地震作用下大尺寸热水储能罐的热力耦合分析

王长山; 张志谦; 王勇奉; 李雄彦; 张静; 耿岩

doi:10.13204/j.gyjzG20121408

地震作用下大尺寸热水储能罐的热力耦合分析

doi: 10.13204/j.gyjzG20121408

1. 国核电力设计研究院有限公司, 北京 100022;
2. 北京工业大学建筑工程学院, 北京 100124

基金项目:

国核电力规划研究院资助研发项目(40004013201922)。

详细信息

作者简介:
王长山,男,1983年出生,硕士,高级工程师。

通讯作者:
李雄彦,xiongy2006@126.com。

计量
- 文章访问数: 112
- HTML全文浏览量: 25
- PDF下载量: 4
- 被引次数: 0
出版历程
- 收稿日期: 2020-12-14
- 网络出版日期: 2022-09-05

Seismic Response of Large-Scale Heat Energy Storage Tank Considering Its Thermo-Mechanical Coupling Effect

1. Stated Nuclear Electric Power Planning Design & Research Institute Co., Ltd., Beijing 100022, China;
2. School of Architecture and Engineering, Beijing University of Technology, Beijing 100124, China

摘要

摘要: 为研究热水储能罐在温度场和地震作用下的热-力耦合效应,采用附加质量法建立了热水储能罐几何模型,并且利用有限元软件ABAQUS对其进行了温度与地震的耦合作用分析。考察了空罐和热水满载两种工况下的地震响应特征。结果表明:在空罐和满载两种工况下,热水罐最大位移在X-Y平面出现的角度和在罐壁的高度均有较为显著的差异;另外,考虑热力耦合与不考虑热力耦合时最大位移出现的位置会有所不同,且考虑热力耦合时罐壁应力略小于不考虑热力耦合时的应力。因此,当进行热水储能罐抗震设计时应考虑空罐和满载两种状态,并考虑热力耦合效应带来的影响。
- 附加质量法 /
- 温度场 /
- 温度与地震耦合 /
- 自振特性
Abstract: In order to study the thermal-mechanical coupling effect of hot water storage tank under the action of temperature field and earthquake, the geometric model of hot water storage tank was established by using the additional mass method, and the coupling effect between temperature and earthquake was analyzed by using finite element software ABAQUS. The seismic response characteristics of empty tank and hot water full-loaded tank were investigated. The results showed that the angle of the maximum displacement in the X-Y plane and the height of the tank wall of the hot water storage tank were significantly different between the two conditions of empty tank and full-loaded tank; in addition, the position of the maximum displacement would be different when the thermal-mechanical coupling was considered, and the stress of the tank wall when the thermal mechanical coupling was considered was slightly smaller than that when the thermal-mechanical coupling was not considered.Therefore, the influence of two states of empty tank and full-loaded tank as well as the thermal coupling effect should be considered when the seismic design of the hot water storage tank was carried out.
- additional mass method /
- temperature field /
- coupling of temperature and earthquake /
- free-vibration characteristics

HTML全文

参考文献(13)

[1]	王锦, 罗会信. 170 t铁水罐热-应力耦合分析[J]. 冶金设备, 2007(5):35-37.
[2]	但斌斌, 曹亮. 100 t铁水罐热-结构耦合分析与实测验证[J]. 武汉科技大学学报(自然科学版), 2016, 39(3 ):204-208.
[3]	杨建江, 周波, 王锐. LNG储罐有限元静动力分析方法的探讨[J]. 特种结构, 2011(6):71-75.
[4]	张兆龙, 高博青, 杨宏康. 基于附加质量法的大型固定顶储液罐基底隔震分析[J]. 振动与冲击, 2012, 31(23):32-38.
[5]	毕晓星, 彭延建, 张超. LNG储罐地震响应分析方法[J]. 油气储运, 2015, 34(11):1202-1207.
[6]	郑建华, 李金光, 李艳辉. 全容式LNG储罐的地震作用计算模型研究[J]. 化工设计, 2012, 22(2):11-14.
[7]	HOUSNER G W. Dynamic pressure on accelerated fluid container[J]. Bulletin of the Seismological Society of America, 1957, 47(1):15-35.
[8]	HOUSNER G W. The dynamic behavior of water tanks[J]. Bulletin of the Seismological Society of America, 1963, 53(2):381-387.
[9]	张春霞, 李昌铸, 卢铁瑞, 等. 现行桥梁抗震设计的反应谱分析方法[J]. 公路交通科技(应用技术版), 2008(9):9-11,24.
[10]	中华人民共和国住房和城乡建设部. 建筑抗震设计规范:GB 50011-2010[S].北京:中国建筑工业出版社,2016.
[11]	吴小峰, 孙启国, 狄杰建,等. 抗震分析反应谱法和时程分析法数值仿真比较[J]. 地震工程学报, 2011, 33(3):275-278.
[12]	苏亮, 邵寿磊. 多点地震输入的反应谱法研究[J]. 工程力学, 2014, 31(12):83-88.
[13]	杨璐, 陈虹, 岳永志, 等. 反应谱法与时程分析法抗震分析对比[J]. 沈阳工业大学学报, 2016, 38(3):331-336.