端板连接蜂窝梁-柱节点抗震性能试验研究

贾连光; 毕然; 李秋镕

doi:10.13204/j.gyjzG21083002

端板连接蜂窝梁-柱节点抗震性能试验研究

doi: 10.13204/j.gyjzG21083002

沈阳建筑大学土木工程学院, 沈阳 110168

基金项目:

国家自然科学基金项目（51578346）。

详细信息

作者简介:
贾连光,男,1961年出生,硕士,教授。电子信箱:syjlg@163.com

计量
- 文章访问数: 108
- HTML全文浏览量: 18
- PDF下载量: 1
- 被引次数: 0
出版历程
- 收稿日期: 2021-08-30
- 网络出版日期: 2023-03-22

Experimental Research on Seismic Performance of End-Plate Connections Between Castellated Beams and Columns

School of Civil Engineering, Shenyang Jianzhu University, Shenyang 110168, China

摘要

摘要: 为研究开孔形状、开孔率和混凝土楼板对蜂窝梁柱端板连接节点抗震性能的影响，设计4个足尺边节点并进行拟静力加载试验，研究试件破坏模式、承载能力、延性和耗能性能等。结果表明：对有楼板的试件，孔型对节点破坏形态和抗震性能影响较大，六边形孔更易发生梁铰破坏且耗能性能更好；开孔率对节点的破坏形态、承载能力和延性影响较大，适当提高开孔率有利于应力由端板连接处向首孔迁移，降低端板与柱翼缘的应变极限值；楼板的组合效应使节点的抗弯承载力提高25%以上，耗能和延性分别提高16.5%和30.7%，极限转角提高40.9%，但会减弱应力由端板连接处向首孔的迁移效应。对于梁铰破坏形式的组合节点，采用ASCE中对腹板开洞组合梁的承载力计算方法所得结果与试验值吻合较好。
- 蜂窝梁 /
- 端板连接 /
- 应力迁移 /
- 塑性铰 /
- 拟静力试验 /
- 抗震性能
Abstract: In order to study the effects of opening shape, opening ratio and concrete floor on the seismic performance of the end-plate joint of castellated beam-to-column, four full-scale side joints were designed and tested under quasi-static loading. The failure mode, bearing capacity, ductility and energy dissipation of the specimens were studied. The results showed that for the specimens with floor plates, the opening shape had a great influence on the failure mode and seismic performance of joints, the hexagonal opening was more prone to beam hinge failure and showed a better energy dissipation. The opening ratio had a great influence on the failure mode, bearing capacity and ductility of the joints, appropriately increasing the opening ratio was conducive to the stress migrated from the end plate connection to the first opening, and the strain limit value between the end plate and the column flange was reduced. The combined effect of the floor increased the flexural capacity of the joints by more than 25%, the energy consumption and ductility by 16.5% and 30.7%, and the ultimate angle by 40.9%, respectively, but weakened the stress migration effect from the end plate joint to the first opening.
- castellated beams /
- end plate connections /
- stress migration /
- plastic hinge /
- quasi-static test /
- seismic performance

HTML全文

参考文献(16)

[1]	IMAN F, MAMOOD M T, MOHD H O, et al. Cyclic behaviour of fully-rigid and semi-rigid steel beam-to-column connections[J]. International Journal of Steel Structures, 2020, 20(2):1-21.
[2]	梁刚, 郭宏超, 刘云贺, 等. 考虑力组合效应的钢框架端板连接力学行为[J]. 地震工程与工程振动, 2019, 39(1):96-105.
[3]	张才, 王晨, 李东, 等. 梁翼缘二次削弱型端板连接节点滞回性能研究[J]. 钢结构, 2019, 34(5):24-30.
[4]	索雅琪, 范圣刚, 刘飞, 等. 新型单面螺栓梁柱外伸端板连接节点受力性能试验研究[J]. 东南大学学报(自然科学版), 2020, 50(3):417-424.
[5]	TSAVDARIDIS K D, PAPADOPOULOS T. A FE parametric study of RWS beam-to-column bolted connections with cellular beams[J]. Journal of Constructional Steel Research, 2016, 116:92-113.
[6]	TSAVDARIDIS K D, FAGHIH F, NIKITAS N. Assessment of perforated steel beam-to-column connections subjected to cyclic loading[J]. Journal of Earthquake Engineering, 2014, 18(8):1302-1325.
[7]	ERFANI S, NASERI A B, AKRAMI V. The beneficial effects of beam web opening in seismic behavior of steel moment frames[J]. Steel and Composite Structures, 2012, 13(1):35-46.
[8]	ERFANI S, AKRAMI V. Increasing seismic energy dissipation of steel moment frames using reduced web section (RWS) connection[J]. Journal of Earthquake Engineering, 2017, 21(7):1090-1112.
[9]	CHEN S J, CHAO Y C. Effect of composite action on seismic performance of steel moment connections with reduced beam sections[J]. Journal of Constructional Steel Research, 2001, 57(4):417-434.
[10]	贾连光, 赵轶彤, 李显超, 等. 蜂窝组合梁钢框架抗震性能分析[J]. 工业建筑, 2018, 48(5):144-150.
[11]	徐莹璐, 卢林枫, 马蓬渤. 弱轴连接组合节点的滞回性能分析[J].东南大学学报(自然科学版), 2019, 49(1):16-24.
[12]	张艳霞, 李瑞, 赵微, 等. 钢框架梁柱栓焊扩翼-翼缘削弱节点优势分析性能试验[J]. 世界地震工程, 2016, 32(2):127-138.
[13]	郭兵. 钢框架梁柱端板连接在循环荷载作用下的破坏机理及抗震设计对策[D]. 西安:西安建筑科技大学, 2002:99-104.
[14]	中国国家标准化管理委员会. 金属材料拉伸试验第1部分:室温试验方法:GB/T 228. 1-2010[S]. 北京:中国国家标准化管理委员会, 2010.
[15]	中华人民共和国住房和城乡建设部. 建筑抗震试验规程:JGJ/T 101-2015[S]. 北京:中国建筑工业出版社, 2015.
[16]	ASCE.Commentary on proposed specification for structural steel beams with web openings[J]. Journal of Structural Engineering, 1992, 118(12):3325-3349.