斜向U型箍控制复材加固混凝土梁板端破坏的试验研究

冯百川; 刘锋; 付兵; 黄东超

doi:10.13204/j.gyjzG201903190009

斜向U型箍控制复材加固混凝土梁板端破坏的试验研究

doi: 10.13204/j.gyjzG201903190009

1. 广东工业大学土木与交通工程学院, 广州 510006;
2. 暨南大学重大工程灾害与控制教育部重点实验室, 广州 510632

基金项目:

国家自然科学基金项目（51608130，51978176）。

详细信息

作者简介:
冯百川,男,1995年出生,硕士研究生。电子信箱:542193570@qq.com

计量
- 文章访问数: 68
- HTML全文浏览量: 3
- PDF下载量: 1
- 被引次数: 0
出版历程
- 收稿日期: 2020-10-20
- 网络出版日期: 2021-08-19

EXPERIMENTAL RESEARCH ON SUPPRESSION OF DEBONDING IN FRRMC-PLATED RC BEAM AND SLAB ENDS BY USING OBLIQUE U-JACKET

1.;
2. MOE Key Lab of Disaster Forecast and Control in Engineering, Jinan University, Guangzhou 510632, China

摘要

摘要: 将树脂基纤维增强复合材料外贴或者表层嵌贴于钢筋混凝土梁受拉部位提升其抗弯承载能力，是钢筋混凝土结构受弯加固的主流技术之一。复材加固钢筋混凝土梁通常破坏于中部剥离或者混凝土保护层剥离，破坏发生时加固复材的最大应变通常仅为20%~40%的极限抗拉应变，导致复材抗拉强度高的特点没有得到很好的发挥。合理的锚固措施能够有效控制或延缓剥离破坏，从而很好地提升加固效率和复材利用率。国内外学者提出了不同形式的锚固措施，其效果、耐久性能、施工复杂程度存在差异，为此，提出采用斜向复材U型箍，控制或延缓板端剥离破坏（也称为混凝土保护层破坏）。通过4根足尺寸的复材加固钢筋混凝土梁的四点受弯试验，验证端部斜向复材U型箍对复材加固钢筋混凝土梁保护层剥离破坏的控制效果。试验结果表明：配置端部斜向U型箍能够对外贴和表层嵌贴复材加固钢筋混凝土梁的极限承载能力和延性分别提升62.03%和117.85%，61.08%和155.44%。
- 钢筋混凝土梁 /
- 受弯加固 /
- 混凝土保护层剥离 /
- 锚固措施 /
- 树脂基纤维增强复合材料
Abstract: Fiber-reinforced polymer (FRP) composites are widely externally bonded on or near surface mounted into the tension side of reinforced concrete (RC) beams to enhance the flexural capacity. Such a technique becomes one of the mainstream techniques for the flexural strengthening of RC beams. FRP plated RC beams usually fail due to debonding failure in either intermediate crack induced debonding (IC debonding) or concrete cover debonding. The debonding failure usually occurs with the maximum strain of the FRP being only 20%~40% of its rupture strain, thus limiting the utilization of the high tensile strength of the materials. Appropriate anchorages can effectively suppress or delay the occurrence of the debonding failure, thus improving the strengthening efficiency and the utilization of the materials. The scholars at home and abroad have proposed different forms of anchoring measures, and their effects, durability, and construction complexity are different. The oblique U-jacket was proposed to suppress or mitigate the concrete cover debonding of RC beams. Four full-scale RC beams strengthened by FRP with or without end oblique U-jacket to identify the effect of the U-jacket on the suppression or mitigation of concrete cover debonding. The test results showed that the ultimate bearing capacity and ductility of the tested beams with externally bonded and near surface mounted reinforced concrete beams could be increased by 62.03% and 117.85%, 61.08% and 155.44%, respectively.
- reinforced concrete beams /
- flexural strengthening /
- concrete cover debonding /
- anchoraging /
- fiber-reinforced polymer composites

HTML全文

参考文献(11)

[1]	李荣,滕锦光,岳清瑞.FRP材料加固混凝土结构应用的新领域:嵌入式(NSM)加固法[J].工业建筑,2004,34(4):5-10.
[2]	陆洲导,皮锐,周激.FRP材料嵌入式加固技术[C]//第九届全国建筑物鉴定与加固改造学术会议论文集.2008:454-458.
[3]	TENG J G, SMITH S T, YAO J, et al.Intermediate Crack Induced Debonding in RC Beams and Slabs[J]. Constr Build Mater, 2003,17(6/7):447-462.
[4]	SMITH S T, TENG J G. Shear-Bending Interaction in Debonding Failures of FRP-Plated RC Beams[J]. Advances in Structural Engineering, 2003, 6(3):183-199.
[5]	PORNPONGSAROJ P, PIMANMAS A. Peeling Behaviour of Reinforced Concrete Beams Strengthened with CFRP Plates Under Various End Restraint Conditions[J]. Magazine of Concrete Research, 2004, 56(2):73-81.
[6]	FU B, TENG J G, CHEN J F, et al. Concrete Cover Separation in FRP-Plated RC Beams:Mitigation Using FRP U-Jackets[J]. Journal of Composites for Construction, 2016.DOI: 10.10611/(ASCE)CC.1943-5614.0000721.
[7]	周朝阳,刘君,许芃, 等. U型CFRP条带混锚加固混凝土梁抗剪试验[J].复合材料学报, 2018, 35(3):714-721.
[8]	AL-AMERY R, AL-MAHAIDI R. Coupled Flexural-Shear Retrofitting of RC Beams Using CFRP Straps[J]. Composite Structures, 2006, 75(1/2/3/4):457-464.
[9]	LEE J, LOPEZ M M. Characterization of FRP Uwrap Anchors for Externally Bonded FRP-Reinforced Concrete Elements:An Experimental Study[J]. Journal of Composites for Construction, 2016, 20(4).DOI: 10.1061/(ASCE)CC1943-5614.0000642.
[10]	BREñA S F, BRAMBLETT R M, WOOD S L, et al. Increasing Flexural Capacity of Reinforced Concrete Beams Using Carbon Fiber-Reinforced Polymer Composites[J]. ACI Structural Journal, 2003, 100(1):36-46.
[11]	COELHO M R, SENA-CRUZ J M,NEVES LA.A Review on the Bond Behavior of FRP NSM Systems in Concrete[J/OL]. Construction and Building Materials, 2015,93:1157-1169.https://doi.org/10.1016/j.conbuildmat.2015.05.010.