中心研发项目(YZB2019ky02)

中国船舶重工集团科技创新与研发项目(201815K)。

国家重点研发计划项目(2019YFE0112900)

详细信息

作者简介:
薛辰,女,1996年出生,硕士。

通讯作者:
兰涛,男,1976年出生,博士,研究员,qd_lantao@163.com

计量
- 文章访问数: 96
- HTML全文浏览量: 18
- PDF下载量: 2
- 被引次数: 0
出版历程
- 收稿日期: 2022-04-14
- 网络出版日期: 2023-05-25
- 刊出日期: 2023-01-20

Thermo-Mechanical Coupling Response Analysis of Prefabricated Box-Plate Steel Structures Under Fire

1. CSIC International Engineering Co., Ltd., Beijing 100121, China;
2. School of Civil Engineering, Southwest Jiaotong University, Chengdu 610031, China

摘要

摘要: 通过建立箱板装配式钢结构的热力耦合分析模型,计算得到了整体结构在火灾下的热力学响应,并对关键构件和关键测点进行力学响应分析,结合箱板式钢结构的结构特点,探明了箱板装配式整体结构在火灾下的破坏模式,并得到了7种火灾场景下的耐火极限。研究表明:对于一层结构,火源位置是影响其耐火极限的主要原因,火源位于中心时,板的中面屈服后产生薄膜应力可提供屈曲后强度,有效提升了耐火时间,火源位于墙板附近时,结构因受力不均,应力重分布后墙板承受过大的应力,导致耐火时间大大降低;对于三层结构,火源位于结构中间楼层时耐火时间会缩短,火源位于中心位置时也会更早达到耐火极限。各工况下耐火时间达到了1 000 s以上,各方向最大位移处无明显突变,表明箱板装配式钢结构具有刚度大、耐火性能和整体性能优良的特点。
- 装配式钢结构 /
- 箱型结构 /
- 热力耦合分析 /
- 抗火性能 /
- 耐火极限
Abstract: By calculating the thermo-mechanical coupling analysis model of prefabricated box-plate steel structures, the thermodynamic response was obtained, and the mechanical response analysis of key members and key measuring points was carried out. Combined with the structural characteristics of the prefabricated box-plate steel structure, the failure mode of the structure under fire was proved, and the fire resistance limit of seven fire scenarios was obtained. The results showed that, in single-story structure, the location of fire sources had a great impact on the fire resistance endurance, and when the fire source was in the center, the film stress produced after the middle surface yield of the plate could provide the post buckling strength, which effectively improved the fire resistance time. When the fire source was near the wall, the structure was under uneven and redistributed stress, and the wall bore too much stress, which caused a great reduction of fire resistance time. For a three-story structure, the fire resistance time would be shortened when the fire source was at the bottom, which would achieve earlier when the fire source located in the center position. The fire resistance time of each working condition had reached more than 1 000 s, and there was no obvious mutation at the maximum displacement in each direction. The prefabricated box-plate steel structure showed great stiffness, excellent fire resistance and superior overall performances.
- prefabricated steel structure /
- box-type structure /
- thermo-mechanical coupling analysis /
- fire resistance /
- fire endurance

HTML全文

参考文献(25)

[1]	门进杰,贺青青,兰涛.箱板式钢结构住宅模型振动台试验设计[J].工业建筑,2018,48(9):9-14 ,82.
[2]	兰涛,郭昌灵,门进杰,等.箱板装配式钢结构住宅振动台模型试验研究[J].工业建筑,2018,48(9):1-8.
[3]	兰涛,宋昭,门进杰,等.角部加强的箱板式钢结构模块单元抗震性能试验研究[J].工业建筑,2018,48(9):15-21.
[4]	MAO H, QIN G C, LAN T. Study on the seismic performance of box-plate steel structure modular unit[J/OL]. Advances in Materials Science and Engineering, 2019:1-16[2019-05-02] .https://doi.org/10.1155/2019/4561631.
[5]	MEN J J, FAN G L, LAN T. Study on the seismic performance of box-plate steel structure with openings modular unit[J]. Materials, 2019, 12(24):4142-4159.
[6]	贺青青.箱板装配式钢结构组合承重墙抗火性能研究[D].西安:西安建筑科技大学, 2019.
[7]	薛辰,李然,兰涛.火灾下箱板装配式钢结构温度分布规律研究[J].工业建筑, 2023,53(1):9-19.
[8]	李国强.钢梁抗火计算和设计的实用方法[J].工业建筑, 1994(7):43-46.
[9]	郭士雄.约束钢梁在升温段和降温段的反应及梁柱节点的破坏研究[D].上海:同济大学, 2006.
[10]	李国强,杨明,王兆玺.钢柱抗火计算和设计的实用方法[J].工业建筑, 1995,25(2):31-37 ,61.
[11]	李国强,王培军,王永昌.约束钢柱抗火性能试验研究[J].建筑结构学报, 2009, 30(5):184-190.
[12]	KRUPPA J. Resistance en feu des assemblages par boulons haute resistance[R]. Remy Chevreuse:Centre Technique Industrial de la Construction Metallique St,1976.
[13]	British Steel Corporation (Sweden Labs). The performance of beam/column/beam connections in the BS476:art 8 fire test:Reports T/RS/1380/33/82D and T/RS/1380/34[R].London:British Steel Corporation, 1982.
[14]	BAILEY C G, LENNON T, MOORE D B. The behaviour of full-scale steel framed building subjected to compartment fires[J].The Structural Engineer,1999,77(8):15-21.
[15]	Building Research Establishment (BRE).The integrity of compartmentation in buildings during a fire[R].Harlow:BRE,2005.
[16]	WANG Y C, KODUR V K R. Research toward use of unprotected steel structures[J]. Journal of Structural Engineering, 2000,126(12):1442-1450.
[17]	WANG Y C. An analysis of the global structural behaviour of the Cardington steel-framed building during the two BRE fire tests[J]. Engineering Structures, 2000, 22(5):401-412.
[18]	中华人民共和国住房和城乡建设部.建筑钢结构防火技术规范:GB 51249-2017[S].北京:中国计划出版社,2017.
[19]	上海市住房和城乡建设管理委员会.建筑钢结构防火技术规程:DG/TJ08-008-2017[S].上海:同济大学出版社,2017.
[20]	European Convention for Constructional Steelwork Technical Committee (ECCSTC).European recommendations for the fire safety of steel structures[S].Brussels:ECCSTC,1983.
[21]	British Standard Institution (BSI).Structure use of steel work in building, part 8:code of practice for fire resistant design:BS 5950-1:1990[S]. London:BSI,1990:3-4.
[22]	European Committee for Standardization (CEN).Eurocode 3:Design of steel structures,part1.2:general rule/structural fire design:ENV 1993-1-2:2000[S]. Brussels:CEN, 2001:19-20.
[23]	薛辰.箱板装配式钢结构火灾下的热力耦合响应分析[D].成都:西南交通大学, 2021.
[24]	李国强,韩林海,楼国彪.钢结构及钢-混凝土组合结构抗火设计[M].北京:中国建筑工业出版社, 2006.
[25]	中华人民共和国住房和城乡建设部.钢结构设计标准:GB 50017-2017[S].北京:中国建筑工业出版社,2018.